RIO-18-TR093-49-T1:18 Remote Control NASCAR Monte Carlo Series

ANT Function A control Function B control Function C control Function D control BAT TX Block Diagram Encoding Circuit Logic Timing Generator
    Latch Circuit RF AMP OSC 49.86 MHz Charge Circuit

Operation Description 1:18 Remote Control NASCAR Monte Carlo Version 49MHz The 1:18 Remote Control NASCAR Monte Carlo Version 49MHz RC Car is powered by 1 X 9V battery for Transmitter. There are two control sticks on the front side of body. When the forward or backward stick is pushed, it will transmit a radio frequency for receiver go forward or backward. When the left or right stick is pushed, it will transmit a radio frequency for receiver go left or right. Refer to the transmitter circuit design, the circuit description is listed as below:
 X1, Q2 and associate circuit act as oscillator.
Q1 and associate circuit act as RF Amp.
 R5 and associate circuit act as oscillator for PT8A977.
 PT8A977 and associate circuit act as encoder.

TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1302, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, N.T., Hong Kong. Tel : (852) 2698 8198 Fax : (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AE005949-1 Date : 2004 July 12 Applicant : Team Caliber, Inc. 4606 Roush Place, Concord North Caroline, 28027 United States Sample Description : One(1) submitted sample stated to be 1:18 Remote Control Nascar Monte Carlo series. Rating : 1 x 9 V battery No. of sample(s) : Two(2) sets *** Date Received : 2004 April 19. Test Period : 2004 April 19 – 2004 June 28. Test Requested : FCC Part 15 Certification Test Method : FCC Rules and Regulations Part 15 – Dec 2003 ANSI C63.4 – 2001 Test Result : See attached sheet(s) from page 2 to 11. Conclusion : The submitted sample was found to comply with requirement of FCC Part 15 Subpart C. Remark : All three models are the same in circuitry and components and construction; and therefore model 1:18 Remote Control Nascar Monte Carlo series was chosen to be the representative of the test sample. FOR AND ON BEHALF OF CMA Testing and Certification Laboratories Authorized Signature : Page 1 of 11 Danny Chui EMC Engineer - EL. Division FCC ID : RIO-18-TR093-49-T TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1302, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, N.T., Hong Kong. Tel : (852) 2698 8198 Fax : (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AE005949-1 Date : 2004 July 12 Table of Contents 1 General Information........................................................................................................................ 3 1.1 General Description.................................................................................................................. 3 1.2 Related Submittal Grants.......................................................................................................... 3 1.3 Location of the test site............................................................................................................. 4 1.4 List of measuring equipment..................................................................................................... 5 2 Description of the radiated emission test........................................................................................... 6 2.1 Test Procedure......................................................................................................................... 6 2.2 Test Result...............................................................................................................................6 2.3 Radiated Emission Measurement Data....................................................................................... 7 3 Description of the Line-conducted Test............................................................................................ 8 3.1 Test Procedure......................................................................................................................... 8 3.2 Test Result...............................................................................................................................8 3.3 Graph and Table of Conducted Emission Measurement Data....................................................... 8 4 Photograph..................................................................................................................................... 9 4.1 Photographs of the Test Setup for Radiated Emission and Conduction Emission........................... 9 4.2 Photographs of the External and Internal Configurations of the EUT........................................... 9 5 Supplementary document............................................................................................................... 10 5.1 Bandwidth............................................................................................................................. 10 6 Appendices...............................................................................................................................11 Page 2 of 11 FCC ID : RIO-18-TR093-49-T TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1302, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, N.T., Hong Kong. Tel : (852) 2698 8198 Fax : (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AE005949-1 Date : 2004 July 12 1 General Information 1.1 General Description The equipment under test (EUT) is a transmitter for 1:18 Remote Control Nascar Monte Carlo series operating at 49.860 MHz which is controlled by a crystal. The EUT is powered by 9 V battery. There are two control joystick in the front of EUT. When the forward or backward joystick pushed once, it will transmit a radio signal for receiver go forward or backward. When the left or right joystick pushed once, it will transmit a radio frequency for receiver turn left or right. The brief circuit description is listed as follows : - X1, Q2 and associated circuit act as oscillator - Q1 and associated circuit act as RF Amp. - R5 and associated circuit act as oscillator for PT8A977 - PT8A977 and associated circuit act as encoder The models 1:18 Remote Control Nascar Dodge series and 1:18 Remote Control Ford Taurus series, are the same model with 1:18 Remote Control Nascar Monte Carlo series in hardware aspect. The difference in model is the body of the car. 1.2 Related Submittal Grants This is a single application for certification of a transmitter. The receiver for this transmitter is authorized by Certification procedure. Page 3 of 11 FCC ID : RIO-18-TR093-49-T TEST REP…

Text truncated - open the document above for the full version.

CMA Testing and Certification Laboratories P. of Report No.: AE005949-1 Bandwidth Plot Bandwidth 1

CMA Testing and Certification Laboratories P. of Report No.: AE005949-1 Duty Cycle 1 CMA Testing and Certification Laboratories P. of Report No.: AE005949-1 Duty Cycle 2 Duty Cycle 3