WQ83017000101TPMS sensor activator

A universal TPMS sensor activator The MaxiTPMS TS101 is a universal TPMS (tire pressure monitoring system) sensor trigger tool to activate TPMS sensors to reset or relearn the sensor ID. Designed for vehicles with stationary “re-learn mode” : most GM, Chrysler and Ford and some Japanese cars, and compatible with all currently known TPMS sensors, TS101 is an easy-to-use and affordable tool for every driver! Stream on and low battery indicators. Radio stream: 125KHz to activate sensors. Powered by 9V alkaline battery. Internet update guarantees future sensor compatibility. Designed to last in rough environments Extremely easy to use. like tire repair shops. Specifications Weight:0.166 Kg( battery included) Dimensions:151.7x49.2x28.5mm(5.97"x1.97"x1.12") Maxi Compliance Information FCC COMPLIANCE FCC ID: WQ83017000101 This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: i. Reorient or relocate the receiving antenna. ii. Increase the separation between the equipment and receiver. iii. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. iv. Consult the dealer or an experienced radio/TV technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction。 The term “IC” before the radio certification number only signifies that IC technical specifications were met. RoHS COMPLIANCE This device is declared to be in compliance with the European RoHS Directive 2011/65/EU. CE COMPLIANCE This product is declared to conform to the essential requirements of the following Directives and carries the CE mark accordingly: EMC Directive 2004/108/EC R&TTE Directive 1999/5/EC Low Voltage Directive 2006/95/EC

Shenzhen Autel Intelligent Tech. Co., Ltd. Rm. 2205, Overseas Chinese Scholars Venture Bldg. Hi-tech Industrial Park Shenzhen China DATE :2012-12-22 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 Attn: Director of Certification Authority to Act as Agent On our behalf, I appoint Hans.Hu of Global United Technology Services Co., Ltd. 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District Shenzhen Guangdong (Name and address) to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with Shenzhen Autel Intelligent Tech. Co., Ltd. and Rm. 2205, Overseas Chinese Scholars Venture Bldg. Hi- tech Industrial Park Shenzhen China ( applicant name and address). Dated this / Day of 12/22/2012 / Agency agreement expiration date: 12/22/2013 By: Frank Li Signature Printed Title: Manager On behalf of : Shenzhen Autel Intelligent Tech. Co., Ltd. Telephone: 0755-86329573

Shenzhen Autel Intelligent Tech. Co., Ltd. Rm. 2205, Overseas Chinese Scholars Venture Bldg. Hi-tech Industrial Park Shenzhen China 2012-12-22 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: WQ83017000101 Product Name: TPMS sensor activator Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential: • Schematics • Block diagram • Operational Description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this 12/22/2012 By: Frank Li Signature Printed Title: Manager On behalf of : Shenzhen Autel Intelligent Tech. Co., Ltd. Telephone: 0755-86329573

Label location

Global United Technology Services Co., Ltd. Report No.: GTSE12120157101 Authorized Signature: Robinson Lo Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the GTS product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of GTS International Electrical Approvals or testing done by GTS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by GTS International Electrical Approvals in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” FCC REPORT Applicant: Shenzhen Autel Intelligent Tech. Co., Ltd. Address of Applicant: Rm. 2205, Overseas Chinese Scholars Venture Bldg. Hi-tech Industrial Park Shenzhen China Equipment Under Test (EUT) Product Name: TPMS sensor activator Model No.: MaxiTPMS TS101 FCC ID: WQ83017000101 Applicable standards: FCC CFR Title 47 Part 15 Subpart C:2011 Date of sample receipt: 4 Jan., 2013 Date of Test: 4 -10 Jan., 2013 Date of report issued: 11 Jan., 2013 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Report No.: GTSE12120157101 Global United Technology Services Co., Ltd. Project No.: GTSE121201571RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 2 of 17 2 Version Version No. Date Description 00 11 Jan., 2013 Original Prepared By: Date: 11 Jan., 2013 Project Engineer Check By: Date: 11 Jan., 2013 Reviewer Report No.: GTSE12120157101 Global United Technology Services Co., Ltd. Project No.: GTSE121201571RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 3 of 17 3 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 VERSION .................................................................................................................................................. 2 3 CONTENTS .............................................................................................................................................. 3 4 TEST SUMMARY ..................................................................................................................................... 4 5 GENERAL INFORMATION ...................................................................................................................... 5 5.1 CLIENT INFORMATION.......................................................................................................................... 5 5.2 GENERAL DESCRIPTION OF EUT ......................................................................................................... 5 5.3 TEST MODE........................................................................................................................................ 6 5.4 DESCRIPTION OF SUPPORT UNITS....................................................................................................... 6 5.5 TEST FACILITY.................................................................................................................................... 6 5.6 TEST LOCATION.................................................................................................................................. 6 5.7 OTHER INFORMATION REQUESTED BY THE CUSTOMER......................................................................... 6 6 TEST INSTRUMENTS LIST ..................................................................................................................... 7 7 TEST RESULTS AND MEASUREMENT DATA...................................................................................... 8 7.1 ANTENNA REQUIREMENT: .................................................................................................................... 8 7.2 RADIATED EMISSIONS......................................................................................................................... 9 7.3 20DB OCCUPIED BANDWIDTH............................................................................................................ 12 8 TEST SETUP PHOTO ............................................................................................................................ 13 9 EUT CONSTRUCTIONAL DETAILS .....................................................................................................14 Report No.: GTSE12120157101 Global United Technology Services Co., Ltd. Project No.: GTSE121201571RF 2nd Floor, Block No.2, Laodong Industrial Zone, Xixiang Road Baoan District, Shenzhen, China 518102 Telephone: +86 (0) 755 2779 8480 Fax: +86 (0) 755 2779 8960 Page 4 of 17 4 Test Summary Test Item Section in CFR 47 Result Antenna requirement 15.203 Pass AC Power Line Conducted Emission 15.207 N/A Radiated Emission 15.209 Pass 20dB Occupied Bandwidth 15.215 Pass Pass: The EUT complies with the essential requirements in the standard. N/A: not applicable.…

Text truncated - open the document above for the full version.

Radiated Emission