SFB-HR135Electronic Pest Repeller

YACHT & RV GUARD™ Manual About Aspectek™ Aspectek is a world leading supplier of advanced electronic products with over 20 years of experience in research and development. Notice of Copyright Yacht & RV Guard™ owner’s manual ©October 2012 As- pectek. All rights reserved. Disclaimer UNLESS SPECIFICALLY AGREED TO IN WRITING, ASPECTEK: A. MAKES NO WARRANTY AS TO THE ACCURACY, SUFFICIENCY OR SUITABILITY OF ANY TECHNICAL OR OTHER INFORMATION PROVIDED IN ITS MANUALS OR OTHER DOCUMENTATION. B. ASSUMES NO RESPONSIBILITY OR LIABILITY FOR LOSS OR DAMAGE, WHETHER DIRECT, INDIRECT, CONSEQUENTIAL OR INCIDENTAL, WHICH MIGHT ARISE OUT OF THE USE OF SUCH INFORMATION. THE USE OF ANY SUCH INFORMATION WILL BE ENTIRELY AT THE USER’S RISK. Technical Support Web: www.aspectek.com Email: [email protected] This manual will provide you, the user, with directions for the safe and efficient operation of the Yacht & RV Guard™. Please read this manual carefully before using this product, and keep it for future reference. IMPORTANT! Before you plug in your unit, it is important to under- stand sonic and ultrasonic signals. The sonic signal is the alarm/harrassment sound hu- mans can hear. Combining this sound with ultrasonic may give you better results for startling and repelling intruders and animals from your yard. However, if the sonic sound bothers your neighbours, you can turn this off using the “Sonic Volume” dial. Just turn the volume dial to zero. The ultrasonic signal is the high-pitched frequency that only animals can hear. This sound will be emitted when- ever your device is on (plugged in or on battery power). You can adjust the frequency using the Frequency dial, but you won’t turn it off by adjusting either the Sonic Volume or Frequency dial. YACHT & RV GUARD™ DIAGRAM 20 Ultrasonic Motion Sensor Constant Cont. Sweep Operating Time 24 Hr. Day Night Sensor Sensitivity Sonic Volume 16 8 0 1 2 4 Decode SUMULATION DIAL 19 TABLE OF CONTENTS 3 4 5 5 6 6 6 7 8 8 9 9 10 10 11 11 11 11 12 12 13 13 13 14 14 14 15 15 16 16 16 17 18 19 20 INTRODUCTION SAFETY AND MAINTENANCE QUICK SET UP FREQUENCY DIAL MODES SENSITIVITY DIAL SONIC VOLUME PLACEMENT THE SCIENCE BEHIND IT ULTRASONIC INFRARED MOTION SENSOR STROBE LIGHT WITH SUNDOWN SENSOR OPERATING TIME SONIC OPERATING THE YACHT & RV GUARD USING THE A/C ADAPTER USING THE “CIGARETTE LIGHTER” PLUG CONNECTING THE EXTENSION CORD INSTALLING THE BATTERIES INTELLIGENT POWER SYSTEM (IPS) OPTIONAL POWER SOURCES TURNING THE UNIT ON/OFF SETTINGS FREQUENCY DIAL SENSITIVITY DIAL MOUNTING TO A WALL REMOTECONTROL SET THE SIMULATION DIAL TURBO BUTTON STANDBY MODE STROBE LIGHT BUTTON ULTRASONIC PRODUCT SPECIFICATIONS 9 WAYS TO KEEP PESTS AWAY! CONTACT US DIAGRAM CONTACT US We enjoy receiving letters and emails from our valued customers. If you have a question, comment or suggestion about the product, please write to us. If you have a success story, let us know. With your permission we may publish it on our website. Aspectek Langara PO Box No. 61088 571 West 57th Ave. Vancouver, BC V6P 6S5 Visit us at aspectek.com Or email us at [email protected] We stand by our products with a one-year limited warranty. If you are having trouble with your product please don’t return it to the merchant. Contact us, and we would be happy to help you. Available Accesories The Yard Sentinel RC can be connected to a 12V DC or 24V DC Sealed Lead-Acid (SLA) battery using our special extension cord with alligator clip and DC power plug. (For diagram, see page 12; Fig. 8.) Contact us for product and ordering information. 18 . Here are some preventative measures you can take to keep pests out of your home and yard: 1. Keep garbage lids closed tightly. 2. Store food in airtight containers. 3. Don’t leave pet food and water out overnight. 4. Repair plumbing leaks and cracks. 5. Drain all liquids and wash containers before you put them in the recycle bin. 6. Accumulating paper products such as cardboard boxes, bags, newspapers, etc., should be avoided. 7. Keep grass short around the foundation of the house and the trees and shrubs planted away from the house. 8. Screen all vent opening such as crawl spaces, attics or laundry vents. 9. Repair and adjust windows and door screens. 9 TIPS TO KEEP PESTS AWAY The Yacht & RV Guard™ pest repellent by Aspectek is the industry’s most advanced outdoor anti-pest product. The product brings together peace of mind and affordability as a result of years of research and innovation. This device allows you to rid your yard, garden or outdoor area of pests humanely and without the use of poisonous chemicals. How does it work? The Yacht & RV Guard uses ultrasonic technology to repel pests from your yard as well as sonic alarm/harassment noise and strobe light. The device is environmentally friendly, safe for humans and pets and won’t even harm the pests you are trying to repel. It is equipped with an infrared motion sensor that activates when pests are in range. The strobe light and sensor can also be activated by remote control. Features Your device is equipped with several features: AC adapter “Cigarette lighter” plug 10 metre (33 feet) extension cord Battery-operational: Requires 4 C batteries (not included) Intelligent Power System (IPS): AC power will take priority over battery when both are installed. In the case of power failure, device will switch to battery backup when batteries are installed Ultrasonic: Adjustable frequencies so high that only pests can hear them Sonic: Audible alarm and harassment noise Strobe light: Ideal for repelling nocturnal animals Modes: Motion Sensor, Constant or Continuous Sweep Infrared Motion Sensor: Detects pests in range and activates device Remote Control: Four-button remote (Stand-by, Turbo, Ultrasonic, Strobe) INTRODUCTION 3 417 1. Please read the manual before using the product. 2. Do not restrict airflow around the unit. Do not position behind furniture or curtains. For best effect, position in open areas. 3. Do not attempt to open the…

Text truncated - open the document above for the full version.

MILO ENTERPRISES INC. Date: 12.03.2013 Authority to Act as an Agent We declare that the following representative (agent) Name Mark Zhu Position Manager Company Name Shenzhen Certification Technology Service Co., Ltd. Address 2F, Building B, East Area of Nanchang Second Industrial Zone, Gushu 2 nd Road, Bao’an District, Shenzhen 518126, P.R. China Tel / Fax 0755-86375541/0755-26736857 Email [email protected] to act on our behalf on all matters concerning the application and documents submitted to PHOENIX TEST-LAB for product certification below Product Name Electronic Pest Repeller Model Name HR135, HR132, HR136 Brand Name N/A Yours sincerely, Signatory Name Michael Liu Position Manager Company Name MILO ENTERPRISES INC. Address 603-7281 CAMBIE STREET, VANCOUVER, B. C. V6P 3H4 CANADA Tel 1-604-4248228 Fax 1-604-3265896 Email [email protected] In case of FCC, we certify that we are not subject to a denial of Federal benefits, that include FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. §862 because of a conviction for possession or distribution of a controlled substance.

MILO ENTERPRISES INC. Federal Communications Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 Request for Confidentiality Company name: MILO ENTERPRISES INC. FCC ID : SFB-HR135 FCC Part 15 Certification Gentlemen, Pursuant to 47 CFR 0.457(d)(1)(ii) and 0.459 we hereby requests permanent confidentiality of the following documents for the subject application: Exhibit Type Description ☒ Schematics All circuitry of devices and component values ☒ Block Diagrams Details of device showing the frequency of all oscillators ☒ Operational Description Description of the circuit functions Note: Exhibit types that are commonly held confidential are: (1) Schematics, (2) Block Diagrams, (3) Bill Of Materials, (4) Operational Descriptions. Any exhibit NOT granted confidentiality is viewable on the FCC website as soon as a grant is issued. These documents contain detailed system and equipment description and related information about the product which we considers to be proprietary, confidential and a custom design and otherwise would not release to the general public. Since the design is a basis from which future technological products will evolve, we consider that this information would be of benefit to its competitors and that the disclosure of the information in these documents would give competitors an unfair advantage in the market. Yours sincerely, Signatory Name Michael Liu Position Manager Company Name MILO ENTERPRISES INC. Address 603-7281 CAMBIE STREET, VANCOUVER, B. C. V6P 3H4 CANADA Tel 1-604-4248228 Fax 1-604-3265896 Email [email protected]

Top View Bottom View Front View Left View Rear View Right View

Lable: 20mm 10mm Label Location FCC ID: SFB-HR135

Top View Bottom View Antenna

Shenzhen Certification Technology Service Co., Ltd 2F, Building B, East Area of Nanchang Second Industrial Zone, Gushu 2nd Road, Bao'an District, Shenzhen 518126, P.R. China. FCC ID: SFB-HR135 Page 1 of 29 TEST REPORT FCC ID: SFB-HR135 Applicant : MILO ENTERPRISES INC. Address : 603-7281 CAMBIE STREET, VANCOUVER, B. C. V6P 3H4 CANADA Equipment under Test (EUT): Name : Electronic Pest Repeller Model : HR135, HR132, HR136 Standards : FCC PART 15, SUBPART C : 2012 (Section 15.231) Report No. : STI130123026 Date of Test : March 05-12, 2013 Date of Issue : March 12, 2013 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above Authorized Signature (Mark Zhu) General Manager The manufacture should ensure that all the products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of Shenzhen Certification Technology Service Co., Ltd. Or test done by Shenzhen Certification Technology Service Co., Ltd. Approvals in connection with, distribution or use of the product described in this report must be approved by Shenzhen Certification Technology Service Co., Ltd. Approvals in writing. Report No.: STI130123026 FCC ID: SFB-HR135 Page 2 of 29 TABLE OF CONTENT Description Page 1 General Information------------------------------------------------------------------------------------3 1.1 Description of Device (EUT)---------------------------------------------------------------------3 1.2 Description of Test Facility-----------------------------------------------------------------------3 2 EMC Equipment List-----------------------------------------------------------------------------------4 3 Test Procedure------------------------------------------------------------------------------------------5 4 Summary of Measurement---------------------------------------------------------------------------6 4.1 Summary of test result-----------------------------------------------------------------------------6 4.2 Block Diagram--------------------------------------------------------------------------------------6 4.3 Assistant equipment used for test----------------------------------------------------------------6 4.4 Test Conditions-------------------------------------------------------------------------------------7 4.5 Measurement Uncertainty (95% confidence levels, k=2)-------------------------------------7 5 Radiation Emission------------------------------------------------------------------------------------8 5.1 Radiation Emission Limits(15.209&231)-------------------------------------------------------8 5.2 Test Setup--------------------------------------------------------------------------------------------8 5.3 Test Procedure-------------------------------------------------------------------------------------10 5.4 Test Equipment Setting For emission test.-----------------------------------------------------11 5.5 Test Condition-------------------------------------------------------------------------------------11 5.6 Test Result------------------------------------------------------------------------------------------11 6 POWER LINE CONDUCTED EMISSION-------------------------------------------------------17 6.1 Conducted Emission Limits(15.209)-----------------------------------------------------------17 6.2 Test Setup-------------------------------------------------------------------------------------------17 6.3 Test Procedure-------------------------------------------------------------------------------------18 6.4 Test Results-----------------------------------------------------------------------------------------18 7 Occupied bandwidth---------------------------------------------------------------------------------19 7.1 Test limit--------------------------------------------------------------------------------------------19 7.2 Method of measurement--------------------------------------------------------------------------19 7.3 Test Setup-------------------------------------------------------------------------------------------19 7.4 Test Results-----------------------------------------------------------------------------------------19 8 Transmission time------------------------------------------------------------------------------------21 8.1 Test limit--------------------------------------------------------------------------------------------21 8.2 Method of measurement--------------------------------------------------------------------------21 8.3 Test Setup-------------------------------------------------------------------------------------------21 8.4 Test Results-----------------------------------------------------------------------------------------21 9 Band Edge Check-------------------------------------------------------------------------------------23 9.1 Test limit--------------------------------------------------------------------------------------------23 9.2 Test Procedure-------------------------------------------------------------------------------------23 9.3 Test Setup-------------------------------------------------------------------------------------------23 9.4 Test Result------------------------------------------------------------------------------------------23 10 Antenna Requirement-------------------------------------------------------------------------------24 10.1 Standard Requirement----------------------------------------------------------------------------24 10.2 Antenna Connected Construction---------------------------------------------------------------24 10.3 Result------------------------------------------------------------------------------------------------24 11 Photographs of Test Setup------------------------------------------------------------------------25 12 Photographs of EUT-----------------…

Text truncated - open the document above for the full version.

Photographs-Radiated Emission Test Setup in Chamber Below 1G Above 1G