OUCGGM-M018ETACS

1/1 Since this device is alwa ys used with vehicle, it is not sold to general end users separatel y. Therefore there is no user manual of this device by alone. The following statements must be described on the user manual of the vehicle;

CONFIDENTIAL AM-E201856 16/20 7. Photographs Figure 7.1 Appearance (front view) Figure 7.2 Appearance (back view) CONFIDENTIAL AM-E201856 17/20 Figure 7.3 Appearance (side1 view) Figure 7.4 Appearance (side2 view) Figure 7.5 Appearance (side3 view) Figure 7.6 Appearance (side4 view)

CONFIDENTIAL AM-E201856 19/20 8. Label and labeling location Figure 8.1 Label Figure 8.1 Label(1) Figure 8.2 Label(2) FCC ID： Model： OUCGGM-M018 GGM-M018 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. MIN 1.4mm MIN 1.4mm CUSTOMER PARTS NO. PRODUCER COUNTRY BARCODE BARCODE COMPANY BRAND CONFIDENTIAL AM-E201856 20/20 Figure 8.3 Labeling location Label(1) Label(2)

CONFIDENTIAL AM-E201856 18/20 Figure 7.3 PCB ASSY (front view) Figure 7.4 PCB ASSY (back view)

Test report No. : 13380256H Page : 1 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 Facsimile : +81 596 24 8124 Report Cover Page - 13-EM-F0429 Issue # 17.0 EMI TEST REPORT Test Report No. : 13380256H Applicant : NIDEC MOBILITY CORPORATION Type of EUT : ETACS Model Number of EUT : GGM-M018 FCC ID : OUCGGM-M018 Test regulation : FCC Part 15 Subpart B: 2020 Test Result : Complied (Refer to SECTION 3.2) Date of test: June 28, 2020 Representative test engineer: Akihiko Maeda Engineer Consumer Technology Division Approved by: Shinichi Miyazono Engineer Consumer Technology Division This report contains data that are not covered by the NVLAP accreditation. There is no testing item of "Non-accreditation". 1. This test report shall not be reproduced in full or partial, without the written approval of UL Japan, Inc. 2. The results in this report apply only to the sample tested. 3. This sample tested is in compliance with the limits of the above regulation. 4. The test results in this test report are traceable to the national or international standards. 5. This test report covers EMC technical requirements. It does not cover administrative issues such as Manual or non-EMC test related Requirements. (if applicable) 6. The all test items in this test report are conducted by UL Japan, Inc. Ise EMC Lab. 7. This test report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the U.S. Government. 8. The information provided from the customer for this report is identified in SECTION 1. This laboratory is accredited by the NVLAP LAB CODE 200572-0, U.S.A. The tests reported herein have been performed in accordance with its terms of accreditation. *As for the range of Accreditation in NVLAP, you may refer to the WEB address, http://japan.ul.com/resources/emc_accredited/ Test report No. : 13380256H Page : 2 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 Facsimile : +81 596 24 8124 REVISION HISTORY Original Test Report No.: 13380256H Revision Test report No. Date Page revised Contents - (Ori ginal) 13380256H July 8, 2020 - - Test report No. : 13380256H Page : 3 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 Facsimile : +81 596 24 8124 Reference: Abbreviations (Including words undescribed in this report) AAN Asymmetric Artificial Network ILAC International Laboratory Accreditation Conference AC Alternating Current ISED Innovation, Science and Economic Development Canada AM Amplitude Modulation ISN Impedance Stabilization Network AMN Artificial Mains Network ISO International Organization for Standardization Amp, AMP Amplifier JAB Japan Accreditation Board ANSI American National Standards Institute LAN Local Area Network Ant, ANT Antenna LCL Longitudinal Conversion Loss AP Access Point LIMS Laboratory Information Management System ASK Amplitude Shift Keying LISN Line Impedance Stabilization Network Atten., ATT Attenuator MRA Mutual Recognition Arrangement AV Average N/A Not Applicable BPSK Binary Phase-Shift Keying NIST National Institute of Standards and Technology BR Bluetooth Basic Rate NS No signal detect. BT Bluetooth NSA Normalized Site Attenuation BT LE Bluetooth Low Energy NVLAP National Voluntary Laboratory Accreditation Program BW BandWidth OBW Occupied Band Width C.F Correction Factor OFDM Orthogonal Frequency Division Multiplexing Cal Int Calibration Interval PK Peak CAV CISPR AV P LT long-term flicker severity CCK Complementary Code Keying POHC(A) Partial Odd Harmonic Current CDN Coupling Decoupling Network Pol., Pola. Polarization Ch., CH Channel PR-ASK Phase Reversal ASK CISPR Comite International Special des Perturbations Radioelectriques P ST short-term flicker severity Corr. Correction QAM Quadrature Amplitude Modulation CPE Customer premise equipment QP Quasi-Peak CW Continuous Wave QPSK Quadri-Phase Shift Keying DBPSK Differential BPSK r.m.s., RMS Root Mean Square DC Direct Current RBW Resolution Band Width DET Detector RE Radio Equipment D-factor Distance factor REV Reverse Dmax maximum absolute voltage change during an observation period RF Radio Frequency DQPSK Differential QPSK RFID Radio Frequency Identifier DSSS Direct Sequence Spread Spectrum RSS Radio Standards Specifications EDR Enhanced Data Rate Rx Receiving e.i.r.p., EIRP Equivalent Isotropically Radiated Power SINAD Ratio of (Signal + Noise + Distortion) to (Noise + Distortion) EM clamp Electromagnetic clamp S/N Signal to Noise ratio EMC ElectroMagnetic Compatibility SA, S/A Spectrum Analyzer EMI ElectroMagnetic Interference SG Signal Generator EMS ElectroMagnetic Susceptibility SVSWR Site-Voltage Standing Wave Ratio EN European Norm THC(A) Total Harmonic Current e.r.p., ERP Effective Radiated Power THD(%) Total Harmonic Distortion EU European Union TR Test Receiver EUT Equipment Under Test Tx Transmitting Fac. Factor VBW Video BandWidth FCC Federal Communications Commission Vert. Vertical FHSS Frequency Hopping Spread Spectrum WLAN Wireless LAN FM Frequency Modulation xDSL Generic term for all types of DSL technology Freq. Frequency (DSL: Digital Subscriber Line) FSK Frequency Shift Keying Fund Fundamental FWD Forward GFSK Gaussian Frequency-Shift Keying GNSS Global Navigation Satellite System GPS Global Positioning System Hori. Horizontal ICES Interference-Causing Equipment Standard I/O Input/Output IEC International Electrotechnical Commission IEEE Institute of Electrical and Electronics Engineers IF Intermediate Frequency Test report No. : 13380256H Page : 4 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 …

Text truncated - open the document above for the full version.

Test report No. : 13380256H Page : 15 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 Facsimile : +81 596 24 8124 APPENDIX 3: Photographs of test setup Radiated Emission (Below 1 GHz) Photo 1 Photo 2 Test report No. : 13380256H Page : 16 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 Facsimile : +81 596 24 8124 Radiated Emission (Above 1 GHz) Photo 1 Photo 2 Test report No. : 13380256H Page : 17 of 17 Issued date : July 8, 2020 FCC ID : OUCGGM-M018 UL Japan, Inc. Ise EMC Lab. 4383-326 Asama-cho, Ise-shi, Mie-ken 516-0021 JAPAN Telephone : +81 596 24 8999 Facsimile : +81 596 24 8124 Worst Case Position (Horizontal: X-axis / Vertical: X-axis) X-axis Y-axis Z-axis End of Report