P4Q-N387Fitness Device

Fitness Device Magellan Switch UP, Switch, N387 User Manual Certification Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other aerial or transmitter. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment. The Magellan Switch must be installed and operated at a distance no closer then 8 inches (20 cm) from the user. This Class B digital device meets all requirements of the Canadian Interference-Causing Equipment Regulations. IC statement This device complies with Industry Canada licence-exempt RSS-210 & ICES003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. CE statement Products with the CE marking comply with Radio & Telecommunication Terminal Equipment Directive (R&TTE) (1999/5/EC), the Electromagnetic Compatibility Directive (2004/108/EC) and the Low Voltage Directive (2006/95/EC) - issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Standards: EN301489-1: Electronic compatibility and Radio spectrum Matters (ERM), ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements EN301489-17: Electronic compatibility and Radio spectrum Matters (ERM),ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 17: Specific conditions for 2,4 GHz wideband transmission systems and 5 GHz high performance RLAN equipment EN 300 440-2: "Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 1 GHz to 40 GHz frequency range; Part 1: Technical characteristics and test methods". EN55022: Radio disturbance characteristics EN55024: Immunity characteristics EN61000-3-2: Limits for harmonic current emissions EN61000-3-3: Limitation of voltage fluctuation and flicker in low-voltage supply system IEC60950-1+A1:2009: Product Safety The manufacturer cannot be held responsible for modifications made by the User and the consequences thereof, which may alter the conformity of the product with the CE Marking. Hereby, MiTAC International Corporation, declares that this Switch, Switch, N387 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Canada This Class B digital apparatus complies with Canada ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This device complies with Industry Canada licence-exempt RSS-210 & ICES003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. The information provided in this document is subject to change without notice. Improvements and enhancements to the product may occur without any formal notification. Check the Magellan website (www.magellanGPS.com) for product updates and additional information. Maximum normal use temperature is 66°C. © 2011 MiTAC International Corporation. The Magellan logo, M…

Text truncated - open the document above for the full version.

Fitness Device Magellan Switch UP, Switch, N387 User Manual Certification Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other aerial or transmitter. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the user’s authority to operate this equipment. The Magellan Switch must be installed and operated at a distance no closer then 8 inches (20 cm) from the user. This Class B digital device meets all requirements of the Canadian Interference-Causing Equipment Regulations. IC statement This device complies with Industry Canada licence-exempt RSS-210 & ICES003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. CE statement Products with the CE marking comply with Radio & Telecommunication Terminal Equipment Directive (R&TTE) (1999/5/EC), the Electromagnetic Compatibility Directive (2004/108/EC) and the Low Voltage Directive (2006/95/EC) - issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Standards: EN301489-1: Electronic compatibility and Radio spectrum Matters (ERM), ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 1: Common technical requirements EN301489-17: Electronic compatibility and Radio spectrum Matters (ERM),ElectroMagnetic Compatibility (EMC) standard for radio equipment and services; Part 17: Specific conditions for 2,4 GHz wideband transmission systems and 5 GHz high performance RLAN equipment EN 300 440-2: "Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD); Radio equipment to be used in the 1 GHz to 40 GHz frequency range; Part 1: Technical characteristics and test methods". EN55022: Radio disturbance characteristics EN55024: Immunity characteristics EN61000-3-2: Limits for harmonic current emissions EN61000-3-3: Limitation of voltage fluctuation and flicker in low-voltage supply system IEC60950-1+A1:2009: Product Safety The manufacturer cannot be held responsible for modifications made by the User and the consequences thereof, which may alter the conformity of the product with the CE Marking. Hereby, MiTAC International Corporation, declares that this Switch, Switch, N387 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. Canada This Class B digital apparatus complies with Canada ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This device complies with Industry Canada licence-exempt RSS-210 & ICES003. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The abbreviation, IC, before the registration number signifies that registration was performed based on a Declaration of Conformity indicating that Industry Canada technical specifications were met. It does not imply that Industry Canada approved the equipment. The information provided in this document is subject to change without notice. Improvements and enhancements to the product may occur without any formal notification. Check the Magellan website (www.magellanGPS.com) for product updates and additional information. Maximum normal use temperature is 66°C. © 2011 MiTAC International Corporation. The Magellan logo, M…

Text truncated - open the document above for the full version.

FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC APPENDIX 2 EXTERNAL PHOTOGRAPHS OF EUT FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC All View of EUT Front of EUT FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Back of EUT Site View of EUT – 1 FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Site View of EUT – 2 Site View of EUT – 3 FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Adapter

FCC ID & IC LABEL FORMAT AND LOCATION Applicant: Mitac International Corporation FCC ID: P4Q-N387 IC: 2420C-N387

FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC APPENDIX 3 INTERNAL PHOTOGRAPHS OF EUT FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Open View of EUT Internal of EUT – 1 FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Internal of EUT – 2 Internal of EUT –3 FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Internal of EUT – 4 Internal of EUT – 5 Antenna

FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC APPENDIX 1 PHOTOGRAPHS OF SETUP FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Radiated Emission Setup Photos FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Conducted Emission Setup Photos

FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC APPENDIX 1 PHOTOGRAPHS OF SETUP FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Radiated Emission Setup Photos FCC ID: P4Q-N387 IC: 2420C-N387 International Standards Laboratory Report Number: ISL-11LR054FC Conducted Emission Setup Photos