WED-FD350GPS Receiver

1 Precautions and Notices . For your own safety, do not operate the controls of the product while driving. . Use this product prudently. The product is intended to be used only as a navigation aid. It is not for precise measurement of direction, distance, location or topography. . The calculated route is for reference only. It is the user's responsibility to follow the traffic signs and local regulations along the roads. . When you get off the car, do not leave your device on the dashboard that is subject to direct sunlight. The overheating of the battery can cause malfunction and/or danger. . GPS is operated by the United States government, which is solely responsible for the performance of GPS. Any change to the GPS system can affect the accuracy of all GPS equipments. . GPS satellite signals cannot pass through solid materials (except glass). When you are inside a tunnel or building, GPS positioning is not available. . A minimum of 4 GPS satellite signals is needed to determine current GPS position. Signal reception can be affected by situations such as bad weather or dense overhead obstacles (e.g. trees and tall buildings). . Other wireless devices in the vehicle might interfere with the reception of satellite signals and cause the reception to be unstable. . A car holder is needed when using the device in a car. Be sure to place the device in an appropriate place, so as not to obstruct the driver's view or deployment of air bags. 2 Table of Contents Precautions and Notices................................................................................1 1Getting Started.............................................................................................4 1.1 Understanding Hardware Features..........................................................4 Front and back components...........................................................................4 Top components.............................................................................................5 Side components............................................................................................5 1.2 Connecting to AC Power and Charging the Battery(Optional)..................6 1.3 Using Your Device in a Vehicle.................................................................7 Using the Car Holder......................................................................................7 1.4 Connecting the Car Charger.....................................................................7 2 Operating Basics.......................................................................................8 2.1 Performing the Initial Start Up...................................................................8 2.2 Turning On and Off/sleeping mode...........................................................8 2.3 Operating the Device................................................................................9 2.4 Main Menu..............................................................................................10 2.5 Inserting a microSD Card.......................................................................10 3 Device Settings.......................................................................................12 3.1 Using Device Settings............................................................................12 3.2 Volume...................................................................................................12 3.3 Date/time...............................................................................................12 3.4 Backlight................................................................................................13 3.5 Language...............................................................................................13 3.6 calibrator................................................................................................14 3.7 about......................................................................................................14 3.8 NAVI Path....................................................................................................14 3.9 USB Setting.................................................................................................15 4.1 GPS Receiver......................................................................................16 5 Music Player...........................................................................................17 5.1 Starting and Exiting Music Player...........................................................17 5.2 Preparing the Music Files for You Device...............................................18 5.3 Music playback control.........................................................................18 6 Video Player.............................................................................................19 6.1 Starting and Exiting Video player.............................................................19 6.2 Video playback control............................................................................19 7 Picture Viewer .........................................................................................20 3 7.1 Viewing a picture file................................................................................20 8 Document Viewer.....................................................................................21 8.1 Viewing a Document file...........................................................................21 9 Trouble shooting and maintenance...........................................................22 9.1 Resetting Your System..............................................................................22 9.2 Troubleshooting.........................................................................................22 Screen freezes......................................................................................23 GPS Problems.............................................................................…

Text truncated - open the document above for the full version.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 Revised wording (current) 1.0 2.0 Sept–25-2007

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 1 Rev 2.0 Authorization Letter SGS-CSTC Standards Technical Services Ltd 09 February, 2010 To: SIEMIC, INC. 2206 Ringwood Avenue, San Jose, CA 95131 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, _______ SGS-CSTC Standards Technical Services Ltd _________hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): Product : GPS Item N.O.:G69-1, G69-2, G69-3, G69-5, G69-6, G69-8, G69-9,G350,FD-350 We affirm that between SIEMIC and _ SGS-CSTC Standards Technical Services Ltd any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature: Client’s name / title: Jack Zhang, Technical Manager Contact information / address: No.1 Workshop, M-10, Middle Section, Science & Technology Park, Nanshan District, Shenzhen

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (current) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 1.0 2.0 August – 11 - 2008

1.1 EUT Constructional Details

This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only

SGS-CSTC Standards Technical Services Co., Ltd. No. 1 Workshop, M-10, Middle section, Science & Technology Park, Shenzhen, Guangdong, China 518057 Telephone: +86 (0) 755 2601 2053 Fax: +86 (0) 755 2671 0594 Email: [email protected] Report No. SZEMO10020055701 Page: 1 of 12 Authorized Signature: Robinson Lo Laboratory Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only FCC REPORT Application No. : SZEMO100200557RF Applicant: Electronics Co.,Ltd FCC ID： ：： ： WED-FD350 Product Name: GPS Product N.O.: G69-1, G69-2, G69-3, G69-5, G69-6, G69-8, G69-9,G350,FD-350♣ ♣ Please refer to section 2 of this report which indicates which item was actually tested and which were electrically identical. Standards: FCC CFR Title 47 Part 15 Subpart B: 2008 Date of Receipt 01 Frebruary 2010 Date of Test 01 Frebruary to 08 Frebruary 2010 Date of Issue 08 Frebruary 2010 Test Result : PASS * *In the configuration tested, the EUT complied with the standards specified above. This report supersedes our previous report SZEMO10020055701, issued on 08 Frebruary 2010, which is hereby deemed null and void.’’ . SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEMO10020055701 Page: 2 of 12 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only 2 Contents Page 1 COVER PAGE ........................................................................................................................................... 1 2 CONTENTS............................................................................................................................................................ 2 3 TEST SUMMARY.................................................................................................................................................. 3 4 GENERAL INFORMATION.................................................................................................................................. 4 4.1 CLIENT INFORMATION........................................................................................................................................... 4 4.2 GENERAL DESCRIPTION OF E.U.T. ........................................................................................................................ 4 4.3 E.U.T OPERATION ENVIRONMENT AND TEST MODE.............................................................................................. 4 4.4 TEST FACILITY...................................................................................................................................................... 5 4.5 TEST LOCATION.................................................................................................................................................... 5 4.6 OTHER INFORMATION REQUESTED BY THE CUSTOMER..................................................…

Text truncated - open the document above for the full version.

1.1 Conducted Emission Test Setup 1.2 Radiatd Emission Test Setup