PSF-0701HS002Wireless Remote Control

Receiver – As indicated on Figure 3, the dipswitches are located behind the battery slots. You need to remove the batteries before you can perform the dipswitch setting. A switch is ON when dipswitch is on up position, and OFF when dipswitch is down. Numbers start from right to left. Figure 3 Transmitter - As shown on Figure 4 the dipswitches are located behind the battery door. The dipswitch module looks different compared to the one inside the Receiver, but make sure numbers are also going from right to left. Flipping the switch towards you is ON, and flipping it away from you is OFF. Figure 4 Regulatory information The user is cautioned that changes or modifications not expressly approved by the party responsible for regulatory compliance could void the user’s authority to operate the equipment. Model No. HS-002-1 Handy-Switch OWNER’S MANUAL Please read before using this equipment Expand Your Wireless Need OpenZone, Inc. www.openzone2000.com  2001 OpenZone Incorporated. All Rights Reserved. One-Year Limited Warranty This is a “Limited Warranty” as defined in the U.S. Consumer Product Warranty and Federal Trade Commission Improvement Act. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. OpenZone, Inc. warrants this product, to original purchaser, for one year from purchase date to be free of defects in material and workmanship. Defective product may be sent (freight prepaid) to the company’s Customer Service Department for free repair or replacement at our option. This warranty covers only OpenZone assembled products and is not extended to other equipment and components that a customer uses in conjunction with our products. Your remedy does not include: cost of inconvenience, damage due to product failure, transportation damages, misuse, abuse, accident or the like, or commercial use. IN NO EVENT SHALL OPENZONE BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.

FEATURES: • Transmission range of up to 300 feet. • 256 selectable codes to prevent conflicts with other wireless devices. • Signal passes through doors and walls. • Expand your wireless need. Controls up to 2 separate DC operated devices. PUSH BUTTON TRANSMITTER: • Powered by 12-volt alkaline battery-type MN21 or A23 (included). • 2 control options: v Turn device on and off with the press of one button, OR v Keep device with the press of one button until another button is pressed to turn off. • LED lights indicate remote receiver On or Off RECEIVER: • Powered by 4 AAA size alkaline batteries (not included). • Low battery light indicator. • 2 terminals to connect 2 separate DC devices. • Easy insertion of wires without tools. (wires included) FCC Certified This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. One Year Warranty Openzone, Inc., California, USA www.openzone2000.com Model # HS-002-1 Made in China Manufactured in China exclusively for OpenZone, Inc.

Marianne Bosley From:Alice Wong [[email protected]] Sent:Friday, September 07, 2001 6:44 AM To:Marianne Bosley Cc:EED - Choy, Kitty Subject:Re: Openzone FCC ID:PSF-0701HS002 Hi Marianne, For question 1: The handy switch wireless remote control is incorrect statement in the manual, This two button is different command only. (i.e.: switch on and off on send different code.) No need press another button for stop the transmission. So we would correction the manual. (see attached file for manual & letter of agent authorization) Thanks. Best Regards Alice ----- Original Message ----- From: "Marianne Bosley" <[email protected]> To: <[email protected]> Cc: "Marianne Bosley" <[email protected]> Sent: Thursday, August 30, 2001 12:01 PM Subject: Openzone FCC ID:PSF-0701HS002 > Hi Alice, > > The technical review of this application has been completed. Below is the > issue that needs to be completed. Please answer and respond so that we may > Grant the device. Also, you were questioning our confidential procedure for > this one. Did you decide that the applicant did not want anything held > confidential? > > > 1. In the User's Manual there is a statement that the EUT may be kept "on > continuously with the press of one button until another button is pressed to > turn off." This is contradicted by a statement on page 21 of 22 in the test > report which claims that the EUT complies with the provision of Section > 15.231(a)(1) that requires that transmission cease within 5 seconds of the > button being released. Is the statement in the Manual incorrect? If so, it > should be removed from the Manual. Please respond. > > Marianne user manual1.PDFuser manual.PDFletter.PDF

FCC ID: PSF-0701HS002 PHOTOGRAPH OF THE PRODUCT FRONT VIEW OF THE PRODUCT REAR VIEW OF THE PRODUCT

FCC ID: PSF-0701HS002 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC ID: PSF-0701HS002 LABEL LOCATION BOTTOM VIEW OF THE DEVICE WITH FCC ID LABEL

FCC ID: PSF-0701HS002 PHOTOGRAPH OF THE PRODUCT INNER CIRCUIT TOP VIEW INNER CIRCUIT BOTTOM VIEW

FCC ID: PSF-0701HS002 Circuit Description The 433.92MHz crystal oscillator drives the base of Q2 the final/buffer amplifier. The modulation provided by U1(PT2262-S). The output of Q2 has the matching network consisting of L1 and C5 that limit the harmonic content and effect the proper coupling of the antenna to the output stage. Antenna, Ground and Power Source There is no external antenna. There is no external ground connection. The ground is only that of the printed circuit board. Electric current is supplied by a 12 Volt (“A23, VR22, EL12”) primary storage cell.

Date: 2001-07-16 TEST REPORT Page 1 of 22 No.: HM105443 FCC PART 15 SUBPART C CERTIFICATION REPORT FOR LOW POWER TRANSMITTER TEST REPORT No.:HM105443 Equipment Under Test [EUT]:Handy Switch Model Number:HS-002T Applicant:Openzone FCC ID :PSF-0701HS002 Date: 2001-07-16 TEST REPORT Page 2 of 22 No.: HM105443 CONTENT: Cover Page 1 of 22 Content Page 2-3 of 22 Conclusion Page 4 of 22 1.0General Details 1.1Test Laboratory Page 5 of 22 1.2Applicant Details Page 5 of 22 Applicant HKSTC Code Number for Applicant Manufacturer 1.3Equipment Under Test [EUT] Page 6 of 22 Description of EUT operation 1.4Date of Order Page 6 of 22 1.5Submitted Sample Page 6 of 22 1.6Test Duration Page 6 of 22 1.7Country of Origin Page 6 of 22 1.8 Additional Information of EUT Page 7 of 22 2.0Technical Details 2.1Investigations Requested Page 8 of 22 2.2Test Standards and Results Summary Page 8 of 24 3.0Test Results 3.1Emission Page 9-14 of 22 3.2Bandwidth Measurement Page 15-16 of 22 Date: 2001-07-16 TEST REPORT Page 3 of 22 No.: HM105443 Appendix A List of Measurement Equipment Page 17 of 22 Appendix B Duty Cycle Correction During 100 msec Page 18-19 of 22 Appendix C Periodic Operation Page 20 of 22 Appendix D Photographs Page 21-22 of 22 Date: 2001-07-16 TEST REPORT Page 4 of 22 No.: HM105443 CONCLUSION The submitted product was deemed to have COMPLIED with the requirements of Federal Communications Commission [FCC] Rules and Regulations Part 15. The tests were performed in accordance with the standards described above and on Section 2.2 in this Test Report. Law Man KitPatrick Wong Verify byPatrick Wong for Managing Director Date: 2001-07-16 TEST REPORT Page 5 of 22 No.: HM105443 1.0General Details 1.1Test Laboratory The Hong Kong Standards and Testing Centre Ltd. EMC Laboratory 10 Dai Wang Street, Taipo Industrial Estate New Territories, Hong Kong Telephone:852 2666 1888 Fax:852 2664 4353 1.2Applicant Details Applicant OPENZONE 1956 Avenida Monte Vista, San Dimas, CA91773 Telephone:0011 626 573 9710 Fax:0011 626 332 7369 HKSTC Code Number for ApplicantOPE001 Manufacturer EVERTOP OVERSEAS (ASIA) LIMITED. Rm. 13, 8/F., Yale Industrial Centre, 61-63 Au Pui Wan St., Fo Tan, Shatin, Hong Kong. Telephone:852 2763 6488 Fax:852 2322 6819 Date: 2001-07-16 TEST REPORT Page 6 of 22 No.: HM105443 1.3Equipment Under Test [EUT] Description of Sample Product:Handy Switch Manufacturer:Evertop Overseas (Asia) Ltd. Brand Name:N/A Model Number:HS-002T Input Voltage:12Vd.c. 1.3.1Description of EUT Operation The Equipment Under Test (EUT) is an Openzone, 433.6MHz RF wireless remote control. The EUT is to transmit RF signal while each button is be pressed Modulation by Data Code. Tape is pulses modulation. 1.4Date of Order 2000-08-26 1.5Submitted Sample(s): 7 Samples per model 1.6Test Duration 2001-07-13 1.7Country of Origin China Date: 2001-07-16 TEST REPORT Page 7 of 22 No.: HM105443 1.8Additional Information of EUT SubmittedNot Available User Manual Part List Circuit Diagram Printed Circuit Board [PCB] Layout Rating Label Block diagram FCC ID Label Date: 2001-07-16 TEST REPORT Page 8 of 22 No.: HM105443 2.0Technical Details 2.1Investigations Requested Perform ElectroMagnetic Interference measurement in accordance with FCC 47CFR [Codes of Federal Regulations] Part 15 and ANSI C63.4:1992 for FCC Certification. 2.2Test Standards and Results Summary Tables EMISSION Results Summary Test ConditionTest RequirementTest MethodClass /Test Result SeverityPassFailedN/A Field Strength of Fundamental Emissions & Spurious Emissions FCC 47CFR 15.231aANSI C63.4:1992N/A Radiated Emissions, 30MHz to 1GHz FCC 47CFR 15.209ANSI C63.4:1992Class B Conducted Emissions on AC, 0.45MHz to 30MHz FCC 47CFR 15.207ANSI C63.4:1992Class B Note: N/A - Not Applicable Date: 2001-07-16 TEST REPORT Page 9 of 22 No.: HM105443 3.0Test Results 3.1Emission 3.1.1Radiated Emissions Test Requirement:FCC 47CFR 15.231a Test Method:ANSI C63.4:1992 Test Date:2001-07-13 Mode of Operation:On mode Test Method: The sample was placed 0.8m above the ground plane on the OATS *. Measurements in both horizontal and vertical polarities were performed. During the test, each emission was maximized by: having the EUT continuously working, investigate all operating modes, rotated about all 3 axis (X, Y & Z) to obtain worst position, manipulating interconnecting cables, rotating turntable, varying antenna height from 1m to 4m in both horizontal and vertical polarizations. The emissions worst-case are shown in Test Results of the following pages. *:OATS [Open Area Test Site] located at HKSTC with a metal ground plane on filed with the FCC pursuant to section 2.948 of the FCC rules, with Registration Number: 90657. Test Setup: EUT distance = 3m Pre -Amplifier Receiver Computer Turn-table Ground Plane Date: 2001-07-16 TEST REPORT Page 10 of 22 No.: HM105443 Limits for Field Strength of Fundamental Emissions [FCC 47CFR 15.231a]: Frequency Range of Fundamental Field Strength of Fundamental Emissions Field Strength of Spurious Emissions [MHz][μV/m][μV/m] 40.66-40.701,000100 70-13050050 130-174500 to 1,500 *50 to 150 * 174-2601,500150 260-4701,500 to 5,000 *150 to 500 * Above 4705,000500 ** Linear interpolations Where F is the frequency in MHz, the formula for calculating the maximum permitted fundamental field strengths are as follows: for the band 130-174 MHz, μV/m at meters=56.81818(F)-6136.3636; for the band 260-470 MHz, μV/m at 3 meters =41.6667(F)-7083.3333. The maximum permissible unwanted emission level is 20dB below the maximum fundamental level. Results: Field Strength of Fundamental Emissions Peak Value FrequencyLevel @3mCorrection Factor Field Strength Field Strength Limit ** @3m Antenna Polarity MHzdBμVdB/mdBμV/mμV/mμV/m 433.661.921.783.615,135.6109,833.4Horizontal Field Strength of Spurious Emissions Peak Value FrequencyLevel @3m Correction Factor Field Strength Field Strength Limit @3m Antenna Polarity MHzdBμVdB/mdBμV/mμV/mμV/m 867.229.435.264.61698.210983.3Horizontal +1300.820.435.155.559…

Text truncated - open the document above for the full version.

FCC ID: PSF-0701HS-002 Limits for 20 dB Bandwidth of Fundamental Emission: Frequency Range20dB BandwidthFCC Limits * [MHz][KHz][KHz] 433.6150.01084 Remarks: *:FCC Limit for Bandwidth measurement= (0.25%)(Center Frequency) =(0.0025)(433.6) =1084KHz Results: The following figure is the measured bandwidth of Fundamental Emission. 20dB Bandwidth of Fundamental Emission

FCC ID: PSF-0701HS002 TEST SET UP PHOTOGRAPH OF THE PRODUCT MEASUREMENT OF RADIATED EMISSION TEST SET UP