OQO-BNTXCP2Transmitter

This Pac ka ge includes: • Batter y Product Featur es include: To get the most out of this product, please read these instructions carefully. Wir eless Door Chime Accessory Transmitter INSTALLATION 1. Install batter y. (supplied). 2. Set the frequency code to match your door chime. 3. Befor e mounting, t est the range. 4. Mount chime but ton. OPERATION BATTERY REPLACEMENT Chime Button ADDITIONAL DOOR CHIMES TROUBLESHOOTING below. Chime rings on its own: Chime doesn’t sound: same. Batteries are OK, but chime does not work when installed: but ton. Questions on this product? Call 1-800-637-1 453 7:30 AM to 6:00 PM Central Time, Weekdays Regulator y Infor mation The user is cautioned that changes or modifications not expressly approved by the party responsible for regulator y compliance could void the user’s authority to operat e this equipment. • Door chime but ton You will need a screwdriver and other tools depending on ho w the button is mounted. • Batter y powered transmitter - No wires to run. • Channels are selectable to allow more then one door chime to ring at the same time. Remove the cover from the side of the chime button case. Lift the case up and away from the back. Install battery Make sure that the frequency set matched on both the but ton and chime. Replace cover removed in Step 1. Put the chime and the button where you want to mount them and then press the button. Drill 3/4” diameter x 3-1/2” deep hole at chime button location. Insert button into escutcheon and use provided hardwar e to install. Press the door chime button to verify that the button and chime work properly. When the button is pressed, the chime should sound. If it doesn’t, check that the frequency codes are set the same and that the alkaline batteries are fresh. Replace batteries following door chime instructions. Open button case (see Step 1). Replace battery with one N Cell, 1.5V alkaline battery. Close button case. When installing other Wireless Door Chime sets, remenber to set switches to different settings to avoid interference. If you want them to all ring at the same time, set them to the same frequency code. The range of the door chime depends on location, temperature and battery condition. If you are having problems with this product, please try the solutions listed • A neighbor may have a wireless chime set with the same frequency jumper settings. Change the chime and button fr equency jumpers. • Make sure the button and the chime jumpers are set the • Replace the button battery. Also check chime batteries. • Mounting the chime or button directly on metal, concrete or near metal studs reduces the range. • Do not mount the chime too close to ground level concrete slabs which may also reduce the range. Mount the chime away from the floor. • Try different locations for the chime closer to the button. Also, try to orient the chime at a different angle to increase the range. Range is most effective to the sides of the 99528379A BROAN-NUTONE ONE YEAR LIMITED WARRANTY Br oan-NuTone warrants to the or iginal consumer purchaser of its pr oducts that such pr oducts will be fr ee fr om defects in mater ials or wor kmanship for a period of one year fr om the date of or iginal purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FI TNESS FOR A PARTICULAR PURPOSE. Dur ing this one-year period, Br oan-NuTone will, at its option, repair or replace, without charge , an y pr oduct or part which is found t o be defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not co ver (a) no rmal maintenance and service or (b) an y pr oducts or parts which ha ve been subject to misuse, negligence, accident, improper maintenance or repair (other than by Br oan-NuTone), faulty installation or installation contrar y t o recommended installation instructions. The duration of an y implied warranty is limited to the one-year period as specified for the express warranty. Some st at es do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply t o you. BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some st at es do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply t o you. This warranty gives you specific legal rights, and you may also ha ve other rights, which var y fr om st at e to st at e. This warranty supersedes all prior w arranties. To qualify for warranty service, you must (a) notify Br oan-NuTone at the address or telephone number below, (b) give the model number and part identification and (c) describe the nature of an y defect in the pr oduct or part. At the time of requesting warranty service, y ou must present evidence of the original purchase date. Br oan-NuTone LLC, 926 W. Stat e Street, Hartf or d, Wisconsin 53027 www.n ut one.com 800-558-171 1 WARRANTY • This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC NOTE the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. • This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. • If this equipment does cause harmful interference to radio or television reception, which can be determi…

Text truncated - open the document above for the full version.

Click to buy NOW! P D F - X C h a n g e V i e w e r w w w . d o c u - t r a c k . c o m Click to buy NOW! P D F - X C h a n g e V i e w e r w w w . d o c u - t r a c k . c o m

PHOTOGRAPH OF THE PRODUCT FRONT VIEW OF THE PRODUCT REAR VIEW OF THE PRODUCT PHOTOGRAPH OF THE PRODUCT TOP VIEW OF THE PRODUCT BTTOM VIEW OF THE PRODUCT

PHOTOGRAPH OF THE PRODUCT INNER CIRCUIT TOP VIEW PHOTOGRAPH OF THE PRODUCT INNER CIRCUIT BOTTOM VIEW

STC Test Report Date : 2012-07-19 Page 1 of 19 No. : MH186941 T h e H o n g K o n g S t a n d a r d s a n d T e s t i n g C e n t r e L t d . 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] This report shall not be reproduced unless with prior written approval from the Hong Kong Standards and Testing Centre Ltd. For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of Homepage. Applicant (SMH001): Golden Prosper Enterprises LTD. Flat G, 8/F Kim Tak Bldg., 328-342 Nathan Road, Kowloon Hong Kong Description of Sample(s): Submitted sample(s) said to be Product: Transmitter Brand Name: Broan-NuTone Model Number: CP2 FCC ID: OQO-BNTXCP2 Date Sample(s) Received: 2012-06-27 Date Tested: 2012-07-12 Investigation Requested: Perform ElectroMagnetic Interference measurement in accordance with FCC 47CFR [Codes of Federal Regulations] Part 15: 2011 and ANSI C63.4:2009 for FCC Certification. Conclusion(s): The submitted product COMPLIED with the requirements of Federal Communications Commission [FCC] Rules and Regulations Part 15. The tests were performed in accordance with the standards described above and on Section 2.2 in this Test Report. Remark(s): --- Dr. LEE Kam Chuen Authorized Signatory ElectroMagnetic Compatibility Department For and on behalf of The Hong Kong Standards and Testing Centre Ltd. STC Test Report Date : 2012-07-19 Page 2 of 19 No. : MH186941 T h e H o n g K o n g S t a n d a r d s a n d T e s t i n g C e n t r e L t d . 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Ltd. For Conditions of Issuance of this test report, please refer to the overleaf or Homepage CONTENT: Cover Page 1 of 19 Content Page 2-3 of 19 1.0 General Details 1.1 Equipment Under Test [EUT] Page 4 of 19 Description of EUT operation 1.2 Date of Order Page 4 of 19 1.3 Submitted Sample(s) Page 4 of 19 1.4 Test Duration Page 4 of 19 1.5 Country of Origin Page 4 of 19 1.6 2.0 Technical Details 2.1 Investigations Requested Page 5 of 19 2.2 Test Standards and Results Summary Page 5 of 19 3.0 Test Results 3.1 Emission Page 6-9 of 19 3.2 Bandwidth Measurement Page 10-11 of 19 STC Test Report Date : 2012-07-19 Page 3 of 19 No. : MH186941 T h e H o n g K o n g S t a n d a r d s a n d T e s t i n g C e n t r e L t d . 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Ltd. For Conditions of Issuance of this test report, please refer to the overleaf or Homepage Appendix A List of Measurement Equipment Page 12 of 19 Appendix B Duty Cycle Correction During 100 msec Page 13-16 of 19 Appendix C A manually Operation Page 17 of 19 Appendix D Photographs Page 18-19 of 19 STC Test Report Date : 2012-07-19 Page 4 of 19 No. : MH186941 T h e H o n g K o n g S t a n d a r d s a n d T e s t i n g C e n t r e L t d . 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Ltd. For Conditions of Issuance of this test report, please refer to the overleaf or Homepage 1.0 General Details 1.1 Equipment Under Test [EUT] Description of Sample(s) Submitted sample(s) said to be Product: Transmitter Manufacturer: Dongguan Smart Hero Electronic Products Co., Ltd. 118 Li Xiang West Rd, Shuiping Village, Dalang Town, Dongguan, Guangdong Brand Name: Broan-NuTone Model Number: CP2 Rating: 1.5Vd.c. (“LR1” size battery x 1) 1.2.1 Description of EUT Operation The Equipment Under Test (EUT) is a Golden Prosper Enterprises LTD., Transmitter. The transmitter is a manually operated transmitter. The EUT will automatically cease transmission after one packet has been sent. It is pulse transmitter. Modulation by IC; and type is ASK modulation. 1.3 Date of Order 2012-06-27 1.4 Submitted Sample(s): 1 Sample 1.5 Test Duration 2012-07-12 1.6 Country of Origin China STC Test Report Date : 2012-07-19 Page 5 of 19 No. : MH186941 T h e H o n g K o n g S t a n d a r d s a n d T e s t i n g C e n t r e L t d . 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Ltd. For Conditions of Issuance of this test report, please refer to the overleaf or Homepage 2.0 Technical Details 2.1 Investigations Requested Perform ElectroMagnetic Interference measurement in accordance with FCC 47CFR [Codes of Federal Regulations] Part 15 2011 and ANSI C63.4:2009 for FCC Certification. 2.2 Test Standards and Results Summary Tables EMISSION Results Summary Test Condition Test Requirement Test Method Class / Test Result Severity Pass Failed N/A Field Strength of Fundamental Emissions & Spurious Emissions FCC 47CFR 15.231a ANSI C63.4:2009 N/A Radiated Emissions FCC 47CFR 15.209 ANSI C63.4:2009 N/A Note: N/A - Not Applicable STC Test Report Date : 2012-07-19 Page 6 of 19 No. : MH186941 T h e H o n g K o n g S t a n d a r d s a n d T e s t i n g C e n t r e L t d . 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] This report shall not be reproduced unless with prior written approval from The Hong Kong Standards and Testing Centre Ltd. For Conditions of Issuance of this test report, pleas…

Text truncated - open the document above for the full version.

PHOTOGRAPH OF THE PRODUCT MEASUREMENT OF RADIATED EMISSION TEST SET UP