
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
SECURICOR EMS FCC ID: NSNEMSWPRFB
Dear Mrs. Green: The label will look like: and will be located on the underside of the watch patrol main body. This product is worn like a wrist watch. The FCC label will be against the skin of the person wearing it. Thank you, Mike Redfield PDE Laboratories (949) 361-9189 FCC ID: NSNEMSWPRFB
FCC PART 15 SUBPART C Intentional Radiators EVALUATION REPORT RADIO FREQUENCY INTERFERENCE TEST Prepared for: SECURICOR EMS 30201 Aventura Rancho Santa Margarita, California 92653 Product Description: UHF Transmitter (FCC ID: NSNEMSWPRFB) Model: Watch Patrol 418.00 MHz Test Completion Date: June 12, 2002 TABLE OF CONTENTS 1.0LETTER OF CERTIFICATION 2.0SUMMARY OF TEST 2.1 ADMINISTRATIVE DATA AND TEST DESCRIPTION 2.2 TEST RESULT - CONDUCTED EMISSIONS 2.3 TEST RESULT - RADIATED EMISSIONS 2.4 MODIFICATIONS 2.5 INTENT TO INCORPORATE ENGINEERING REWORK 2.6 RECOMMENDATIONS 3.0TEST CONFIGURATION AND DESCRIPTION OF EUT 3.1 SKETCH OF EQUIPMENT AND CABLE CONFIGURATION 3.2.1 DESCRIPTION OF EUT 3.2.2 DESCRIPTION OF PERIPHERAL EQUIPMENT 3.3 TYPES OF CABLES USED 3.4 OPERATION MODES 3.5 PHOTOGRAPHS OF TEST SETUP AND EUT 3.6 DETAILED BLOCK DIAGRAM OF EUT 4.0TEST EQUIPMENT AND TEST SETUPS 4.1 LIST OF TEST EQUIPMENT USED AND CALIBRATION DATES 4.2 CONDUCTED EMISSIONS TEST SETUP 4.3RADIATED EMISSIONS TEST SETUP 5.0TEST PROCEDURE 5.1 CONDUCTED EMISSIONS TEST 5.2 RADIATED PRELIMINARY TEST 5.3RADIATED EMISSIONS TEST 5.4FINAL RADIATED TESTING 6.0SAMPLE CALCULATIONS 7.0 MEASUREMENTS AND UNCERTAINTIES 8.0 LABELING AND NOTIFICATION REQUIREMENTS 1.0LETTER OF CERT IFIC AT ION PDE Laboratories, Inc is accredited by the U.S. National Institute Standards Techno logy under NVLAP as suppliers of test results to the criteria established by ISO/IEC guide 25 and ISO 9002. PDE Laboratories, Inc. has been validated by the Chinese Taipei Bureau of Standards, Metrology and Inspection (BSMI) under the Asia Pacific Economic Cooperation Mutual Recognition Arrangement (APEC MRA). PDE Labs is provisionally designated to act as a Conformity Assessment Body (CAB) under Appendix B, Phase I Procedures of the APEC MRA. PDE Laboratories, Inc is approved by TUV Product Services as a test facility testing to the EMC DIRECTIVE 89/336/EEC. PDE Laboratories, Inc is approved as a contractor to Radio Frequency investigation LTD, a UK Competent Body and by Radio Frequency Technologies LTD, a Competent Body of Ireland. The data, data evaluation and equipment co nfiguration represented herein are a true and accurate representation of the test sample (EUT), and of the radio frequency susceptibility characteristics and measurements obtained as of the dates and at the times of the test under the conditio ns specified. The test results provided with this report indicate that the equipment tested is COMPLIANT with the followi ng R ules and Regulatio ns: 1)The Code of Federal Regulations 47, Part 15, Subpart C for a Certified product. Tests Performed By: ______________________ Terry Reysbergen Report Approved By: ______________________ David Feher 2.0SUMMARY OF TEST 2.1AADMINISTRATIVE DATA DEVICE TESTED: Description: UHF Transmitter (418.00 MHz) Model: Watch Patrol ACCESSORIES: N/A APPLICANT: SECURICOR EMS 30201 Aventura Rancho Santa Margarita, California 92653 FCC ID: NSNEMSWPRFB (Must appear o n the product) CONTACT:Bob Herrick MANUFACTURER: SECURICOR EMS 2.1B TEST DESCRIPTION FREQUENCY RANGES:Conducted: 0.45 - 30.0 MHz Radiated: 30.0 - 1000 MHz TEST LOCATION:950 Calle Negocio, San Clemente, Calif. 92673 TEST DATES:December 13, 1999, October 16, 2001, June 12, 2002 PURPOSE OF TEST:To demonstrate compliance with the limits of FCC Part 15C. TESTS PERFORMED:1.Conducted Emissions Per ANSI C63.4. 2.Radiated emissions Per ANSI C63.4 at 3 Meters. 3.Engineering Evaluations All Measurement Data is acquired according to the content of ANSI C63.4. The Test Site Data and performance complies with ANSI C63.4, unless supplemented with additional requirements as noted in the test report. 2.2 TEST RESULTS - CONDUCTED EMISSIONS Conducted Emission Results - High or Supply Lead ***Not applicable: Device internally battery powered 2.2TEST RESULTS - CONDUCTED EMISSIONS Conducted Emission Results โ Low or Return Lead ***Not applicable: Device internally battery powered 2.3TEST RESULTS - RADIATED EMISSIONS Measurements taken at 3 Meters. Carrier Limit Line Harmonics Limit Line 2.3TEST RESULTS Periodic Intentional Radiator Carrier emissio n at 418MHz is 95.3dbuV/m or 6.207 micro watt 2.3TEST RESULTS The bandwidth of the emission shall be no wider than .25% of the 418MHz carrier frequency (1.045 MHz) at the โ20db point. Per 15.231 (C). -20db 800KHz PRODUCT RADIATED EMISSIONS NOT E: No emissions w ere detected from the 4 th harmonic and above. 2.4MODIFICATIONS None required to demonstrate compliance. Product compliant as tested. 2.5 INTENT TO INCORPORATE ENGINEERING REWORK (If required by 2.4 above) INTENT TO INCORPORATE ENGINEERING REWORK This is a letter of Intent to Incorporate the Engineering Rework as described in the above referenced PDE Laboratories. Test Report, Section 2.4, to achieve compliance with the intent of the testing as documented. I, the undersigned have the respo nsibility for marketing the device tested, and have implemented procedures to monitor the quality of the product (device tested), during continued manufacturing processes and possible product changes or enhancements, and take the respo nsibility to monitor continued compliance thro ugh periodic re- testing during the life of product (device tested), and re-testing any new configuration which might alter the status of the product's continued compliance to the applicable Rules and Regulations. [ NOT APPLICABLE FOR THIS TEST REPORT ] ________________________________________________ SignatureDate ______________________________ Name ______________________________ Title 2.6RECOMMENDATIONS None. Refer to paragraph 2.4 for any applicable comments. 3.0DESCRIPTION OF EUT CONFIGURATION 3.1SKETCH OF EQUIPMENT AND CABLE CONFIGURATION NOTE: This product is a physically autonomous product that has no physical connection to external devices. See photos for details of product. This product does interact with a mating receiver to complete the system in which it is a representative part. This product was tested and evaโฆ
Text truncated - open the document above for the full version.
950 Calle Negocio ยท San Clemente, California ยท United States
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15.231 | 418 MHz - 418 MHz | - |

PID WITH ZIGBEE (802.15.4) 2.4GHz
Equipment Class
DTS - Digital Transmission System
UHF Transmitter
Equipment Class
DSC - Part 15 Security/Remote Control TransmitterPeople Locator
Equipment Class
DXX - Part 15 Low Power Communication Device TransmitterHome Monitoring System Receiver
Equipment Class
CYY - Communications Receiver used w/Pt 15 Transmitter