T9GMPC6015Tablet PC

WLAN a+b+g mini-PCI Module User Manual Version: 1.1 March 2006 1 Copyright Statement No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording or otherwise without the prior writing of the publisher. Windows ™ 98SE/2000/ME/XP are trademarks of Microsoft ® Corp. Pentium is trademark of Intel. All copyright reserved. 2 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, (example - use only shielded interface cables when connecting to computer or peripheral devices) any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE: This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Photographs module 99594634 External PHOTOGRAPH 1: FRONT VIEW......................................................................................................................... 2 PHOTOGRAPH 2: REAR VIEW........................................................................................................................... 3 PHOTOGRAPH 3: ANTENNA LOCATION (UNDER BLACK COVER)....................................................................... 4 PHOTOGRAPH 4: CLOSE-UP LABEL.................................................................................................................. 5 PHOTOGRAPH 5: POWER SUPPLY..................................................................................................................... 6 PHOTOGRAPH 6: POWER SUPPLY LABEL.......................................................................................................... 7 Page: 2 of 7 Report number: 99721130 Photograph 1: Front view Page: 3 of 7 Report number: 99721130 Photograph 2: Rear view Page: 4 of 7 Report number: 99721130 Photograph 3: Antenna location (under black cover) Page: 5 of 7 Report number: 99721130 Photograph 4: Close-up label Page: 6 of 7 Report number: 99721130 Photograph 5: Power Supply Page: 7 of 7 Report number: 99721130 Photograph 6: Power Supply label

30.05.2006 FCC and IC Label.doc Page 1 of 1 Sample Layout of the new FCC / IC Label: T9GMPC6015 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC: 6275A-MPC6015 Position (position like the other side)

Photographs module 99594634 Internal PHOTOGRAPH 1: INTERNAL VIEW.................................................................................................................... 2 PHOTOGRAPH 2: WLAN CARD LOCATION...................................................................................................... 3 PHOTOGRAPH 3: WLAN CARD PCB (TOP SIDE).............................................................................................. 4 PHOTOGRAPH 4: WLAN CARD PCB (REAR SIDE) ........................................................................................... 5 PHOTOGRAPH 5: ANTENNA MOUNTING........................................................................................................... 6 Page: 2 of 6 Report number: 99721130 Photograph 1: Internal view Page: 3 of 6 Report number: 99721130 Photograph 2: WLAN card location Page: 4 of 6 Report number: 99721130 Photograph 3: WLAN card PCB (top side) Page: 5 of 6 Report number: 99721130 Photograph 4: WLAN card PCB (rear side) Page: 6 of 6 Report number: 99721130 Photograph 5: Antenna mounting

Testing and certification of electric, electronic and radio equipment/installations including telecommunication systems TNO Electronic Products & Services (EPS) B.V. P.O. Box 15 9822 ZG Niekerk (NL) Smidshornerweg 18 9822 TL Niekerk (NL) Telephone: +31 594 505005 Telefax: +31 594 504804 E-mail: [email protected] Web: www.eps.tno.nl Project number: 05102602.ev1 Page 1 of 36 TEST REPORT CONCERNING RF EXPOSURE ASSESSMENT OF A TABLET PC WITH INTEGRAL IEEE 802.11b/g WLAN, BRAND ADS-TEC, MODEL COMPACT3 TO DEMONSTRATE COMPLIANCE WITH BASIC RESTRICTIONS RELATED TO EXPOSURE OF THE GENERAL PUBLIC TO ELECTROMAGNETIC FIELDS FCC listed Industry Canada VCCI registered : : : 90828 IC3501 R-1518, C-1598 Test specification(s): Description of EUT: Manufacturer: Brand mark: Model: FCC ID: FCC SAR Requirements 2.4 GHz IEEE 802.11 b/g WLAN tablet PC Ads-tec Ads-tec Compact3 - Project number: 05102602.e01 Page 2 of 36 Description of test item Test item : 2.4 GHz IEEE 802.11b/g WLAN tablet PC Manufacturer : ADS-tec Brand : ADS-tec Model : Compact3 Serial numbers : n.a. Revision : n.a. Received number of samples : 1 Receipt date : 14-11-2005 Applicant information Applicant's representative : Th. Moegerle Company : ADS-tec Gmbh Address : Raiffeisenstr. 14 Postal code : 70771 City : Leinfelden-Echterdingen PO-box : n.a. Postal code : n.a. City : n.a. Country : Germany Telephone number : +49 711 45894264 Telefax number : n.a. Test(s) performed Location : Niekerk Test(s) started : November 17, 2005 Test(s) completed : November 18, 2005 Purpose of test(s) : To verify compliance with Federal regulated SAR requirements in the USA Test specification(s) IEEE 1528: 2003, FCC OET Bulletin 65 (including Supplement C) Test engineer : J. Schuurmans, B.Sc.E.E. Report written by : J. Schuurmans, B.Sc.E.E. Report approved by : P.A.J.M Robben Report date : January 13, 2006 This report is in conformity with NEN-EN-ISO/IEC 17025: 2000. This report shall not be reproduced, except in full, without the written permission of TNO Electronic Products & Services (EPS) B.V. The test results relate only to the item(s) tested. Test specification(s): Description of EUT: Manufacturer: Brand mark: Model: FCC ID: FCC SAR Requirements 2.4 GHz IEEE 802.11 b/g WLAN tablet PC Ads-tec Ads-tec Compact3 - Project number: 05102602.e01 Page 3 of 36 Table of contents 1 General. .................................................................................................................................................................................5 1.1 Purpose of tests. .............................................................................................................................................................5 1.2 Applied standards/publications. .....................................................................................................................................5 2 Summary and conclusion.......................................................................................................................................................6 2.1 Exposure category. ........................................................................................................................................................6 2.2 Summary of results. .......................................................................................................................................................6 2.3 Compliance. ...................................................................................................................................................................6 3 Identification of Equipment Under Test (EUT). ....................................................................................................................7 3.1 Equipment under Test (EUT) details. ............................................................................................................................7 3.2 EUT test operating configurations. ................................................................................................................................7 3.3 Additional operating configurations. .............................................................................................................................8 4 Test conditions.......................................................................................................................................................................8 4.1 Environmental conditions. .............................................................................................................................................8 4.2 System performance check 2.4 GHz..............................................................................................................................8 4.2.1 2450 MHz validation parameters. ........................................................................................................................10 4.3 Measured maximum output power of EUT. ................................................................................................................10 4.3.1 Measured Average power on 2.4 GHz. ................................................................................................................11 4.4 Tissue simulating liquid dielectric parameters.............................................................................................................12 4.4.1 Mixing procedures. ..............................................................................................................................................12 4.4.2 Dielectric parameters for 2.4 GHz .......................................................................................................................13 4.4.3 Tissue simulating liquid temperature requirements. ............................................................................................13 5 Photographs of EUT in host. ................................................................…

Text truncated - open the document above for the full version.

Radio test report 99594634 based on: - FCC Part 15 Subpart C, section 15.247 (10-1-05 Edition) - RSS-210, Issue 6 (Sept. 2005 edition) Tablet PC with integral IEEE 802.11a/b/g WLAN ads-tec Compact3 Report number: 99594634 Contents MAIN MODULE............................................................................................................................................3 1 I NTRODUCTION ....................................................................................................................................3 2 P RODUCT .............................................................................................................................................4 3 T EST SCHEDULE ...................................................................................................................................4 4 P RODUCT DOCUMENTATION .................................................................................................................5 5 O BSERVATIONS AND COMMENTS .........................................................................................................5 6 M ODIFICATIONS TO THE SAMPLE ..........................................................................................................6 7 S UMMARY ............................................................................................................................................6 8 C ONCLUSIONS ......................................................................................................................................7 TEST RESULTS MODULE .........................................................................................................................8 1.1 Equipment information ...................................................................................................................8 1.2 Tested channels...............................................................................................................................8 1.3 Summary of test data (IEEE 802.11b) ............................................................................................8 1.4 Summary of test data (IEEE 802.11g) ............................................................................................9 2 E MISSION TESTS 802.11 B & 802.11 G .................................................................................................10 2.1 Power line conducted emissions ...................................................................................................10 3 E MISSION TESTS 802.11 B ...................................................................................................................12 3.1 Minimum 6 dB bandwidth............................................................................................................12 3.2 Peak power output ........................................................................................................................14 3.3 Peak power spectral density..........................................................................................................15 3.4 Field strength of unwanted emissions 30 - 1000 MHz (exploratory) ...........................................16 3.5 Field strength of unwanted emissions > 1000 MHz .....................................................................17 3.6 Field strength of unwanted emissions in restricted band 4.5 – 5.15 GHz ....................................21 3.7 Field strength of unwanted emissions in lower adjacent restricted band......................................22 3.8 Field strength of unwanted emissions in upper adjacent restricted band......................................24 4 E MISSION TESTS 802.11 G ...................................................................................................................26 4.1 Minimum 6 dB bandwidth............................................................................................................26 4.2 Peak power output ........................................................................................................................28 4.3 Peak power spectral density..........................................................................................................29 4.4 Field strength of unwanted emissions 30 – 1000 MHz (exploratory) ..........................................30 4.5 Field strength of unwanted emissions > 1000 MHz .....................................................................31 4.6 Field strength of unwanted emissions in restricted band 4.5 – 5.15 GHz ....................................35 4.7 Field strength of unwanted emissions in lower adjacent restricted band......................................36 4.8 Field strength of unwanted emissions in upper adjacent restricted band......................................38 USED TEST EQUIPMENT MODULE .....................................................................................................40 CROSS REFERENCE TABLE ..................................................................................................................41 This report comprises of four modules. The total number of pages is: 41 Main module Page: 3 of 41 Report number: 99594634 Main module 1 Introduction This report contains the result of tests performed by: Telefication B.V. Edisonstraat 12a 6902 PK Zevenaar The Netherlands Telefication complies with the accreditation criteria for test laboratories as laid down in ISO/IEC 17025:1999. The accreditation covers the quality system of the laboratory as well as the specific activities as described in the authorized annex bearing the accreditation number L021 and is granted on 30 November 1990 by the Dutch Council For Accreditation (RvA: Raad voor Accreditatie). The contents of this test report, if reproduced, shall be copied in full, unless special consent in writing for reproduction in part is granted by Telefication. Copyright of this test report is reserved to Telefication. Ordering party: …

Text truncated - open the document above for the full version.

Photographs module 99594634 Test setup PHOTOGRAPH 1: CONDUCTED EMISSIONS....................................................................................................... 2 PHOTOGRAPH 2: EXPLORATORY RADIATED EMISSIONS (30 - 1000 MHZ) ....................................................... 3 PHOTOGRAPH 3: RADIATED EMISSIONS (> 1000 MHZ) ................................................................................... 4 Page: 2 of 4 Report number: 99721130 Photograph 1: Conducted emissions Page: 3 of 4 Report number: 99721130 Photograph 2: Exploratory radiated emissions (30 - 1000 MHz) Page: 4 of 4 Report number: 99721130 Photograph 3: Radiated emissions (> 1000 MHz)