
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
Product Manual 0 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The device complies with industry Canada license-exempt RSS standard(s). Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement." Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/NMB-3(B)
Blue Anatomy Limited Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Request for Confidentiality Company name: Blue Anatomy Limited FCC ID : OJ3-IKS5 FCC Part 15 Certification Gentlemen, Pursuant to 47 CFR 0.457(d)(1)(ii) and 0.459 we hereby requests permanent confidentiality of the following documents for the subject application: Exhibit Type Description ☒ Schematics All circuitry of devices and component values ☒ Block Diagrams Details of device showing the frequency of all oscillators ☒ Operational Description Description of the circuit functions Note: Exhibit types that are commonly held confidential are: (1) Schematics, (2) Block Diagrams, (3) Bill Of Materials, (4) Operational Descriptions. Any exhibit NOT granted confidentiality is viewable on the FCC website as soon as a grant is issued. These documents contain detailed system and equipment description and related information about the product which we considers to be proprietary, confidential and a custom design and otherwise would not release to the general public. Since the design is a basis from which future technological products will evolve, we consider that this information would be of benefit to its competitors and that the disclosure of the information in these documents would give competitors an unfair advantage in the market. Yours sincerely, Signatory Name Mr.Leo Wang Position Manager Company Name Blue Anatomy Limited Address Room 615, 6 Floor, East Ocean Centre, 98 Granville Road, Tsimshatsui, Kowloon, HongKong Tel +86-028-86083300 Fax +86-028-86083301 Email [email protected]
Top View Bottom View Front View Right View Rear View Left View
80mm 35mm FCC ID: OJ3-IKS5 IC: 10422A-IKS5 Blue Anatomy Limited Model name: Bite Smart Kitchen Scale Model No.: iKS5 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Label Location
Antenna
Shenzhen Certification Technology Service Co., Ltd 2F, Building B, East Area of Nanchang Second Industrial Zone, Gushu 2nd Road, Bao'an District, Shenzhen 518126, P.R. China. FCC ID:OJ3-IKS5 / IC:10422A-IKS5 Page 1 of 41 TEST REPORT FCC ID:OJ3-IKS5 / IC:10422A-IKS5 Applicant : Blue Anatomy Limited Address : Room 615, 6 Floor, East Ocean Centre, 98 Granville Road, Tsimshatsui, Kowloon, Hong Kong Equipment Under Test (EUT): Name : Bite Smart Kitchen Scale Model : iKS5 Standards : FCC PART 15, SUBPART C : 2013 (Section 15.247)/ IC RSS-210 ISSUE 8 with amendment June 2010 Report No : CST-TCB140118002 Date of Test : February 10- February 15, 2014 Date of Issue : February 17, 2014 * In the configuration tested, the EUT complied with the standards specified above Authorized Signature (Mark Zhu) General Manager The manufacture should ensure that all the products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of Shenzhen Certification Technology Service Co., Ltd. Or test done by Shenzhen Certification Technology Service Co., Ltd. Approvals in connection with, distribution or use of the product described in this report must be approved by Shenzhen Certification Technology Service Co., Ltd. Approvals in writing. Test Result : PASS * Report No.: CST-TCB140118002 FCC ID:OJ3-IKS5 / IC:10422A-IKS5 Page 2 of 41 TABLE OF CONTENT Description Page 1 General Information------------------------------------------------------------------------------------3 1.1 Description of Device (EUT)---------------------------------------------------------------------3 1.2 Description of Test Facility-----------------------------------------------------------------------3 2 EMC Equipment List------------------------------------------------------------------------------------4 3 Test Procedure-------------------------------------------------------------------------------------------5 4 Summary of Measurement---------------------------------------------------------------------------6 4.1 Summary of test result-----------------------------------------------------------------------------6 4.2 Test connection-------------------------------------------------------------------------------------6 4.3 Assistant equipment used for test----------------------------------------------------------------7 4.4 Test mode--------------------------------------------------------------------------------------------7 4.5 Test Conditions-------------------------------------------------------------------------------------7 4.6 Measurement Uncertainty (95% confidence levels, k=2)-------------------------------------7 5 Spurious Emission-------------------------------------------------------------------------------------8 5.1 Radiation Emission---------------------------------------------------------------------------------8 6 POWER LINE CONDUCTED EMISSION-------------------------------------------------------16 6.1 Conducted Emission Limits(15.207)-----------------------------------------------------------16 6.2 Test Setup-------------------------------------------------------------------------------------------16 6.3 Test Procedure-------------------------------------------------------------------------------------17 6.4 Test Results-----------------------------------------------------------------------------------------17 7 Conducted Maximum Output Power-----------------------------------------------------------18 7.1 Test limit--------------------------------------------------------------------------------------------18 7.2 Test Procedure-------------------------------------------------------------------------------------18 7.3 Test Setup-------------------------------------------------------------------------------------------18 7.4 Test Results-----------------------------------------------------------------------------------------18 8 PEAK POWER SPECTRAL DENSITY-----------------------------------------------------------19 8.1 Test limit--------------------------------------------------------------------------------------------19 8.2 Method of measurement--------------------------------------------------------------------------19 8.3 Test Setup-------------------------------------------------------------------------------------------19 8.4 Test Results-----------------------------------------------------------------------------------------19 9 Bandwidth-----------------------------------------------------------------------------------------------22 9.1 Test limit--------------------------------------------------------------------------------------------22 9.2 Method of measurement--------------------------------------------------------------------------22 9.3 Test Setup-------------------------------------------------------------------------------------------22 9.4 Test Results-----------------------------------------------------------------------------------------22 10 Band Edge Check-------------------------------------------------------------------------------------25 10.1 Test limit--------------------------------------------------------------------------------------------25 10.2 Test Procedure-------------------------------------------------------------------------------------25 10.3 Test Setup-------------------------------------------------------------------------------------------25 10.4 Test Result------------------------------------------------------------------------------------------25 11 Antenna Requirement-------------------------------------------------------------------------------30 11.1 Standard Requirement----------------------------------------------------------------------------30 11.2 Antenna Connected Construction---------------------------------------------------------------30 11.3 Result--…
Text truncated - open the document above for the full version.
Photographs-Radiated Emission Test Setup in Chamber Below 1G Above 1G
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 2.40 GHz - 2.48 GHz | 3.00 mW |

Wireless Body Scale
Equipment Class
DSS - Part 15 Spread Spectrum Transmitter