UKF-FULLJOIN-004BLUETOOTH HEADSET

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.





   
   
     


    
      

APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004

APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 Label Location

APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 Label Drawing FCC ID: UKF-FULLJOIN-004 Model Number: FJ990

APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004

APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 The brief introduction of the circuit of the Bluetooth headsets 1. IC U1 crystal vibration Y1 16MHz will be launched out via antenna, after the 64 times frequency in U1, enlarged by the inside U1, exported passing TX_A and TX_A, and then going through the internet composed by T1L1L2 C2C14C15 and filtered noises. 2. the adjusted signal adds via U1,XTAL_IN, by adjusting the change of frequency of Y116MHz, in order to reach the purpose which is to add the signal to the main frequency. 3. Lunching antenna is printing antenna, in fact, good effect can be obtained by PIFA antenna. 4. power of the whole body is provided by 3.6V battery. 5. Shooting frequency testing point, via a solid connecting frequency testing point on the designing connection board, puts a shooting frequency change connecting equipment on the sieve and antenna. 6. the memorizer of U2,FLASH uses the power provided by 1.8V, and the circuit can be changed easily.

                                !   " #   "   #      "   $  #%  ##%    "      %&    $   %&             '( %)*+*%,-.  / *+*%,-.  *+*%,-. /   /     ((#  #% "  '(  '&          
 $$            /      0 #         #  #  .     %& #    #
1  #
1 0 2(   0  0  #   /  &   !    "    #%       '( "  '(   '( "      3      3                  / #      /  / # 3 &/  '(       % #  %    $  +'- $  $  #  #    "  #           ##% #      #
1  #
1             #  4  ##  56+- 
 -75859%## *6-/## :#;  :;  :;  :";         $ :#; " $ :; #  &/      :;  :;  :#;     $     $   #               $    $      $$ #           " $$ #       $   $ &$ $ $ $"  $#  $ $  (   (  ( :; (" : ; (#  /  /  /  /# $/ &   & $/$ &  &#   3   3   3  3  3 :#; 3  $ 3 $:; 3    3"  3# $/            $:;   $              :;    "  #    :;  : ; /" : ; (  #  "          "      " :;  ! &"  3  /  &   "     $$    $$  < "#  /&=
  /&=

SHENZHEN MOST ELECTRONICS CO., LTD. Tel:(86) 755-26825180 Fax:(86) 755-86170310 Http:// www. szmost.com Email: [email protected] APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 Cover Sheet Test Report Product Name: Bluetooth Headset FCC ID: UKF-FULLJOIN-004 MODEL NO. : FJ990 Applicant: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. 5/F, B2, LIANHE INDUSTRIAL ZONE, EMERSON ROAD, HE PING, FUYONG Shenzhen City, Guang Dong Province Date Received: 10/13/2006-10/16/2006 Date Tested: 10/16/2006 SHENZHEN MOST ELECTRONICS CO., LTD. Tel:(86) 755-26825180 Fax:(86) 755-86170310 Http:// www. szmost.com Email: [email protected] APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 TABLE OF CONTENTS TABLE OF CONTENTS APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 TEST REPORT CONTAINING: PAGE 1...........TEST EQUIPMENT LIST PAGE 3-5.........POWER LINE CONDUCTED INTERFERENC AND PLOTS PAGE 6-7.........RADIATION INTERFERENCE TEST DATA PAGE 8-11........OCCUPIED BANDWIDTH AND PLOTS EXHIBIT INCLUDED: PAGE 1...........BLOCK DIAGRAM PAGE 2...........SCHEMATIC PAGE 3...........USERS MANUAL PAGE 4...........LABEL SAMPLE PAGE 5...........LABEL LOCATION PAGE 6...........EXTERNAL PHOTOGRAPHS PAGE 7...........INTERNAL PHOTOGRAPHS PAGE 8...........OPERATIONAL DESCRIPTION PAGE 9...........TEST SET UP PHOTOGRAPHS SHENZHEN MOST ELECTRONICS CO., LTD. Tel:(86) 755-26825180 Fax:(86) 755-86170310 Http:// www. szmost.com Email: [email protected] APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 Page 1 of 11 EMC Equipment List Remark: Test Firm Name: ACCURATE TECHNOLOGY CO. LTD Test Firm Address: F1, Bldg. A, Changyuan New Material Port, Keyuan Rd. Science & Industry Park, Nanshan Shenzhen Guangdong China FCC Registered Test Site Number: 253065 Equipment Manufacturer Model No. Serial No.Last Cal. Cal. Interval EMI Test Receiver ROHDE&SCHWARZ ESCS30 100307 Mar 20,2006 1 Year LISN ROHDE&SCHWARZ ESH3-Z5 100305 Mar 20,2006 1Year Pulse Limiter ROHDE&SCHWARZ ESH3-Z2 100305 Mar 20,2006 1Year 50 Coaxial Switch ANRITSU CORP MP59B 6200283933 Mar 20,2006 1 Year Spectrum Analyzer ANRITSU MS2651B 6200238856 Mar 20,2006 1 Year Horn Antenna ROHDE&SCHWARZ HF906 1000023 Mar 20,2006 1 Year Bilog Antenna SCHWARZBECK VULB 9163 9163-194 Mar 20,2006 1 Year 50 Coaxial Switch ANRITSU CORP MP59B 620028393 3 Mar 20,2006 1 Year Cable Resenberger N/A NO.1 Mar 20,2006 1 Year Cable SCHWARZBECK N/A NO.2 Mar 20,2006 1 Year Cable SCHWARZBECK N/A NO.3 Mar 20,2006 1 Year DC Power Filter DuoJi DL2°30B N/A N/A N/A Single Phase Power Line Filter DuoJi FNF 202B30 N/A N/A N/A 3 Phase Power Line Filter DuoJi FNF 402B30 N/A N/A N/A AC Power Source California Instruments 5001iX-400 55689 Mar 20,2006 1Year Test analyzer California Instruments PACS-1 72254 Mar 20,2006 1Year ESD Tester HAEFELY PESD 1610 H4001552 Mar 20,2006 1 Year Signal Generator IFR 2032 203002/100 Mar 20,2006 1 Year Amplifier A&R 150W1000 301584 NCR NCR Dual Directional Coupler A&R DC6080 301508 Mar 20,2006 1 Year Power Head A&R PH2000 301193 Mar 20,2006 1 Year Power Meter A&R PM2002 302799 Mar 20,2006 1 Year Field Monitor A&R FM5004 300329 Mar 20,2006 1 Year Field Probe A&R FP5000 300221 Mar 20,2006 1 Year EMCPRO System Thermo RO-BASE 0403271 Mar 20,2006 1 Year Capacitive Clamp Thermo PRO-CCL 0403272 Mar 20,2006 1 Year EMCPRO System Thermo PRO-BASE 0403271 Mar 20,2006 1 Year Coupler decoupler for telecom lines Thermo CM-TEL-CD 0403273 Mar 20,2006 1 Year Signal Generator IFR 2032 203002/100 Mar 20,2006 1 Year Amplifier A&R 150W1000 301584 NCR NCR EMCPRO System Thermo PRO-BASE 0403271 Mar 20,2006 1 Year SHENZHEN MOST ELECTRONICS CO., LTD. Tel:(86) 755-26825180 Fax:(86) 755-86170310 Http:// www. szmost.com Email: [email protected] APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 Page 2 of 11 TEST PROCEDURE GENERAL: This report shall NOT be reproduced except in full without the written approval of SHENZHEN MOST ELECTRONICS CO., LTD. The EUT was transmitting a test signal during the testing. POWER LINE CONDUCTED INTERFERENCE: The test procedure used was ANSI Standard C63.4-2003 using a 50H LISN. Both Lines were observed. The bandwidth of the receiver was 10kHz with an appropriate sweep speed. The ambient temperature of the EUT was 25 with a humidity of 58%. RADIATION INTERFERENCE: The test procedure used was ANSI Standard C63.4-2003 using a ANRITSU spectrum analyzer with a pre-selector. The analyzer was calibrated in dB above a micro volt at the output of the antenna. The resolution bandwidth was 100 kHz and the video bandwidth was 300 kHz up to 1 GHz and 1 MHz with a video BW of 3 MHz above 1 GHz. The ambient temperature of the EUT was 25 with a humidity of 58%. FORMULA OF CONVERSION FACTORS: The Field Strength at 3m was established by adding the meter reading of the spectrum analyzer (which is set to read in units of dBuV) to the antenna correction factor supplied by the antenna manufacturer. The antenna correction factors are stated in terms of dB. The gain of the Pre-selector was accounted for in the Spectrum Analyzer Meter Reading. Example: Freq (MHz) METER READING + ACF = FS 33 20 dBuV + 10.36 dB = 30.36 dBuV/m @ 3m ANSI STANDARD C63.4-2003 10.1.7 MEASUREMENT PROCEDURES: The EUT was placed on a table 80 cm high and with dimensions of 1m by 1.5m. The EUT was placed in the center of the table (1.5m side). The table used for radiated measurements is capable of continuous rotation. When an emission was found, the table was rotated to produce the maximum signal strength. At this point, the antenna was raised and lowered from 1m to 4m. The antenna was placed in both the horizontal and vertical planes. The situation was similar for the conducted measurement except that the table did not rotate. The EUT was setup as described in ANSI Standard C63.4-2003 10.1.7 with the EUT 40 cm from the vertical ground wall. SHENZHEN MOST ELECTRONICS CO., LTD. Tel:(86) 755-26825180 Fax:(86) 755-861703…

Text truncated - open the document above for the full version.

APPLICANT: SHENZHEN FULL-JOIN TECHNOLOGY CO., LTD. FCC ID: UKF-FULLJOIN-004 POWER LINE CONDUCTED TEST RADIATED EMISSION TEST