UB7KCL-135Snowing Snowman

SNOWING SNOWMAN KCL-135 USER’S MANUL 1. Remore the tank from the back of snowman and open the cap. 2. Inser the formula of snow and mix with one gallon of water. 3. Close the cap and put the tank to the back part of the snoeman. 4. Insert the plug. 5. Push the ON key of the RF control. The snowman will produce snow. Working Procedure This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or operating to conjunction with any other antenna or transmitter. Product Start Water pump and Air pump motor Water Pump Move Formala To The Dipe Motor Below Out The Formula To Snow Remote Controller ON/OFF Singnal

1 Helen Zhao Subject: FW: KING CHIEN LUNG INTERNATIONAL CO., LTD, FCC ID: UB7KCL-135, Assessment NO.: AN06T5881, Notice#1 Block Diagram.pdfConfidentiality Request.pdf Operation Description.pdf 0604MAS210_01_T est report.pdf From: hsieh [mailto:[email protected]] Sent: Wednesday, June 21, 2006 8:49 PM To: Helen Zhao Subject: Re: KING CHIEN LUNG INTERNATIONAL CO., LTD, FCC ID: UB7KCL-135, Assessment NO.: AN06T5881, Notice#1 Dear Helen, Thank you for your mail. Re-Q#1: Attached please find the new confidentiality letter. The item of operational description has cancel. Re-Q#2: It's our wrong choice at 731 form of this device. The correct equipment class is "DSC". Could you please kindly to modify it for me? Thank you. Re-Q#3: The correct power is 6Vdc (by button cell battery 1.5Vdc * 4). Attached please find the revise Test Report, Operation Description and Block Diagram. Re-Q#4: Thank you for your opinion. The wrong description has modified at the new test report. Any other questions please feel free to contact with me. Thank you. Best regards, Joe -----Original Message----- Sent: Wednesday, June 21, 2006 12:01 PM Subject: KING CHIEN LUNG INTERNATIONAL CO., LTD, FCC ID: UB7KCL-135, Assessment NO.: AN06T5881, Notice#1 Question #1: The operational description contains nothing but the same statement shown on the test report section 1.2. Since the test report can be viewed by the public, there is no reason why the operational description should be kept confidential. Please update request for confidentiality letter. Question #2: The documents in this filing only suggest this is a transmitter, please explain why you choose "DSR - Part 15 Remove 2 control/Security Device Transceiver" as equipment class on form 731. Question #3: The test report and block diagram all indicate the device is powered by 12VDC. However the schematic diagram shows VDD 6V, please explain. Question #4: This is for your information. The test report section 1.3 indicates the test was performed according to the procedures in Chapter 13 of ANSI C63.4. Please specify version, as year 2001 version is out of date, you need to use ANSI C63.4: 2003. Best Regards, Helen Zhao The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information within 30 days of the original e-mail date may result in application dismissal and forfeiture of the filing fee. Also, please note that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the e-mail address listed below the name of the sender.

ETC Report No.: 06-04-MAS-210-01 Page A1 of A1 FCC ID.: UB7KCL-135 ANNEX A: EXTERNAL CONSTRUCTION PHOTOS OF EUT 1. Outside view 1 of EUT 2. Outside view 2 of EUT

ID Label / Location FCC ID: UB7KCL-135

ETC Report No.: 06-04-MAS-210-01 Page B1 of B3 FCC ID.: UB7KCL-135 ANNEX B: INTERNAL CONSTRUCTION PHOTOS OF EUT 1. Inside View 1 of EUT 2. Inside View 2 of EUT ETC Report No.: 06-04-MAS-210-01 Page B2 of B3 FCC ID.: UB7KCL-135 3. antenna 4. Front view of PCB ETC Report No.: 06-04-MAS-210-01 Page B3 of B3 FCC ID.: UB7KCL-135 5. Rear view of PCB

Operation Description The transmitter of SNOWING SNOWMAN (KCL-135) is powered by 6.0Vdc battery and operates at 315 MHz. The transmitter of SNOWING SNOWMAN controls the SNOWING SNOWMAN of receiver to operate ON or OFF.

ETC Report No. : 06-04-MAS-210-01 Sheet 1 of 22 Sheets FCC ID.: UB7KCL-135 Rev. No 1.0 CONFORMANCE TEST REPORT FOR FCC 47 CFR, Part 15 Subpart C Report No.: 06-04-MAS-210-01 Client: KING CHIEN LUNG INTERNATIONAL CO., LTD. Product: SNOWING SNOWMAN Model: KCL-135 FCC ID: UB7KCL-135 Manufacturer/supplier: HING TAI FU KOU TRADING CO., LIMITED Date test item received: 2006/04/21 Date test campaign completed: 2006/06/09 Date of issue: 2006/06/09 The test result only corresponds to the tested sample. It is not permitted to copy this report, in part or in full, without the permission of the test laboratory. Total number of pages of this test report: 22 pages Total number of pages of photos: External photos 1 pages Internal photos 3 pages Setup photos 2 pages Test Engineer Checked By Approved By Jeng De Hsu James Joe Hsieh ELECTRONICS TESTING CENTER, TAIWAN NO.8, LANE 29, WENMING RD., LESHAN TSUEN, GUISHAN SHIANG, TAOYUAN COUNTY, TAIWAN 33383, R.O.C. TEL: (03) 3276170~4 INT: +886-3-3276170~4 FAX: (03) 3276188 INT: +886-3-3276188 ETC Report No. : 06-04-MAS-210-01 Sheet 2 of 22 Sheets FCC ID.: UB7KCL-135 Rev. No 1.0 Client : KING CHIEN LUNG INTERNATIONAL CO., LTD. Address : NO. 82, SHIHJING DADAO, DONG CHENG DIS., DONGGUAN, GUANAGDONG, CHINA Manufacturer : HING TAI FU KOU TRADING CO., LIMITED Address : NO. 82, SHIHJING DADAO, DONG CHENG DIS., DONGGUAN, GUANAGDONG, CHINA EUT : SNOWING SNOWMAN Trade name : KING CHIEN LUNG INTERNATIONAL CO., LTD. Model No. : KCL-135 Power Source : 12Vdc Regulations applied : FCC 47 CFR, Part 15 Subpart C (2006) The testing described in this report has been carried out to the best of our knowledge and ability, and our responsibility is limited to the exercise of reasonable care. This certification is not intended to believe the sellers from their legal and/or contractual obligations. The compliance test is only certified for the test equipment and the results of the testing report relate only to the item tested. The compliance test of this report was conducted in accordance with the appropriate standards. It’s not intention to assure the quality and performance of the product. This report shall not be reproduced except in full, without the approval of ETC. This report must not be used by the client to claim product endorsement by NVLAP or any agency of the U.S. Government. Laboratory Introduction: Electronics Testing Center, Taiwan is recognized, filed and mutual recognition arrangement as following: 1 ISO9001: TüV Product Service 2 ISO/IEC 17025: BSMI, CNLA, DGT, NVLAP, CCIBLAC, UL, Compliance 3 Filing: FCC, Industry Canada, VCCI 4 MRA: Australia, Hong Kong, New Zealand, Singapore, USA, Japan, Korea, China, APLAC through CNLA 5 FCC Registration Number: 90588, 91094, 91095 NVLAP Lab Code 200133-0 ETC Report No. : 06-04-MAS-210-01 Sheet 3 of 22 Sheets FCC ID.: UB7KCL-135 Rev. No 1.0 Table of Contents Page 1. GENERAL INFORMATION ......................................................................................................................................4 1.1 PRODUCT DESCRIPTION.................................................................................................................................................4 1.2 CHARACTERISTICS OF DEVICE: ......................................................................................................................................4 1.3 TEST METHODOLOGY....................................................................................................................................................4 1.4 TEST FACILITY...............................................................................................................................................................4 1.5 MODIFICATION RECORD................................................................................................................................................4 2. DEFINITION AND LIMITS........................................................................................................................................5 2.1 DEFINITION....................................................................................................................................................................5 2.2 RESTRICTED BANDS OF OPERATION...............................................................................................................................5 2.3 LIMITATION....................................................................................................................................................................6 2.4 LABELING REQUIREMENT..............................................................................................................................................7 2.5 USER INFORMATION.......................................................................................................................................................7 3. RADIATED EMISSION MEASUREMENT..............................................................................................................8 3.1 APPLICABLE STANDARD.................................................................................................................................................8 3.2 MEASUREMENT PROCEDURE.........................................................................................................................................8 3.3 TEST DATA..................................................................................................................................................................10 3.4 FIELD STRENGTH CALCULATION..................................................................................................................................13 3.5 RADIATED TEST EQUIPMENT.......................................................................................................................................13 3.6 MEASURING INSTRUMENT SETUP.........................................................................…

Text truncated - open the document above for the full version.

ETC Report No.:06-04-MAS-210-01 Sheet 1 of 2 Sheets FCC ID.: UB7KCL-135 Radiated Measurement Photos x-axis ETC Report No.:06-04-MAS-210-01 Sheet 2 of 2 Sheets FCC ID.: UB7KCL-135 y-axis z-axis