QTC3001-1001Hand-Held Security Detector

FCC ID QTC3001-1001 Page 1 of 5 Usre Manual for QTC3001-1001 FCC ID QTC3001-1001 Page 2 of 5 FCC ID QTC3001-1001 Page 3 of 5 FCC ID QTC3001-1001 Page 4 of 5 Body Scanning Procedure FCC ID QTC3001-1001 Page 5 of 5

FCC ID: QTC3001-1001 BLOCK DIAGRAM

Page 1 of 2 FCC ID QTC3001-1001 The External photos for QTC3001-1001 The front side of model GC 1001 The back side of model GC 1001 Page 2 of 2 FCC ID QTC3001-1001 The front side of model MD 3001 The back side of model MD 3001

Page 1of 1 FCC ID QTC3001-1001 FCC ID Label for QTC3001-1001 FCC ID: QTC3001-1001 Label location

Page 1 of 2 FCC ID QTC3001-1001 The internal photos for QTC3001-1001 Cover Removed Components side Page 2 of 2 FCC ID QTC3001-1001 Soldered side

Report no: JSH02*1930-002 Page 1 of 11 FCC ID QTC3001-1001 Application for FCC Identifier On Behalf of Shanghai 21st Century Electronic Equipment Co., Ltd. (FCC ID QTC3001-1001) Summary The equipment comply with the requirements according to the following standard(s): 47CFR Part 15: Radio Frequency Device ANSI C63.4 (2000): Interim Standard for Methods of Measurement of Radio-Noise Emissions from Low-Voltage Electrical and Electronic Equipment in the Range of 9kHz to 40GHz. Description The appliances were tested by Shanghai Institute of Process Automation Instr. and found compliance with relevant requirements described in FCC Part 15 Radio frequency Device. Test results are contained in this test report and Intertek Testing Services ETL SEMKO Shanghai Limited is assumed full responsibility for the accuracy and completeness of these measurements. The test report applies to tested samples only and shall not be reproduced in part without written approval of Intertek Testing Services ETL SEMKO Shanghai Limited. Date of Test: January 28, 2003 Date of Issue: January 29, 2003 Prepared by: Report Approved by: Tino Pan (Engineer)Ole Stiling (Chief Engineer) Report no: JSH02*1930-002 Page 2 of 11 FCC ID QTC3001-1001 Description of Test Facility Name of Firm:Shanghai Institute of Process Automation Instr. Site Location:103 Cao Bao Road, Shanghai 200233, China Name of contact :Miss. Ying (first name) Wang (last name) Phone:86-21-64368180 ext. 574 Fax: 86-21-64847454 E-mail address:[email protected] FCC Registration number: 96504 Report no: JSH02*1930-002 Page 3 of 11 FCC ID QTC3001-1001 CONTENTS Summary..............................................................................................................................1 Description...........................................................................................................................1 Description of Test Facility...................................................................................................2 1.Applicant Information.......................................................................................................4 2.Information of Equipment Under Test (EUT)....................................................................4 2.1 Identification of the EUT...............................................................................................4 2.2 Additional information about the EUT...........................................................................5 3. Radiated emission measurement.......................................................................................6 3.1 Radiated emission limit.................................................................................................6 3.2 Instruments list.............................................................................................................6 3.3 Test setup.....................................................................................................................6 3.4 Test configuration.........................................................................................................7 3.5 Test procedure..............................................................................................................7 3.6 Test Results..................................................................................................................8 3.7 Measurement Uncertainty...........................................................................................10 4. Sample field strength calculation.....................................................................................11 Report no: JSH02*1930-002 Page 4 of 11 FCC ID QTC3001-1001 1.Applicant Information FCC ID holder :For models GC-1001 and MD-3001 Shanghai 21st Century Electronic Equipment Co., Ltd. 19 A Zhong You Bld., No.1040 Cao Yang Rd. Shanghai, P.R. China. Manufacturer: Shanghai 21st Century Electronic Equiopment Co., Ltd. 19 A Zhong You Bld., No.1040 Cao Yang Rd. Shanghai, P.R. China. Difference between models:There are two models mentioned in this test report which are the same in electronic diagrams, and the difference between them are the appearances of them and their trade mark. Therefore, the model GC 1001 was chosen as representative and data is listed in this test report. Country of origin: P.R. China Name of contact: Mr. Mingyue (first name) Cao (last name) Telephone: 86-21-64567422 Telefax: 86-21-62167677 2.Information of Equipment Under Test (EUT) 2.1 Identification of the EUT Equipment: Hand-Held Security Detector Type of EUT: ̨ Production ® Pre-product ® Pro-type Type/model: GC-1001, MD-3001 Serial number: 02*1930-001, 02*1930-002 Date of sample receipt2003-01-28 Date of test2003-01-28 Rating: DC 9V*1 Report no: JSH02*1930-002 Page 5 of 11 FCC ID QTC3001-1001 2.2 Additional information about the EUT Frequency range : 52KHz FCC Rule part(s):Part 15 subpart C section 15.209 Test procedure:ANSI C63.4 – 2000 FCC classification:Part15 Low Power Transmitter below 1705kHz (DCD) Power consumption:DC 9V*1 2.3 Peripheral equipment Name BrandModel Number FCC IDSerial Number Earphone SONYMDR-W14NoneNone Report no: JSH02*1930-002 Page 6 of 11 FCC ID QTC3001-1001 3. Radiated emission measurement 3.1 Radiated emission limit Frequency of emission (MHz) Field strength (mircovolts/meter) Measurement Distance (meter) Field strength measured at 3m distance (dBuV/m) 0.009-0.4902400/F(kHz)300128.52-93.8* 0.490-1.70524000/F(kHz)3073.8-62.97* 1.705-30.0303039.54 30-88100340 88-216150343.52 216-960200346.02 Above 960500353.98 Radiated emission in dBuv/m = 20lg ( mircovolts/meter) At frequencies below 30MHz, the limit shall be extrapolated to the specified distance by using the square of an inverse linear distance extrapolation factor (40dB/decade). At frequencies at or above 30MHz, the limit shall be extrapolated to the specified distance by using an extrapolation factor of 20 dB/decade (inverse linear distance for field strength measuremen…

Text truncated - open the document above for the full version.

Page 1 of 7 FCC ID QTC3001-1001 Emission Waveforms Orthogonal axe: X, Antenna Polarization: Horizontal Page 2 of 7 FCC ID QTC3001-1001 Orthogonal axe: Y, Antenna Polarization: Horizontal Page 3 of 7 FCC ID QTC3001-1001 Orthogonal axe: Z, Antenna Polarization: Horizontal Page 4 of 7 FCC ID QTC3001-1001 Orthogonal axe: X, Antenna Polarization: Vertical Page 5 of 7 FCC ID QTC3001-1001 Orthogonal axe: Y, Antenna Polarization: Vertical Page 6 of 7 FCC ID QTC3001-1001 Orthogonal axe: Z, Antenna Polarization: Vertical Page 7 of 7 FCC ID QTC3001-1001 Band width waveform

Page 1 of 3 FCC ID QTC3001-1001 The test setup Radiated Emission Page 2 of 3 FCC ID QTC3001-1001 Page 3 of 3 FCC ID QTC3001-1001