R4Z-326BWIRELESS OUTDOOR LANTERN + SPEAKER

FEATURES & CONTROLS Wireless Outdoor Lantern + Speaker User’s Guide for Model ISBW326B Important Safety Instructions • Read these Instructions. • Keep these Instructions. • Heed all Warnings. • Follow all instructions. • Clean only with a dry cloth. • Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. • Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. • Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. • Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. • Only use attachments/accessories specified by the manufacturer. • Unplug this apparatus during lightning storms or when unused for long periods of time. • Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, does not operate normally, or has been dropped. • Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/ apparatus combination to avoid injury from tip-over. FCC Warnings Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Additional Warnings and Precautions • Caution and marking information is located at the rear or bottom of the apparatus. Attention et de marquage des informations est situé sur le paneau arrière ou inférieur de l’unité. • Mains plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected form the mains socket outlet completely. La prise du secteur est utilisé pour déconnecter le système. La prise du secteur ne doit pas être obstruée ou doit être facilement accessible pendant son utilisation. Pour être complètement déconnecté de l’alimentation d’entrée, la prise doit être débranchée du secteur. • CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. AVIS: AFIN DE PRÉVENIR LES CHOCS ÉLÉCTRIQUES, FAITES CORRESPONDRE LA FICHE BLANCHE DE LA PRISE À LA FENTE LARGE, INSÉREZ TOTALEMENT. • CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure. AVIS: L’utilisation de commande ou l’exécution de procédures autres que celles spécifiées ici peuvent aboutir à une exposition à des radiations dangereuses. • WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. AVIS: Des changements ou des modifications sur ce produit non expressément approuvés par la partie responsable de la conformité peut annuler le droit de l’utilisateur d’utiliser cet équipement. • WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or sensitive finish. As with any rubber compound made with oils, the feet could cause marks or staining where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass between the unit and the surface to reduce the risk of damage and/or staining. AVIS: Ne placez pas cette unité directement sur des surfaces de meubles dont la finition serait douce, poreuse ou sensible. Car, comme tout composé caoutchouc a base d’huiles, les pieds pourraient laisser des tracs ou des taches à l’endroit ou ils sont posés. Nous recommandons d’utiliser une protection comme un linge ou un morceau de verre entre l’unité et la surface pour réduire le risque de dégât et/ou de tache. • WARNING: Lithium batteries, like all rechargeable batteries, are recyclable and should never be disposed of in normal household waste. Contact your local government for disposal or recycling practices in your area. They should never be incinerated since they might explode. AVIS: Les piles au lithium, comme toutes les piles rechargeables, sont recyclables et ne doit jamais être jeté dans les ordures ménagères. Communiquez avec votre gouvernement local pour élimination ou recyclage dans votre région. Ils ne doivent jamais être incinérés car ils pourraient exploser. • WARNING: Shock hazard - Do Not Open. AVIS: Risque de choc électrique - ne pas ouvrir • Battery shall not be expo…

Text truncated - open the document above for the full version.

Zhongshan Senjia Electrical Appliances Co., Ltd. No.35, Wenming Road, Nanqu, Zhongshan, Guangdong, China 2015-12-25 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Confidentiality Request regarding application for certification of FCC ID: R4Z-326B We hereby request confidential treatment of information accompanying this application as outlined below: - schematics - Block diagram - operational description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, (Signature) Sam Wong Executive Director Tel: +86-760-88896872 Fax: +86-760-88896865 E-mail: [email protected]

Zhongshan Senjia Electrical Appliances Co., Ltd. No.35, Wenming Road, Nanqu, Zhongshan, Guangdong, China Letter of Agency 2015-12-25 To whom it may concern, I, an officer of Zhongshan Senjia Electrical Appliances Co., Ltd. do hereby authorize Dongguan NTC Co., Ltd. (Mr. Jees Hong) to act on our behalf in front of the Federal Communications Commission with respect to all matters relating to certification of equipment under Part 15 and/or Part 74 of the FCC Rules until further notice. I further certify that no party (as defined in §1.2002(b) of CFR 47.2007) to this application, including myself, is subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988. 21 U.S.C., 862. Sincerely, (Signature) Sam Wong Executive Director Tel: +86-760-88896872 Fax: +86-760-88896865 E-mail: [email protected]

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B External photo Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Internal photo Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B RF Chip RF Antenna Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Page 2 of 56 Table of Contents 1. GENERAL INFORMATION ................................................................................................ 5 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST.................................................................... 5 1.2 RELATED SUBMITTAL(S) / GRANT (S)................................................................................................ 5 1.3 TEST METHODOLOGY...................................................................................................................... 7 1.4 EQUIPMENT MODIFICATIONS............................................................................................................ 7 1.5 SUPPORT DEVICE............................................................................................................................ 7 1.6 TEST FACILITY AND LOCATION.......................................................................................................... 7 1.7 SUMMARY OF TEST RESULTS........................................................................................................... 7 2. SYSTEM TEST CONFIGURATION .................................................................................... 9 2.1 EUT CONFIGURATION...................................................................................................................... 9 2.2 SPECIAL ACCESSORIES.................................................................................................................... 9 2.3 DESCRIPTION OF TEST MODES......................................................................................................... 9 2.4 EUT EXERCISE................................................................................................................................9 3. CONDUCTED EMISSIONS TEST .................................................................................... 10 3.1 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 10 3.2 TEST CONDITION........................................................................................................................... 10 3.3 MEASUREMENT RESULTS............................................................................................................... 10 4. RADIATED EMISSION TEST........................................................................................... 13 4.1 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 13 4.2 MEASUREMENT PROCEDURE......................................................................................................... 14 4.3 LIMIT.............................................................................................................................................. 14 4.4 MEASUREMENT RESULTS ..................................................................................................... 15 5. CHANNEL SEPARATION TEST ...................................................................................... 19 5.1 MEASUREMENT PROCEDURE......................................................................................................... 19 5.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 19 5.3 MEASUREMENT RESULTS............................................................................................................... 19 6. 20DB BANDWIDTH.......................................................................................................... 25 6.1 MEASUREMENT PROCEDURE......................................................................................................... 25 6.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 25 6.3 MEASUREMENT RESULTS............................................................................................................... 25 7. HOPPING CHANNEL NUMBER ...................................................................................... 31 7.1 MEASUREMENT PROCEDURE......................................................................................................... 31 7.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 31 7.3 MEASUREMENT RESULTS............................................................................................................... 31 Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Page 3 of 56 8. TIME OF OCCUPANCY (DWELL TIME).......................................................................... 33 8.1 MEASUREMENT PROCEDURE......................................................................................................... 33 8.2 MEASUREMENT RESULTS............................................................................................................... 33 9. MAXIMUM PEAK OUTPUT POWER ............................................................................... 33 9.1 MEASUREMENT PROCEDURE......................................................................................................... 39 9.2 MEASUREMENT RESULTS............................................................................................................... 39 10. BAND EDGE ..................................................................................................................39 10.1 MEASUREMENT PROCEDURE....................................................................................................... 45 10.2 LIMIT............................................................................................................................................ 45 10.3 MEASUREMENT RESULTS............................................................................................................. 45 11. ANT…

Text truncated - open the document above for the full version.

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Test photo Radiated emission Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512011F FCC ID: R4Z-326B Conducted emission Ancillary equipment EUT