WBKMBSC081921-08Multi-Band, Multi-Standard, Multi-Carrier Coverage System (CDMA 800)

mBSC081921-12 ISSUE 2 mBSC081921-12 Multi-Band, Multi-Standard, Multi-Carrier Coverage System Operation Manual mBSC081921-12 System Operation Manual Issue 2 © 2009, Bravo Tech Inc. Page 2 COPYRIGHT This document is the Operation Manual for Bravo Tech Inc. mBSC system. Bravo Tech Inc. reserves the right to change the contents without prior notice. No part of this document may be reproduced or utilized. © 2009, Bravo Tech Inc, All Rights Reserved REVISION HISTORY Issue No. Description Date 1 Initial Draft Dec. 15, 2009 2 Update the specification Jan. 18, 2010 TABLE OF CONTENTS Content Page 1 Introduction ...................................................................................................................... 4 2 Thoery of operation .......................................................................................................... 4 2.1 System Overview ..................................................................................................... 4 2.2 Basic System Components....................................................................................... 4 2.3 Host Unit Description................................................................................................ 4 2.3.1 Basic Functions of HU .................................................................................5 2.3.2 HU Interface Ports Description ..................................................................... 5 2.4 Remote Unit Description........................................................................................... 6 2.4.1 Basic Functions of RU .................................................................................8 2.4.2 RU Interface Ports Description ..................................................................... 8 2.5 Specifications ........................................................................................................... 9 3 Network Management system ........................................................................................ 12 3.1 Software Installation ............................................................................................... 13 3.2 System Start-Up Procedure with NMS ....................................................................13 3.3 Read and Edit the current system setting parameters............................................. 19 3.4 Read and Modify the System Gain Budget ............................................................. 20 3.5 Check Alarm Status for the system ......................................................................... 21 3.6 Check the Major performance for the system.......................................................... 22 4 antenna Mount environment ........................................................................................... 23 5 fcc warning..................................................................................................................... 23 6 customer Contact information ......................................................................................... 23 Figure 2-1. System Overview Structure.................................................................................... 4 Figure 2-2. Host Unit ............................................................................................................... 5 Figure 2-3. User Interface of Host Unit..................................................................................... 6 Figure 2-4. 3 Remote Unit Assembly Without Solar Shell ......................................................... 7 Figure 2-5. 3 Remote Unit Assembly With Solar Shell.............................................................. 8 Figure 2-6. User Interface of Remote Unit................................................................................ 9 Figure 3-1. User Login Window.............................................................................................. 13 Figure 3-2. Advanced User Login Window ............................................................................. 13 mBSC081921-12 System Operation Manual Issue 2 © 2009, Bravo Tech Inc. Page 3 Content Page Figure 3-3. Network Management System Main Window ....................................................... 14 Figure 3-4. Configuration of IP Address ................................................................................. 14 Figure 3-5. System Configruation Window ............................................................................. 15 Figure 3-6. Define the District ................................................................................................ 15 Figure 3-7. Reult window after Defining District ...................................................................... 16 Figure 3-8. Add the Host Unit in the System configuration ...................................................... 16 Figure 3-9. Result Window after adding HU ........................................................................... 17 Figure 3-10. Add the Remote Unit below the Host Unit Tree................................................... 17 Figure 3-11. Completion of the System Configuration............................................................. 18 Figure 3-12. Read the current setting for teh system .............................................................. 19 Figure 3-13. Modify the parameters for the system................................................................. 19 Figure 3-14. Modify the parameters for the system................................................................. 20 Figure 3-15. Read the current Alarm Status............................................................................ 21 Figure 3-16. Change the Alarm Setting .................................................................................. 21 Figure 3-17. Check the system performance.......................................................................... 22 Table 2-1. Remote Unit User Interface …

Text truncated - open the document above for the full version.

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT – CDMA 800 Band Unit Front View EUT – CDMA 800 Band Unit Rear View

EXHIBIT A - FCC ID LABELING AND LOCATION FCC ID Label FCC ID Label Location Label here The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925)

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS EUT – Cover off View-1 EUT – Cover off View-2 EUT – Host Unit Control Top View EUT – Host Unit Control Bottom View EUT – Interface Board Top View EUT – Interface Board Bottom View EUT – PA Control Board Top View EUT – PA Control Board Bottom View EUT – Power Board Top View EUT – Power Board Bottom View EUT – Band Pass Filter Module without Cover View EUT – Linearization Module without Cover View EUT – Pilot Module without Cover View EUT – Small Signal Module without Cover View EUT – Duplexer View EUT – RF Module View-1 EUT – RF Module View-2 EUT – RF Module View-3 EUT – RF Module View-4 EUT – RF Module View-5 EUT – RF Module View-6 Delay filter Main power amplifier module Error power amplifier module Powermodule

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP*, NIST, or any agency of the Federal Government. * This report may contain data that are not covered by the NVLAP accreditation and are marked with an asterisk “*” (Rev.2) FCC PART 22H MEASUREMENT AND TEST REPORT For Bravo Tech (Shenzhen) Co., Ltd. No.8 Building, The 3rd Zone, Tangtou Industrial Park, Shiyan, Baoan District, Shenzhen, Guangdong, P. R. of China FCC ID: WBKMBSC081921-08 Report Type: Original Report Product Type: Multi-Band, Multi-Standard, Multi- Carrier Coverage System (CDMA 800) Test Engineer: Weir Zhong Report Number: RSZ09121101-22H Report Date: 2010-05-14 Reviewed By: Merry Zhao EMC Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building, ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 Bravo Tech (Shenzhen) Co., Ltd. FCC ID: WBKMBSC081921-08 Report No.: RSZ09121101-22H Page 2 of 47 FCC Part 22H Test Report TABLE OF CONTENTS GENERAL INFORMATION.......................................................................................................................................4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ....................................................................................4 EUT PHOTO.................................................................................................................................................................4 OBJECTIVE...................................................................................................................................................................4 RELATED SUBMITTAL(S)/GRANT(S).............................................................................................................................5 TEST METHODOLOGY..................................................................................................................................................5 TEST FACILITY.............................................................................................................................................................5 SYSTEM TEST CONFIGURATION ..........................................................................................................................6 JUSTIFICATION.............................................................................................................................................................6 EQUIPMENT MODIFICATIONS.......................................................................................................................................6 LOCAL SUPPORT EQUIPMENT LIST AND DETAILS........................................................................................................6 EXTERNAL I/O CABLE..................................................................................................................................................6 CONFIGURATION OF TEST SETUP.................................................................................................................................7 BLOCK DIAGRAM OF TEST SETUP................................................................................................................................7 SUMMARY OF TEST RESULTS...............................................................................................................................8 FCC §1.1307(B)(1) & §2.1091- MAXIMUM PERMISSIBLE EXPOSURE (MPE).....................................................9 STANDARD APPLICABLE..............................................................................................................................................9 MPE PREDICATION......................................................................................................................................................9 FCC §2.1047 - MODULATION CHARACTERISTIC ............................................................................................10 FCC §2.1046 & § 22.913(A) - RF OUTPUT POWER ..............................................................................................11 APPLICABLE STANDARD............................................................................................................................................11 TEST PROCEDURE......................................................................................................................................................11 TEST EQUIPMENT LIST AND DETAILS.........................................................................................................................11 TEST DATA................................................................................................................................................................11 FCC §2.1049, §22.917& §22.905 - OCCUPIED BANDWIDTH ..............................................................................19 APPLICABLE STANDARDS...........................................................................................................................................19 TEST PROCEDURE......................................................................................................................................................19 TEST EQUIPMENT LIST AND DETAILS.........................................................................................................................19 TEST DATA................................................................................................................................................................19 FCC §2.1051 & §22.917(A) - SPURIOUS EMISSIONS AT ANTENNA TERMINALS.......................................33 APPLICABLE STANDARDS......…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Below 1 GHz: Spurious Radiated Emissions - Front View (Downlink mode) Below 1 GHz: Spurious Radiated Emissions - Rear View (Downlink mode) Above 1 GHz: Spurious Radiated Emissions - Front View (Downlink mode) Above 1 GHz: Spurious Radiated Emissions - Rear View (Downlink mode) Frequency Stability Test View (Downlink mode)