RE81300249RRC Toy

FCC ID: RE81300249R Ophoto1 Ophoto2 FCC ID: RE81300249R Ophoto3 Ophoto4 FCC ID: RE81300249R Ophoto5 Ophoto6

FCC ID: RE81300249R Iphoto1 Iphoto2 FCC ID: RE81300249R Iphoto3 Iphoto4 FCC ID: RE81300249R Iphoto5 Iphoto6 FCC ID: RE81300249R Iphoto7 Iphoto8 FCC ID: RE81300249R Iphoto9 Iphoto10 FCC ID: RE81300249R Iphoto11 Iphoto12 FCC ID: RE81300249R Iphoto13 Iphoto14 FCC ID: RE81300249R Iphoto15 Iphoto16 FCC ID: RE81300249R Iphoto17 Iphoto18 FCC ID: RE81300249R Iphoto19 Iphoto20

FCC ID: RE81300249R Iphoto21 Iphoto22 FCC ID: RE81300249R Iphoto23 Iphoto24 FCC ID: RE81300249R Iphoto25 Iphoto26 FCC ID: RE81300249R Iphoto27 Iphoto28 FCC ID: RE81300249R Iphoto29 Iphoto30 FCC ID: RE81300249R Iphoto31 Iphoto32 FCC ID: RE81300249R Iphoto33 Iphoto34 FCC ID: RE81300249R Iphoto35 Iphoto36 FCC ID: RE81300249R Iphoto37

FCC ID: RE81300249R Technical Description : The brief circuit description is listed as follows : - U1 MF-R1B and associated circuit act as Super-regenerative receiver (49.860 MHz), amplifier and decoder. - U2 W588S003 and associated circuit act as Micro Controller. - IR, Q18, Q39 and associated circuit act as IR TX and RX (control for launch the aircraft). - D1, Q38 and associated circuit act as Voltage Regulator. - Q1 ~ Q7, Q16 and associated circuit act as Motor driver for Left propeller. - Q8 ~ Q15 and associated circuit act as Motor driver for Right propeller. - Q21 ~ Q22, Q32 ~ Q37 and associated circuit act as Motor driver for launch Motor. - Q19 ~ Q20 and associated circuit act as Motor driver for Helicopter rotate Motor. - Q23, Q24 and associated circuit act as Motor driver for Motor (Helicopter Return to deck). - Q25 ~ Q31 and associated circuit act as Motor driver for Motor (Helicopter up & down). Antenna Used : An Integral antenna has been used.

• The test results reported in this report shall refer only to the sample actually tested and shall not refer or be deemed to refer to bulk from which such a sample may be said to have been obtained. • This report shall not be reproduced except in full without prior authorization from Intertek Testing Services Hong Kong Limited • The evaluation data of the report will be kept for 3 years from the date of issuance. FCC ID : RE81300249R Fun Maker Limited Application For Certification (FCC ID: RE81300249R) Superregenerative Receiver Sample Description : Radio Control Aircraft Carrier Model : 13002 0516387 BC/at August 30, 2005 INTERTEK TESTING SERVICES FCC ID: RE81300249R i LIST OF EXHIBITS INTRODUCTION EXHIBIT 1: General Description EXHIBIT 2: System Test Configuration EXHIBIT 3: Emission Results EXHIBIT 4: Equipment Photographs EXHIBIT 5: Product Labelling EXHIBIT 6: Technical Specifications EXHIBIT 7: Instruction Manual EXHIBIT 8: Miscellaneous Information INTERTEK TESTING SERVICES FCC ID: RE81300249R ii MEASUREMENT/TECHNICAL REPORT Fun Maker Limited - MODEL: 13002 FCC ID: RE81300249R August 30, 2005 This report concerns (check one:) Original Grant X Class II Change Equipment Type: Superregenerative Receiver (example: computer, printer, modem, etc.) Deferred grant requested per 47 CFR 0.457(d)(1)(ii)? Yes No X If yes, defer until: date Company Name agrees to notify the Commission by: date of the intended date of announcement of the product so that the grant can be issued on that date. Transition Rules Request per 15.37? Yes No X If no, assumed Part 15, Subpart B for intentional radiator Report prepared by: Billy Chow Intertek Testing Services 2/F., Garment Center, 576, Castle Peak Road, HONG KONG Phone: 852-2173-8502 Fax: 852-2742-9149 INTERTEK TESTING SERVICES FCC ID: RE81300249R iii Table of Contents 1.0 General Description..................................................................................................2 1.1 Product Description...............................................................................................2 1.2 Related Submittal(s) Grants..................................................................................2 1.3 Test Methodology..................................................................................................3 1.4 Test Facility...........................................................................................................3 2.0 System Test Configuration ......................................................................................5 2.1 Justification...........................................................................................................5 2.2 EUT Exercising Software.......................................................................................5 2.3 Support Equipment List and Description................................................................5 2.4 Equipment Modification.........................................................................................6 2.5 Special Accessories..............................................................................................6 3.0 Emission Results......................................................................................................8 3.1 Field Strength Calculation......................................................................................9 3.2 Radiated Emission Configuration Photograph......................................................10 3.3 Radiated Emission Data......................................................................................11 4.0 Equipment Photographs ........................................................................................14 5.0 Product Labelling...................................................................................................16 6.0 Technical Specifications ........................................................................................18 7.0 Instruction Manual..................................................................................................20 8.0 Miscellaneous Information.....................................................................................22 8.1 Stabilization Waveform........................................................................................23 8.2 Emissions Test Procedures.................................................................................24 8.2 Emissions Test Procedures (cont'd).....................................................................25 INTERTEK TESTING SERVICES FCC ID: RE81300249R iv List of attached file Exhibit type File Description filename Test Report Test Report report.pdf Operation Description Technical Description descri.pdf Test Setup Photo Radiated Emission radiated photos.doc Test Report Stabilization Waveform superreg.pdf External Photo External Photo external photos.doc Internal Photo Internal Photo internal photos.doc Block Diagram Block Diagram block.pdf Schematics Circuit Diagram circuit.pdf ID Label/Location Label Artwork and Location label.pdf User Manual User Manual manual.pdf INTERTEK TESTING SERVICES FCC ID: RE81300249R 1 EXHIBIT 1 GENERAL DESCRIPTION INTERTEK TESTING SERVICES FCC ID: RE81300249R 3 1.3 Test Methodology The radiated emission measurements were performed according to the procedures in ANSI C63.4 (2003). All measurements were performed in Open Area Test Sites. Preliminary scans were performed in the Open Area Test Sites only to determine worst case modes. All Radiated tests were performed at an antenna to EUT distance of 3 meters, unless stated otherwise in the "Justification Section" of this Application. 1.4 Test Facility The open area test site and conducted measurement facility used to collect the emission data is located at Garment Centre, 576 Castle Peak Road, Kowloon, Hong Kong. This test facility and site measurement data have been fully placed on file with the FCC. INTERTEK TESTING SERVICES FCC ID: RE81300249R 4 EXHIBIT 2 SYS…

Text truncated - open the document above for the full version.

INTERTEK TESTING SERVICES Front View Back View