SEU-CENTURYHELI4 Channel Remote Controller

OPERATION Thank you for purchasing the “Elite 4 Radio Control System “which is a low product to be used with model helicopter as well as fixed wing airplane . Operation of the system is simple as following for model helicopter : 1. Install 8 cells of the 1.5VDC batteries into the Transmitter on the and fully pull out Antenna. 2. Connect the 2 Servos to CH1 and CH2 respectively in the Receiver (5 in 1 Modulation ). 3. Connect the Main Motor and the Tail Motor to the Control-Board by inserting the connector into the Mail Motor Socket and Tail Motor Socket respectively.(5in 1modulation ) 4. Connect the Power Pack (6 to 12VDC)to the Control-Board by inserting the connector into the Battery Socket .(5 in 1 Modulation ) 5. Then you can start testing the system .(Detail please see the Instruction Manual ). Operation of the system is simple is simply as follows for model airplane : 1.Install 8cells of 1.5VDC batteries into the Transmitter.Switch the Transmitter on and fully pull out Antenna. 2.Connect the 2 Servo to CH1 and CH2 respectively in the Receiver (5 in 1 Modulation ) 3.Connect the your speed control system to CH3 respectively in the Receiver (5 in 1 Modulation ),And finally connect the Power Pack to you r speed control system . Then you can start testing the system.(Detail please see the Instruction Manual). When test done.firstly turn off the Receiver ,The Transmitter should be switched off the last .

PROPOSED FCC ID LABEL AND LOCATION CENTURY HELICOPTER PRODUCTS This device complies with Part 95 of the FCC rules. FCC ID: SEU-CENTURYHELI

OPERATION Thank you for purchasing the “Elite 4 Radio Control System “which is a low product to be used with model helicopter as well as fixed wing airplane . Operation of the system is simple as following for model helicopter : 1. Install 8 cells of the 1.5VDC batteries into the Transmitter on the and fully pull out Antenna. 2. Connect the 2 Servos to CH1 and CH2 respectively in the Receiver (5 in 1 Modulation ). 3. Connect the Main Motor and the Tail Motor to the Control-Board by inserting the connector into the Mail Motor Socket and Tail Motor Socket respectively.(5in 1modulation ) 4. Connect the Power Pack (6 to 12VDC)to the Control-Board by inserting the connector into the Battery Socket .(5 in 1 Modulation ) 5. Then you can start testing the system .(Detail please see the Instruction Manual ). Operation of the system is simple is simply as follows for model airplane : 1.Install 8cells of 1.5VDC batteries into the Transmitter.Switch the Transmitter on and fully pull out Antenna. 2.Connect the 2 Servo to CH1 and CH2 respectively in the Receiver (5 in 1 Modulation ) 3.Connect the your speed control system to CH3 respectively in the Receiver (5 in 1 Modulation ),And finally connect the Power Pack to you r speed control system . Then you can start testing the system.(Detail please see the Instruction Manual). When test done.firstly turn off the Receiver ,The Transmitter should be switched off the last .

COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 1 of 37 Rev. 00 ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT INTENTIONAL RADIATOR CERTIFICATION TO FCC PART 95 SUBPART C REQUIREMENT OF 4 Channel Digital Proportional Remote Control System MODEL No.: Elite 4 BRAND NAME: N/A FCC ID: SEU-CENTURYHELI REPORT NO:SZE0407049 ISSUE DATE: August 16, 2004 Prepared for CENTURY HELICOPTER PRODUCTS 1740C JUNCTION AVE.,SAN JOSE,CA95112 U.S.A Prepared by COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. d.b.a. COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. NO. 6, JINAO INDUSTRIAL PARK, NO. 35 JUKENG ROAD, DASHUIKENG VILLAGE, GUANLAN TOWN, BAOAN DISTRICT, SHENZHEN, CHINA TEL: 86-755-28055000 FAX: 86-755-28055221 COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 2 Rev. 00 VERIFICATION OF COMPLIANCE Applicant: CENTURY HELICOPTER PRODUCTS 1740C JUNCTION AVE.,SAN JOSE,CA95112 U.S.A Product Description: 4 Channel Digital Proportional Remote Control System Brand Name: N/A Model Number: Elite 4 Serial Number: N/A File Number: SZE0407049 Date of Test: July 23,2004 ~ August 10, 2004 We hereby certify that: The above equipment was tested by COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in TIA/EIA 603 and the sample tested as described in this report is in compliance with the FCC Rules Part 95 Subpart C. The test results of this report relate only to the tested sample identified in this report. Approved By Reviewed By Clinton Kao / Q.A. Manager Jimmy COMPLIANCE CERTIFICATION COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. SERVICES (SHENZHEN) INC. COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 3 Rev. 00 Table of Contents 1. ............................................................................................... 5GENERAL INFORMATION 1.1 PRODUCT DESCRIPTION...................................................................................................................... 5 1.2 RELATED SUBMITTAL(S)/GRANT(S)................................................................................................. 6 1.3 TEST METHODOLOGY.......................................................................................................................... 6 1.4 TEST FACILITY....................................................................................................................................... 6 2. SYSTEM TEST CONFIGURATION.................................................................................. 7 2.1 EUT CONFIGURATION.......................................................................................................... 7 2.2 EUT EXERCISE........................................................................................................................ 7 2.3 GENERAL TECHNICAL REQUIREMENTS ............................................................................ 7 2.4 ............................................................................... 8CONFIGURATION OF TESTED SYSTEM 3. ..................................................................................... 10SUMMARY OF TEST RESULTS 4. .................................................................................. 10DESCRIPTION OF TEST MODES 5. AUTHORIZED OPERATION CHANNELS....................................................11 5.1 PROVISIONS APPLICABLE...................................................................................11 5.2 COMPLIANCE.....................................................................................................11 6. FREQUENCY TOLERANCE.....................................................................12 6.1 PROVISIONS APPLICABLE.....................................................................................12 6.2 MEASUREMENT PROCEDURE................................................................................12 6.2.1 FREQUENCY STABILITY VERSUS ENVIRONMENTAL TEMPERATURE........................12 6.2.2 FREQUENCY STABILITY VERSUS INPUT VOLTAGE...................................................12 6.3 TEST SETUP BLOCK DIAGRAM...............................................................................13 6.4 TEST RESULT........................................................................................................13 7. EMISSION TYPE....................................................................................15 7.1 PROVISIONS APPLICABLE.................................................................................... 15 7.2 COMPLIANCE.......................................................................................................15 8. EMISSION BANDWIDTH..........................................................................16 8.1 PROVISIONS APPLICABLE......................................................................................16 8.2 MEASUREMENT PROCEDURE................................................................................16 8.3 TEST SETUP BLOCK DIAGRAM...............................................................................16 8.4 MEASUREMENT EQUIPMENT USED........................................................................16 8.5 MEASUREMENT RESULT.......................................................................................16 COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 4 Rev. 00 9. UNWANTED RADIATION.........................................................................18 9.1 PROVISIONS APPLICABLE.....................................................................................18 9.2 MEASUREMENT PROCEDURE.................................................................................18 …

Text truncated - open the document above for the full version.

COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 1 of 37 Rev. 00 ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT INTENTIONAL RADIATOR CERTIFICATION TO FCC PART 95 SUBPART C REQUIREMENT OF 4 Channel Digital Proportional Remote Control System MODEL No.: Elite 4 BRAND NAME: N/A FCC ID: SEU-CENTURYHELI REPORT NO:SZE0407049 ISSUE DATE: August 16, 2004 Prepared for CENTURY HELICOPTER PRODUCTS 1740C JUNCTION AVE.,SAN JOSE,CA95112 U.S.A Prepared by COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. d.b.a. COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. NO. 6, JINAO INDUSTRIAL PARK, NO. 35 JUKENG ROAD, DASHUIKENG VILLAGE, GUANLAN TOWN, BAOAN DISTRICT, SHENZHEN, CHINA TEL: 86-755-28055000 FAX: 86-755-28055221 COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 2 Rev. 00 VERIFICATION OF COMPLIANCE Applicant: CENTURY HELICOPTER PRODUCTS 1740C JUNCTION AVE.,SAN JOSE,CA95112 U.S.A Product Description: 4 Channel Digital Proportional Remote Control System Brand Name: N/A Model Number: Elite 4 Serial Number: N/A File Number: SZE0407049 Date of Test: July 23,2004 ~ August 10, 2004 We hereby certify that: The above equipment was tested by COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in TIA/EIA 603 and the sample tested as described in this report is in compliance with the FCC Rules Part 95 Subpart C. The test results of this report relate only to the tested sample identified in this report. Approved By Reviewed By Clinton Kao / Q.A. Manager Jimmy COMPLIANCE CERTIFICATION COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. SERVICES (SHENZHEN) INC. COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 3 Rev. 00 Table of Contents 1. ............................................................................................... 5GENERAL INFORMATION 1.1 PRODUCT DESCRIPTION...................................................................................................................... 5 1.2 RELATED SUBMITTAL(S)/GRANT(S)................................................................................................. 6 1.3 TEST METHODOLOGY.......................................................................................................................... 6 1.4 TEST FACILITY....................................................................................................................................... 6 2. SYSTEM TEST CONFIGURATION.................................................................................. 7 2.1 EUT CONFIGURATION.......................................................................................................... 7 2.2 EUT EXERCISE........................................................................................................................ 7 2.3 GENERAL TECHNICAL REQUIREMENTS ............................................................................ 7 2.4 ............................................................................... 8CONFIGURATION OF TESTED SYSTEM 3. ..................................................................................... 10SUMMARY OF TEST RESULTS 4. .................................................................................. 10DESCRIPTION OF TEST MODES 5. AUTHORIZED OPERATION CHANNELS....................................................11 5.1 PROVISIONS APPLICABLE...................................................................................11 5.2 COMPLIANCE.....................................................................................................11 6. FREQUENCY TOLERANCE.....................................................................12 6.1 PROVISIONS APPLICABLE.....................................................................................12 6.2 MEASUREMENT PROCEDURE................................................................................12 6.2.1 FREQUENCY STABILITY VERSUS ENVIRONMENTAL TEMPERATURE........................12 6.2.2 FREQUENCY STABILITY VERSUS INPUT VOLTAGE...................................................12 6.3 TEST SETUP BLOCK DIAGRAM...............................................................................13 6.4 TEST RESULT........................................................................................................13 7. EMISSION TYPE....................................................................................15 7.1 PROVISIONS APPLICABLE.................................................................................... 15 7.2 COMPLIANCE.......................................................................................................15 8. EMISSION BANDWIDTH..........................................................................16 8.1 PROVISIONS APPLICABLE......................................................................................16 8.2 MEASUREMENT PROCEDURE................................................................................16 8.3 TEST SETUP BLOCK DIAGRAM...............................................................................16 8.4 MEASUREMENT EQUIPMENT USED........................................................................16 8.5 MEASUREMENT RESULT.......................................................................................16 COMPLIANCE CERTIFICATION SERVICES (SHENZHEN) INC. REPORT NO: SZE0407049 FCC ID: SEU-CENTURYHELI DATE: 08/16/2004 Page 4 Rev. 00 9. UNWANTED RADIATION.........................................................................18 9.1 PROVISIONS APPLICABLE.....................................................................................18 9.2 MEASUREMENT PROCEDURE.................................................................................18 …

Text truncated - open the document above for the full version.