P4Q-N435Tablet PC

                                  This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Operations in the 5.15-5.25GHz band are restricted to indoor usage only. This device This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless device employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. * Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands. Note: The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.

Page 1 CONSTRUCTION PHOTOS OF EUT Page 2 Page 3 Page 4 Page 5 Page 6

Back cover of EUT FCC ID: P4Q-N435 Label Location

Ref. NoteNANANA V NOTE: 1. Material: white Mylar 50#,PET, 2. Color: Text-Pantone Cool Gray 7C/ other color follow artwork 3. All of printing should follow Mitac's artwork 4. 5. Joyce.Tsai 2014/7/10 Joyce.Tsai 2014/7/10 Nemo.Chen 2014/7/10 Nemo.Chen 2014/7/10 242N43500032 R00 TF-LABEL;RATING,EU,USA,3G,WIFI,WHITE,GAIA R0.8 x2 28 mm 37.5 mm LASER RADIATION DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT P < 1mW λ=650 nm IEC/EN 60825-1:2007 _ X-XX K Model No: N435Tablet PC Made in China P/N: 242N43500032 R00 Input: 5V 2A R1.8 x2 Vendor Code ●Marketing name ●Bar Code ●Serial No. Caution: Only use the specified power supply (see user’s manual) DID: D021801 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. FCC ID: P4Q-N435 2200

Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24 Page 25

Report No.: RF140312C09-7 1 of 53 Report Format Version 5.0.0 FCC TEST REPORT (NFC) REPORT NO.: RF140312C09-7 MODEL NO.: N435 FCC ID: P4Q-N435 RECEIVED: Mar. 12, 2014 TESTED: Jul. 17, 2014 ~ Jul. 21, 2014 ISSUED: Jul. 25, 2014 APPLICANT: MiTAC International Corp. ADDRESS: Building B, No. 209, Sec. 1, Nan Gang Rd., Nan Gang Dist., Taipei 11568, Taiwan, R.O.C. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Vil., Lin Kou Dist., New Taipei City, Taiwan, R.O.C. TEST LOCATION: No. 19, Hwa Ya 2nd Rd, Wen Hwa Tsuen, Kwei Shan Hsiang, Taoyuan Hsien 333, Taiwan, R.O.C. This report is for your exclusive use. Any copying or replication of this report to or for any other person or entity, or use of our name or trademark, is permitted only with our prior written permission. This report sets forth our findings solely with respect to the test samples identified herein. The results set forth in this report are not indicative or representative of the quality or characteristics of the lot from which a test sample was taken or any similar or identical product unless specifically and expressly noted. Our report includes all of the tests requested by you and the results thereof based upon the information that you provided to us. You have 60 days from date of issuance of this report to notify us of any material error or omission caused by our negligence, provided, however, that such notice shall be in writing and shall specifically address the issue you wish to raise. A failure to raise such issue within the prescribed time shall constitute your unqualified acceptance of the completeness of this report, the tests conducted and the correctness of the report contents. Unless specific mention, the uncertainty of measurement has been explicitly taken into account to declare the compliance or non-compliance to the specification. This report should not be used by the client to claim product certification, approval, or endorsement by TAF or any government agencies. Report No.: RF140312C09-7 2 of 53 Report Format Version 5.0.0 Table of Contents RELEASE CONTROL RECORD ............................................................................................................. 3 1. CERTIFICATION ................................................................................................................................. 4 2. SUMMARY OF TEST RESULTS ........................................................................................................ 5 2.1 MEASUREMENT UNCERTAINTY ................................................................................................ 5 3. GENERAL INFORMATION ................................................................................................................. 6 3.1 GENERAL DESCRIPTION OF EUT ............................................................................................ 6 3.2 DESCRIPTION OF TEST MODES .............................................................................................. 7 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ................................... 7 3.3 DESCRIPTION OF SUPPORT UNITS ........................................................................................ 8 3.3.1 CONFIGURATION OF SYSTEM UNDER TEST............................................................... 8 3.4 GENERAL DESCRIPTION OF APPLIED STANDARDS ............................................................. 9 4. TEST TYPES AND RESULTS ..........................................................................................................10 4.1 RADIATED EMISSION MEASUREMENT .................................................................................10 4.1.1 LIMITS OF RADIATED EMISSION MEASUREMENT ....................................................10 4.1.2 TEST INSTRUMENTS .................................................................................................... 11 4.1.3 TEST PROCEDURES .....................................................................................................12 4.1.4 DEVIATION FROM TEST STANDARD ...........................................................................12 4.1.5 TEST SETUP ..................................................................................................................13 4.1.6 EUT OPERATING CONDITIONS ....................................................................................13 4.1.7 TEST RESULTS ..............................................................................................................14 4.2 CONDUCTED EMISSION MEASUREMENT ............................................................................38 4.2.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT ...............................................38 4.2.2 TEST INSTRUMENTS ....................................................................................................38 4.2.3 TEST PROCEDURES .....................................................................................................39 4.2.4 DEVIATION FROM TEST STANDARD ...........................................................................39 4.2.5 TEST SETUP ..................................................................................................................39 4.2.6 EUT OPERATING CONDITIONS ....................................................................................39 4.2.7 TEST RESULTS ..............................................................................................................40 4.3 FREQUENCY STABILITY .........................................................................................................42 4.3.1 LIMITS OF FREQUENCY STABILITY MEASUREMENT ...............................................42 4.3.2 TEST INSTRUMENTS ....................................................................................................42 4.3.3 TEST PROCEDURE ................................................................…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST (For Bluetooth) 2 CONDUCTED EMISSION TEST (For WLAN) 3 RADIATED EMISSION TEST (For WLAN 2.4GHz) MODE A / B / C 4 RADIATED EMISSION TEST (For WLAN 2.4GHz) MODE D / E / F 5 RADIATED EMISSION TEST (For WLAN 5GHz) MODE A / B / C 6 RADIATED EMISSION TEST (For WLAN 5GHz) MODE D / E / F 7 RADIATED EMISSION TEST (For Bluetooth) MODE A 8 RADIATED EMISSION TEST (For Bluetooth) MODE B 9 RADIATED EMISSION TEST (For NFC) MODE A / B / C 10 RADIATED EMISSION TEST (For NFC) MODE D / E / F 11 (WWAN) (PART 22) RADIATED EMISSION TEST - MODE A & C 12 RADIATED EMISSION TEST - MODE B 13 RADIATED EMISSION TEST - MODE D & F 14 RADIATED EMISSION TEST - MODE E 15 ERP POWER TEST 16 (PART 24) RADIATED EMISSION TEST - MODE A 17 RADIATED EMISSION TEST - MODE B 18 RADIATED EMISSION TEST - MODE C 19 RADIATED EMISSION TEST - MODE D 20 RADIATED EMISSION TEST - MODE E 21 RADIATED EMISSION TEST - MODE F 22 EIRP POWER TEST 23 (PART 27) RADIATED EMISSION TEST - MODE A 24 RADIATED EMISSION TEST - MODE B & C 25 RADIATED EMISSION TEST - MODE D 26 RADIATED EMISSION TEST - MODE E & F 27 EIRP POWER TEST