PJ9TX21Remote Relay (Transmitter)

FCC ID. : PJ9TX21 CAUTION: To assure continued FCC compliance: z Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. FCC Label Compliance Statement: z This device complies with Part 15 of the FCC Rules. Operation is subject to he following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Request for Confidentiality Date: May 11, 2006 Federal Communications Commission Authorization and Evaluation Division Subject: Confidentiality Request regarding Application for certification of FCC ID: PJ9TX21 Gentlemen: Pursuant to Section 0.457 and 0.459 of the Commission’s Rules, we hereby request confidential treatment of information accompanying this application as outlined below: ‹ Block Diagram ‹ Schematics Diagram ‹ Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, _______________________________________ Richard Frizell Dynamco Pty, Ltd.

Helen Zhao To: cherry Cc: TTEMC (Mr. Leon Liu) (E-mail); T??? (Ben); [email protected] Subject: RE: Dynamco Pty. Ltd., FCC ID: PJ9TX21, Assessment NO.: AN06T5982, Notice#1 7/31/2006 Dear Helen, Please refer to the following for answer: Question # 1 : Revised block diagram, please see the attached file. Question # 2 : Revised operational description, please see the attached file. Should you have any queation or comments, please let me know. Best Regards, Cherry Wang -----Original Message----- Sent: Wednesday, July 19, 2006 11:34 AM Subject: Dynamco Pty. Ltd., FCC ID: PJ9TX21, Assessment NO.: AN06T5982, Notice#1 Question #1: The block diagram indicates: Note (1). These buttons are normally open (i.e. spring loaded to remain open and only close when pushing) (2). There is no latching circuit to lock on transmitter after initial button is pushed. Please explain where is the button and where is the spring. The schematic diagram does not show them either. Question #2: The operational description indicates "U2 is the microprocessor. Once a signal s received on wither PWM it will send a PWM signal to the base of Q1." Please rephase the second sentence as it is not understandable. Please explain what kind of signal will be received from whom to whom, and what kind of signal will be sent to Q1. Please explain what are CN1, CN2 in the schematic diagram. The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information within 30 days of the original e-mail date may result in application dismissal and forfeiture of the filing fee. Also, please note that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the e-mail address listed below the name of the sender. Best Regards, Helen Zhao

Dynamco Pty. Ltd. Remote Relay (Transmitter) FCC ID. : PJ9TX21 Photographs of EUT (External) Photos 1 General Appearance (Front View) Photos 2 General Appearance (Back View)

Dynamco Pty. Ltd. Remote Relay (Transmitter) FCC ID. : PJ9TX21 ID Label Format and Location z Label Format z Label Placement Location (Bottom Side of EUT) FCC ID : PJ9TX21

Dynamco Pty. Ltd. Remote Relay (Transmitter) FCC ID. : PJ9TX21 Photographs of EUT (Internal) Photos 1 PCB View Photos 2 PCB View

FCC ID.PJ9TX21 Page 1 of 21 APPLICATION FOR CERTIFICATION On Behalf of Dynamco Pty. Ltd. Remote Relay (Transmitter) Model : TX21 FCC ID：PJ9TX21 Prepared for : Dynamco Pty. Ltd. 10 Brown Street, East Perth, Western Australia 6004 Australia Prepared by : Audix Corporation Technical Division EMC Department No. 53-11, Tin-Fu Tsun, Lin-Kou, Taipei Hsien, Taiwan, R.O.C. Tel : (02) 2609-9301, 2609-2133 Fax: (02) 2609-9303 File Number ： EM950693 Report Number ： EM-F950258 Date of Test ： Jul. 03, 2006 Date of Report ： Jul. 07, 2006 Audix Corporation Report No.: EM-F950258 FCC ID.PJ9TX21 Page 2 of 21 TABLE OF CONTENTS Description Page TEST REPORT CERTIFICATION.......................................................................................................3 1. GENERAL INFORMATION..........................................................................................................4 1.1. Description of Device (EUT)..............................................................................................................4 1.2. Tested Supporting System Details......................................................................................................5 1.3. Description of Test Facility ................................................................................................................5 1.4. Measurement Uncertainty...................................................................................................................5 2. POWERLINE CONDUCTED EMISSION MEASUREMENT.....................................................6 3. RADIATED EMISSION MEASUREMENT..................................................................................7 3.1. Test Equipment...................................................................................................................................7 3.2. Test Setup...........................................................................................................................................7 3.3. Radiation Limit (§15.231)..................................................................................................................8 3.4. EUT’s Configuration during Compliance Measurement....................................................................8 3.5. Operating Condition of EUT ..............................................................................................................8 3.6. Test Procedure....................................................................................................................................9 3.7. Radiated Emission Noise Measurement Results...............................................................................10 4. EMISSION BANDWIDTH MEASUREMENT............................................................................14 4.1. Test Equipment.................................................................................................................................14 4.2. Block Diagram of Test Setup............................................................................................................14 4.3. Specification Limits [§15.231-(c)]...................................................................................................14 4.4. EUT’s Configuration during Compliance Measurement..................................................................14 4.5. Emission Bandwidth Measurement Results......................................................................................14 5. PERIODIC OPERATED MEASUREMENT................................................................................16 5.1. Test Equipment.................................................................................................................................16 5.2. Block Diagram of Test Setup............................................................................................................16 5.3. Specification Limits [§15.231-(a)-(1)]..............................................................................................16 5.4. EUT’s Configuration during Compliance Measurement..................................................................16 5.5. Periodic Operated Measurement Results..........................................................................................16 6. DEVIATION TO TEST SPECIFICATIONS................................................................................18 7. PHOTOGRAPHS...........................................................................................................................19 7.1. Photos of Radiated Measurement at Semi-Anechoic Chamber (30~1000MHz)........................................19 7.2. Photos of Radiated Measurement at Semi-Anechoic Chamber (1~5.5GHz)....................................20 7.3. Photos of Bandwidth Measurement.................................................................................................. 21 7.4. Photos of Periodic Operated Measurement.......................................................................................21 Audix Corporation Report No.: EM-F950258 FCC ID.PJ9TX21 Page 3 of 21 TEST REPORT CERTIFICATION Applicant ： Dynamco Pty. Ltd. Manufacturer ： Tesor Plus Corp. EUT Description ： Remote Relay (Transmitter) FCC ID ： PJ9TX21 (A) MODEL NO. ： TX21 (B) SERIAL NO. ： N/A (C) POWER SUPPLY：DC 12V Measurement Procedure Used: FCC RULES AND REGULATIONS PART 15 SUBPART C, FEB 2006 AND ANSI C63.4/2003 (FCC CFR 47 Part 15C, §15.231, §15.207 and §15.209) The device described above was tested by AUDIX COPORATION. to determine the maximum emission levels emanating from the device. The maximum emission levels were compared to the FCC Part 15 subpart C limits both radiated and conducted emissions. The measurement results are contained in this test report and AUDIX CORPORATION. is assumed full responsibility for the accuracy and completeness of these measurements. Also, this report shows that the EUT to be technically compliant with the FCC official limits…

Text truncated - open the document above for the full version.

FCC ID.PJ9TX21 Page 19 of 21 Audix Corporation Report No.: EM-F950258 7. PHOTOGRAPHS 7.1. Photos of Radiated Measurement at Semi-Anechoic Chamber (30~1000MHz) FRONT VIEW OF RADIATED MEASUREMENT BACK VIEW OF RADIATED MEASUREMENT FCC ID.PJ9TX21 Page 20 of 21 Audix Corporation Report No.: EM-F950258 7.2. Photos of Radiated Measurement at Semi-Anechoic Chamber (1~5.5GHz) FRONT VIEW OF RADIATED MEASUREMENT BACK VIEW OF RADIATED MEASUREMENT FCC ID.PJ9TX21 Page 21 of 21 Audix Corporation Report No.: EM-F950258 7.3. Photos of Bandwidth Measurement 7.4. Photos of Periodic Operated Measurement