WKLWA6206WLAN 11n ROUTER

Version: 1.0s i User’s Manual Version: 1.0s 11n Wi-Fi router Version: 1.0s ii Trademarks Copyright @2007 Contents are subject to change without notice. All trademarks belong to their respective proprietors. Copyright Statement THIS DOCUMENT CONTAINS OF PROPRIETARY TECHNICAL INFORMATION THAT IS THE PROPERTY OF THIS COMPANY. AND NO PART OF THIS DOCUMENTATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRICAL OR MECHANICAL, BY PHOTOCOPYING, RECORDING, OR OTHERWISE, WITHOUT THE PRIOR WRITTEN CONSENT OF THIS COMPANY. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Version: 1.0s iii Trademark All of the company or product names mentioned in this manual are the trademarks or registered trademarks of their respective holders. Disclaimer All of the contents in this manual, product specifications, size and shape are subject to change without prior notice. The manufacturer makes no representations or warranties with regard to the contents hereof and reserves the right to revise this manual without obligation to notify any person. The manufacturer shall not be liable for any technical or editorial errors or omissions contained in this manual, or for any damage, direct or indirect, from discrepancies between the manual and the product it describes. The manufacturer assumes no responsibility, directly or indirectly, for financial losses or claims from third persons resulting from the use of this product and any of its functions. Total accessible capacity varies depending on operating environment. All references to speed are for comparison purposes only. Actual data throughput will vary. Precautions Please follow the precautions listed below. Failure to do so may cause damage to the device and void the warranty. * Read this User’s Guide carefully and follow the procedures for installing and using the device. * Do not open the device or attempt to disassemble or modify it. If it appears to be malfunctioning, contact Technical Support. * Never expose the device to water or other liquids or in damp or wet conditions in order to avoid danger of electric shock, short-circuiting or personal injury. * Place the power adapter and the power cord such a way that people cannot step on it. * Do not use a third-party AC adapter or power cord. * Do not cover the openings; the openings on the equipment are for air convection hence protects the equipment from overheating. * If any of the following situations arises, have the equipment checked by service personnel: - The power adapter, power cord or power connector is damaged. - Liquid has penetrated into the equipment. - The equipment has dropped and damaged. - The equipment has obvious sign of breakage. Version: 1.0s iv Copyright Notice The material in this document is the intellectual property of Samtack Computer Inc. We take every care in the preparation of this document, but no guarantee is given to the correctness of its contents. Our products are under continues improvement and we reserve the right to make changes without notice. Limited Warranty This product is warranted against manufacturing defects for the period of one year. The warranty period commences on the date of purchase from authorized reseller/retailer. Your original purchase invoice, showing the date of purchase of the product is your proof of the date of purchase. During the warranty period, defective parts will be repaired or replaced. There will be no charge for labor or parts during the one-year warranty period from the date of purchase. Any shipping or other cost such as customs incurred costs, etc.... is customers’ responsibility. This warranty does not cover any failure resulting in loss to software, data, lost profits, lost savings, any incidental damages or other economic consequential damages due to accident, abuse, misuse, negligence and acts of God. Technical Support and Service For technical support in English Email [email protected] Call 1-800-255-8048 Monday to Friday (except holidays) 09:00am to 08:00pm (Eastern Time) For technical support in French Email [email protected] Call 1-800…

Text truncated - open the document above for the full version.

EUT top view Adding crusts EUT bottom view Adding crusts

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The Label must not be a stick-on paper label. The Label on these products must be permanently affixed to the product and readily visible at the time of purchase and must last the expected lifetime of the equipment not be readily detachable. Proposed Label Location on EUT EUT Bottom View/Proposed FCC ID Label Location FCC ID: WKLWA6206

EUT inside whole view Main board component side Main board solder side

The test report consists 55 pages in total. It may be duplicated completely for legal use with the allowance of the applicant. It shall not be reproduced except in full, without the written approval of Ke Mei Ou Laboratory Corporation. The test result in the report only applied to the tested sample. FCC TEST REPORT Under FCC 15 Subpart C, Paragraph 15.247: 2008 Operating in 2400 ~ 2483.5 MHz Band Prepared For : CC&C Technologies, Inc. No.9 Building, 3rd Main Street, Kunshan Export Processing Zone. P.R. China January 4, 2010 FCC ID: WKLWA6206 EUT: WLAN 11n Router Model: WA-6206 Report Type: Original Report Test Engineer: Jacky Huang Test Date: December 9, 2009 Review By: Apollo Liu / Manager Ke Mei Ou Laboratory Co., Ltd. 7A, Jiaxiangge, Jiahuixincheng, No.3027, Shennan Rd., Futian, Shenzhen, Guangdong, P.R.China. Zip Code: 518033 Tel: + 86 755 83642690 Fax: + 86 755 83297077 www.kmolab.com CC&C Technologies, Inc. FCC ID: WKLWA6206 KMO FCC ID Report Report #: KSZ2009111604J Page 2 of 55 TABLE OF CONTENTS 1. General Information....................................................................................................................................................3 1. 1 Notes......................................................................................................................................................................3 1. 2 Testing Laboratory..................................................................................................................................................3 1. 3 Details of Applicant................................................................................................................................................3 1. 4 Application Details..................................................................................................................................................3 1. 5 Test Item.................................................................................................................................................................3 1. 6 Test Standards.........................................................................................................................................................3 2. Technical Test...............................................................................................................................................................4 2. 1 Summary of Test Results.........................................................................................................................................4 2. 2 Antenna Requirement..............................................................................................................................................4 3. EUT Modifications.......................................................................................................................................................4 4. Conducted Power Line Test.........................................................................................................................................5 4. 1 Test Equipment.......................................................................................................................................................5 4. 2 Test Procedure........................................................................................................................................................5 4. 3 Test Setup...............................................................................................................................................................5 4. 4 Configuration of The EUT.......................................................................................................................................6 4. 5 EUT Operating Condition........................................................................................................................................8 4. 6 Conducted Power Line Emission Limits..................................................................................................................8 4. 7 Conducted Power Line Test Result...........................................................................................................................9 5. FCC Part 15.247 Requirements for 802.11b/g/n Systems...........................................................................................11 5. 1 Test Equipment.....................................................................................................................................................11 5. 2 Test Procedure......................................................................................................................................................11 5. 3 Test Setup.............................................................................................................................................................11 5. 4 Configuration of the EUT......................................................................................................................................11 5. 5 EUT Operating Condition......................................................................................................................................11 5. 6 Limit....................................................................................................................................................................11 5. 7 Test Result............................................................................................................................................................12 6. Transmitter Spurious Radiated Emission at 3 Meters...............................................................................................39 6. 1 Test Equipment.....................................................................................................................................................39 6. 2 Test Procedure..................................................…

Text truncated - open the document above for the full version.

Conducted emission test view Radiated emission test view