
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
FCC ID Label Sample FCC ID: S3E-05FLT05169 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID Location
Transmitter Transistor Q2(9014), Q3(9014) and other components Frequency Oscillator, transmit to filter Y1 (315MHz) & transistor Q1 (2688) to enlarge the transmission range. When press on the button S1, the high frequency carrier wave transmit from antenna on transmitter. Then re-press on the button, is stop as no energy. Energy is supply with a 12-volt battery. Receiver Antenna is inductive received the RF signal from receiver, the carrier induce Coil L3 & demodulate circuit by Q1 (2688), L5 & C20. The signal output as R23, R19, R20 to amplifier IC1 (LM324) to enlarge the transmission range after detect, the output frequency through IC IC2 (JS4056) and to activate sounds. Energy is supply with 6-volt batteries.
Report No.: GLEMO050300530RFT Page: 1 of 14 FCC ID : Authorized Signature: Kent Hsu Laboratory Manager This report refers to the General Conditions for Inspection and Testing Services, printed overleaf This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the SGS PRODUCT CERTIFICATION MARK.. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. Member of the SGS Group (SGS SA) SGS-CSTC Standards Technical Services Ltd. 1/F., Building No. 1 Building, Agriculture Machinery Materials Co. Wushan Road, Shipai, Tianhe District,Guangzhou, China Telephone: +86 (0) 20 3848 1001 Fax: +86 (0) 20 3848 1006 Email: [email protected] FEDERAL COMMUNICATIONS COMMISSION Registration number: 282399 FCC TEST REPORT Application No. : GLEMO050300530RF ( SGS NO.: 2009312/EL) Applicant : FREEWELL TRADING LIMITED FCC ID : S3E-05FLT05169 Fundamental Frequency : 315.000MHz Equipment under Test (EUT): Name : REMOTE CONTROL SPOOKY SOUND Model : 05169 Standards : FCC PART 15, SUBPART C : 2004 (Section 15.231) Date of Receipt : 05 March 2004 Date of Test : 07 March to 16 May 2004 Date of Issue : 28 May 2004 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. FCC ID: S3E-05FLT05169 Report No.: GLEMO050300530RFT Page: 2 of 14 SGS-CSTC Standards Technical Services 2 Test Summary Test Test Requirement Stanadard Paragraph Result Radiated Emission (30MHz to 1000MHz) FCC PART 15 :2004 Section 15.231 PASS Occupied Bandwidth FCC PART 15 :2004 Section 15.231 PASS Calculation Of Duty Cycle FCC PART 15 :2004 Section 15.231 PASS Remark: The EUT passed Occupied Bandwidth test after the modification by the applicant. FCC ID: S3E-05FLT05169 Report No.: GLEMO050300530RFT Page: 3 of 14 SGS-CSTC Standards Technical Services 3 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 TEST SUMMARY....................................................................................................................................................2 3 CONTENTS..............................................................................................................................................................3 4 GENERAL INFORMATION...................................................................................................................................4 4.1 CLIENT INFORMATION....................................................................................................................................... 4 4.2 DETAILS OF E.U.T............................................................................................................................................ 4 4.3 DESCRIPTION OF SUPPORT UNITS................................................................................................................... 4 4.4 TEST LOCATION................................................................................................................................................ 4 4.5 OTHER INFORMATION REQUESTED BY THE CUSTOMER.................................................................................. 4 4.6 TEST FACILITY................................................................................................................................................... 5 5 TEST RESULTS......................................................................................................................................................6 5.1 TEST INSTRUMENTS.......................................................................................................................................... 6 5.2 E.U.T. OPERATION........................................................................................................................................... 6 5.3 TEST PROCEDURE & MEASUREMENT DATA..................................................................................................... 7 5.3.1 Radiated Emissions...................................................................................................................................7 5.3.2 Occupied Bandwidth.................................................................................................................................9 6 PHOTOGRAPHS - TEST SETUP.......................................................................................................................12 7 PHOTOGRAPHS - EUT CONSTRUCTIONAL DETAILS..........................................................................13-14 FCC ID: S3E-05FLT05169 Report No.: GLEMO050300530RFT Page: 4 of 14 SGS-CSTC Standards Technical Services 4 General Information 4.1 Client Information Applicant: FREEWELL TRADING LIMITED Address of Applicant: FLT R, 8/F, BLK 2, GOLDFIELD IND. BLDG., 144 TAI LIN PAI RD, KWAI CHUNG, HK. 4.2 Details of E.U.T. Product Name: REMOTE CONTROL SPOOKY SOUND ( Transmitter Part) Model: 05169 Power Supply: 12Vdc ( 1 x Alkaline Battery) for transmitter, 6.0Vā¦
Text truncated - open the document above for the full version.
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15.231 | 315 MHz - 315 MHz | - |