QU9-INFOWAY-L3800InfoWay Note L3800

1 Product Name:Notebook PC Hardware Manual Revision:1.00 E1021 Release Date:May 2002 Notebook PC Hardware User’s Manual 2 Warranty Information Product Warranty Registration Register your product to activate warranty coverage. Visit http://www.asus.com.tw/register/register.htm ASUS e-Member Enter your login information and click Login Non-ASUS e-Member Click ! register now 1. Warranty will be void if the Notebook PC has been mishandled, misused, willfully damaged, neglected, altered, or defaced in any way. 2. Warranty will be void if the manufacturer’s labels or bar codes have been altered, obscured, or removed. 3. The natural degradation of the battery pack over time is excluded from warranty. 4. You are responsible for backing up all data stored in any storage devices before sending your Notebook PC for service. Repair centers will not be liable for any data loss during the service. e-Magazine http://www.asusemag.com.tw/ Technical Reference Guides http://www.asus.com.tw/inside/TechnicalReference.htm NETQ Discussion Forum http://www.asusnetq.com.tw Software Download http://download.asus.com.tw Global Service Member http://usa.asus.com/inside/gsm.htm ASUS Homepage http://www.asus.com.tw ASUS Registration http://www.asus.com.tw/register/register.htm Reseller Square http://reseller.asus.com.tw Evaluate ASUS http://www.asus.com.tw/evaluate.htm ASUS 24 Hour Online Technical Support About Your Notebook PC’s Warranty 3 Safety Statements Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office of the Federal Register, National Archives and Records Administration, U.S. Government Printing Office. Canadian Department of Communications Statement This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. This Class B digital apparatus complies with Canadian ICES-003. (Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.) For use with AC Adaptor Model (Pour Utiliser Avec Modele) ADP-45GB (45W), ADP-50GB (50W), PA-1530 (50W), or ADP-60DH (60W) Power Safety Requirement Products with electrical current ratings up to 6A and weighing more than 3Kg must use approved power cords greater than or equal to: H05VV-F, 3G, 0.75mm 2 or H05VV-F, 2G, 0.75mm 2 . WARNING! The use of a shielded-type power cord is required in order to meet FCC emission limits and to prevent interference to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. 4 Safety Statements Nordic Cautions (for Notebook PC with Lithium-Ion Battery) (Japanese) Macrovision Corporation Product Notice This product incorporates copyright protection technology that is protected by method claims of certain U.S.A. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited. CDRH Regulations The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for laser products on August 2, 1976. These regulations apply to laser products manufactured from August 1, 1976. Compliance is mandatory for products marketed in the United States. ATTENZIONE! Rischio di esplosione della batteria se sostituita in modo errato. Sostituire la batteria con un una di tipo uguale o equivalente consigliata dalla fabbrica. Non disperdere le batterie nell’ambiente. (Italian) VORSICHT! Explosionsgetahr bei unsachgemäßen Austausch der Batterie. Ersatz nur durch denselben oder einem vom Hersteller empfohlenem ähnlichen Typ. Entsorgung gebrauchter Batterien nach Angaben des Herstellers. (German) ADVARSELI! Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage til leverandøren. (Danish) VARNING! Explosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instrukt…

Text truncated - open the document above for the full version.

4. System- Main components block diagrams

Item No.Device TypeFrequencyQ’tyVenderLocations 1Clock Generator --1ICS (ICS94239CG)U22 2Crystal14.318MHz1OSTX2 3Crystal25MHZ1TXCX1 4Crystal32.768KHZ1EPSONX4 5RESONATOR8MHZ1MATSUSHITAX3 6RESONATOR4MHZ1MURATAX5 7Crystal24.576MHZ2FUJICONX6, Y1 8Oscillator27MHZ1TXCOSC1

ITAUTEC PHILCO S.A. Rua Santa Catarina,1 - 03086-025 Sao Paulo, SP - Brazil January 13, 2003 InfoWay Note L3800 External Photos Above: Top panel View when the notebook is closed. Left: Company Logo Sticker in detail Bellow: Back connectors and ports view. Above: Notebook's bottom base view. Bellow: External Power Adaptor. Sincerely, Pedro Echeverria Engineer. 305-594-2235 (Miami,FL-USA)

ITAUTEC PHILCO S.A. Rua Santa Catarina,1 - 03086-025 Sao Paulo, SP - Brazil January 13, 2003 FCC ID Sample Label This is a sample of the FCC ID Label. FCC ID: XXX-INFOWAY-NL3800 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Complies with Part 68 of the FCC Rules. FCC REG # 60HTAI-35453-M5-E Sincerely, Pedro Echeverria Engineer. 305-594-2235 (Miami,FL-USA) FCC ID: QU9-INFOWAY-L3800 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Complies with Part 68 of the FCC Rules. FCC REG # 60HTAI-35453-M5-E

ITAUTEC PHILCO S.A. Rua Santa Catarina,1 - 03086-025 Sao Paulo, SP - Brazil January 13, 2003 FCC ID Label location Information The FCC ID Label will be located on the bottom base of the Laptop, in the upper-right corner. The picture bellow is a bottom view of the Laptop, ant the red arrow shows its location. FCC ID LABEL Sincerely, Pedro Echeverria Engineer. 305-594-2235 (Miami,FL-USA)

Motherboard – Upper View Motherboard – Bottom View Fax Modem Upper View Fax Modem – Bottom View Floppy Drive – Upper View Hard Drive Upper View Hard Drive – Bottom View CD ROM Upper View CD ROM – Bottom View Display – Upper View Display - Bottom View Keyboard - Upper View Keyboard - Bottom View Memory - Upper View Memory - Bottom View

,167,7872'(3(648,6$6(/'25$'2 'HSDUWDPHQWRGH6HUYLoRV7HFQROyJLFRV Laboratório de Compatibilidade Eletromagnética + (55) 19 – 3757-3137 Fax: + (55) 19 – 3757-3131 Rod. SP-340, Km 118,5 Condomínio Pólis - Prédio 11 CEP: 13086-902 Campinas - SP Brasil ,3(5(,7$8'0DU )&&7(675(3257 IRU )&&3$57&/$66%    127(%22.,1)2:$<127(/   ITAUTEC PHILCO S/A - GRUPO ITAUTEC PHILCO Rua Santa Catarina, 01 - Tatuapé CEP 03086-025 - São Paulo – SP – Brazil      )&&7(675(3257 )&&3DUW&ODVV% 1RWHERRN,QIRZD\1RWH/ ,3(5(,7$8'0DU 6XPPDU\  &HUWLILFDWLRQ  *HQHUDOGHVFULSWLRQRIHTXLSPHQWXQGHUWHVW 2.1. Applicant ...........................................................................................................................................4 2.2. Manufacturer .....................................................................................................................................4 2.3. Basic description of equipment under test .......................................................................................4 2.4. Technical features of equipment under test .....................................................................................4 7HVWFRQILJXUDWLRQRIHTXLSPHQWXQGHUWHVW 3.1. Test manner ......................................................................................................................................5 3.2. Test system description ....................................................................................................................5 3.3. Test setup connection diagram ........................................................................................................8 3.4. Test software.....................................................................................................................................9 7HVWJHQHUDOLQIRUPDWLRQ 4.1. Test facility ........................................................................................................................................9 4.2. Standard measurement methods .....................................................................................................9 4.3. Test in compliance with ....................................................................................................................9 4.4. Investigated frequency range .........................................................................................................10 4.5. Test distance...................................................................................................................................10 &RQGXFWHGSRZHUOLQHWHVW 5.1. Major measuring instruments .........................................................................................................10 5.2. Test procedures ..............................................................................................................................10 5.3. AC powerline conducted emission test results...............................................................................11 5.4. Photographs of AC powerline conducted test configuration ..........................................................12 5DGLDWHGHPLVVLRQWHVW 6.1. Major measuring instruments .........................................................................................................14 6.1.1. from 30MHz to 1GHz....................................................................................................................14 6.1.2. from 1GHz to 8,5 GHz..................................................................................................................14 6.2. Test procedures ..............................................................................................................................14 6.3. Radiated emission test results........................................................................................................15 6.3.1. from 30MHz to 1000MHz .............................................................................................................15 6.3.2. from 1GHz to 8,5GHz...................................................................................................................16 6.4. Photographs of radiated emission test configuration .....................................................................17 0HDVXULQJHTXLSPHQWXVHGOLVW )&&7(675(3257 )&&3DUW&ODVV% 1RWHERRN,QIRZD\1RWH/ ,3(5(,7$8'0DU  &(57,),&$7,21 The electromagnetic interference tests which this report describes were conducted by an independent electromagnetic compatibility laboratory, in accordance with the test procedure specified in ANSI C63.4- 1992 , CFR 47 Part 15 Subpart B and CISPR 22 Class B. The test results contained in this report accurately represent the radiated, and power line conducted electromagnetic emissions generated by sample equipment under test at the time of the test. (TXLSPHQW7HVWHG Notebook Model: Infoway Note L3800 Applied by Itautec Philco S/A. 6DPSOHUHFHLYHG'DWHJan. 15, 2003 )LQDOWHVW'DWH: Feb. 25, 2003 7HVW(QJLQHHr: Wagner Benetti The results show that the sample equipment tested as described in this report is in compliance with CISPR 22 Class B for conducted emission limits and…

Text truncated - open the document above for the full version.

)&&7(675(3257 )&&3DUW&ODVV% 1RWHERRN,QIRZD\1RWH/ ,3(5(,7$8'0DU 3KRWRJUDSKVRI$&SRZHUOLQHFRQGXFWHGWHVWFRQILJXUDWLRQ  The photographs show the configuration used to generate maximum emission. Fig. 2 – Front view of the Conducted EMI Test Setup * The position of the mouse was such as to produce the higher conducted emission. )&&7(675(3257 )&&3DUW&ODVV% 1RWHERRN,QIRZD\1RWH/ ,3(5(,7$8'0DU Fig. 3 – Side view of the Conducted EMI Test Setup

)&&7(675(3257 )&&3DUW&ODVV% 1RWHERRN,QIRZD\1RWH/ ,3(5(,7$8'0DU 3KRWRJUDSKVRIUDGLDWHGHPLVVLRQWHVWFRQILJXUDWLRQ  The photographs show the configuration that generated the maximum emission. Fig. 4 – Rear view of the Radiated EMI Test Setup )&&7(675(3257 )&&3DUW&ODVV% 1RWHERRN,QIRZD\1RWH/ ,3(5(,7$8'0DU Fig. 5 – Front view of the Radiated EMI Test Setup