NIFAT1KImpulse Tag for entry system

The owner’s manual for the Elite Impulse Tag is currently being written.The information in the manual will include the following: “This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.” The owner’s manual will also include: “Changes or modifications not expressly approved by Elite Entry Phone Inc. could void the user’s authority to operate the equipment.”

FCC ID: NIFAT1K DATE: «TESTDATE» REPORT # 06036-1F Agent Agreement

FCC ID: NIFAT1K DATE: «TESTDATE» REPORT # 06036-1F Confidential Request

FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 9 2.7 Photograph of EUT - per 2.1033(b)(7) Transponder (418.0 MHz) Front and Back View

FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 19 4. LABELING REQUIREMENTS - PER 2.1033(B)(7) Label will be constructed of 0.02-inch plastic attached as shown on the equipment with permanent adhesive. All information on the label will be etched or screened. All methods will exceed the expected lifetime of the equipment. The label will be large enough to allow all information to be readily legible. 4.1 Additional Label Required Shown above is a copy of the label with the Part 15.19 Compliance Statement, Location of required information is checked “below”. The label will be placed in a conspicuous location on the device. The device is too small for a compliance label. Therefore the label will be placed in a prominent location in the Instruction Manual or other information supplied to the user. The device is too small for a compliance label. The label will be placed on the container in which the device will be marketed. 4.2 Photograph of Label Placement and Contents Picture of EUT was scanned and picture enhanced due to Label being imprinted on unit. PDF File. See the attachment that was electronically submitted. This device complies with Part 15 of the FCC Rules. Operation is subject to the following tow conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 1 DNB ENGINEERING, INC. CERTIFICATION FOR INTENTIONAL RADIATOR Per Part 15 Subpart C (CFR 47, 15,201, - 15.209 &15.231) EUT: Transponder (418.0 MHz) Model No. Impulse Tag 418.0 MHz PREPARED FOR APPLICANT: Elite 25741 Commercentre Dr. Lake Forest, CA 92630 949-580-1700 REPORT #06036-1 Test Date: 12/17/99 Prepared By: DNB ENGINEERING, INC. 1100 East Chalk Creek Rd. Coalville, Utah 84017 Tel: 1(435) 336-4433 FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 2 Revision Letter Number of Pages Page No. of Rev. DescriptionDate A32Document Release1/12/00 FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 3 TRANSMITTAL SUMMARY Unit tested:Transponder (418.0 MHz) Model #:Impulse Tag FCC ID: NIFAT1K Specifications: ANSI C63.4 1992 and CFR 47 FCC part 15 Subpart C Purpose of Report:This report was prepared to document the status of the Transponder (418.0 MHz) with requirements of the standards listed above. Requirements not applicable to EUT Part 15.37 - Not applicable Emergency Broadcast System - Not applicable Spread Spectrum Exhibit - Not applicable Scanning Receiver - Not applicable Test Summary The EUT’s compliance status according to the tests performed is as follows. REQUIREMENTSSTATUS FCC part 15 Subpart C per 15.201-, 15.209 & 15.231COMPLIANT The report shall not be reproduced, except in full, without the written approval of DNB ENGINEERING, INC. Results contained in this report relate only to the item tested. FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 4 CERTIFICATION OF TEST DATA - per 2.911(d) This report, containing emissions test data and evaluations, has been prepared by an independent electromagnetic compatibility laboratory, DNB ENGINEERING, in accordance with the applicable specifications and instructions required per the Introduction. The American Association has evaluated DNB Engineering to do these tests for Laboratory Accreditation, A2LA. The data evaluation and equipment configuration presented herein are a true and accurate representation of the measurements of the test emissions characteristics as of the dates and at the times of the test under the conditions herein specified. Equipment Tested:Transponder (418.0 MHz) Model #:IMPULSE TAG FCC ID#: NIFAT1K Dates of Test:12/17/99 Test Performed: ____________________________________________ Yancey StaplesDate Test Technician Test Report Reviewed: ____________________________________________ Rick LinfordDate Facility Manager Regulatory Engineer FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 5 TABLE OF CONTENTS 1.INTRODUCTION..................................................................................................................................6 1.1ADMINISTRATIVE DATA PER 2.1033(A) AND 2.911(C)...........................................................................6 1.1.1REQUEST FOR CERTIFICATION Per 2.1033(b)1:................................................................6 1.2RELATED SUBMITTALS/GRANTS...........................................................................................................6 1.3PURPOSE OF TESTS............................................................................................................................6 2.TEST DESCRIPTION...........................................................................................................................7 2.1TEST CONFIGURATION........................................................................................................................7 2.2EQUIPMENT DESCRIPTION...................................................................................................................7 2.3MODE OF OPERATION.........................................................................................................................7 2.4ANTENNA REQUIREMENT - PER 15.203................................................................................................7 2.5CIRCUIT DESCRIPTION - PER 2.1033(B)4.............................................................................................7 2.6SCHEMATICS......................................................................................................................................8 2.7PHOTOGRAPH OF EUT - PER 2.1033(B)(7)..........................................................................................9 3.EMISSIONS FCC PART 15................................................................................................................11 3.1RADIATED EMISSIONS TEST SETUP AND PROCEDURE - PER 2.1033(B)(6) PER 2.947(A).....................11 3.1.1Spurious Radiation Test Site Per 2.1033(b)6.......................................................................11 3.1.2Example Of Typical Calculation Per 2.1033(b)6...................................................................13 3.1.3Field Strength of Fundamental................................................................................................14 3.1.4Harmonics Radiated Emissions..............................................................................................15 3.1.5Spurious Emissions not associated with Fundamental...........................................................16 3.1.6Occupied Bandwidth...............................................................................................................17 3.1.7Photograph of Radiated Test Setup - per 2.1033(b)(7).........................................................18 4.LABELING REQUIREMENTS - PER 2.1033(B)(7)...........................................................................19 4.1ADDITIONAL LABEL REQUIRED...........................................................................................................19 4.2PHOTOGRAPH OF LABEL PLACEMENT AND CONTENTS........................................................................19 5.SCHEMATIC DIAGRAMS..................................................................................................................20 6.OWNERS MANUAL...........…

Text truncated - open the document above for the full version.

06036-1 Elite Transponder low fre(4/99)DNB Engineering, Inc.Page 1 RADIATED EMISSIONS FCC Part 15, Sub-part C (15.209) File #Engr.:Date : Site :2Distance3meter Cables 2.2 Bicon:187 Log: 10 Amp 1 : 67 Meas Type AmpDuty/CableAntennaTotal Ave Freq.Meas'dFactorsFactorsFactorsFactorsTotalLimitDeltaAzimuthHeightHor/HP/ QP (MHz)(dBuV)(dB)(dB)(dB)(dBuV/m)(dBuV/m)(dBuV/m)(dB)(degree)(m)VertR&SPeakComments 418.00081.826.3-1.617.9-10.071.8080.3-8.501VertR&SQP run 1 EUT flat on the table 836.00036.026.92.224.2-0.535.5060.3-24.801VertR&SQP run 1 EUT flat on the table 418.00083.026.3-1.617.9-10.073.0080.3-7.302811Hor/HP/Peak run 2 new battery 12-23-99 EUT flat 835.99844.226.92.224.2-0.543.6860.3-16.622801Hor/HP/Peak run 2 new battery 12-23-99 EUT flat 418.30066.826.3-1.617.9-10.056.7580.3-23.550-3601VertHP/Peak eut flat on the table 418.30081.426.3-1.617.9-10.071.3580.3-8.950-3611VertHP/Peak eut standing on its end Vertical 418.30079.126.3-1.617.9-10.069.0580.3-11.250-3621VertHP/Peak eut on its side 418.30071.426.3-1.617.9-10.061.4080.3-18.902801Hor/HP/Peak eut on its side 418.03078.126.3-1.617.9-10.068.1080.3-12.202801Hor/HP/Peak eut standing on its end Vertical 06036-1Yancey StaplesDec 20, 1999 1100 E. Chalk Creek Rd. Coalville, UT, 84017 Data not valid for report unless signed by DNB personnel _____________________________ Phone (435) 336-4433 Fax (435) 336-4436

FCC ID: NIFAT1K DATE: 12/17/99 REPORT #06036-1F 18 3.1.7 Photograph of Radiated Test Setup - per 2.1033(b)(7) Transponder (418.0 MHz) PDF File. See the attachment that was electronically submitted.