X62IDTI10102901Incell Touch 215x

idti Incell Touch 215x 1 / 2 IS215x Pen Usage The product has 2 touch pens. User can use these 2 pens to do multi-touch operation. The use can operate the pen head’s switch to turn on or turn off the pen. When the user touches the monitor with the pen, the pen will emit light to trigger the monitor’s touch function and the result is the user can use the pen to operate the monitor just like using a mouse. Product spec: idti Incell Touch 215x 2 / 2 Warning statement: FCC Regulatory information: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NCC 警語: (1) 經審驗合格之射頻電信終端設備，非經許可，公司、商號或使用者均不得擅自變更頻率、加 大功率或變更原設計之特性及功能。 (2) 射頻電信終端設備之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即 停用，並改善至無干擾時方得繼續使用。所謂合法通信，係指依電信法規定作業之無線電信。 (3) 輸入、製造射頻電信終端設備之公司、商號或其使用者違反本辦法規定，擅自使用或變更無 線電頻率、電功率者，除依電信法規定處罰外，電信總局並得撤銷其審驗合格證明。

Page 1 CONSTRUCTION PHOTOS OF EUT Model: IS215x Page 2

(Fig. 1) FCC ID: X62IDTI10102901 FCC LABEL LOCATION The label will be permanently affixed at a conspicuous location on the device. Label

Page 2 Model: IS215x Page 3 Page 4

FCC ID: X62IDTI10102901 Report No.: RF990910E01 Operational Description The transmitter of the EUT is powered by 5Vdc from the host equipment or the power adapter, Class II DC 3.7V from the battery. The antenna is PCB antenna without antenna connector. For more detailed instruction, please take a look at the user’s manual.

Report No.: RF990910E01 1 Report Format Version 3.0.1 FCC TEST REPORT REPORT NO.: RF990910E01 MODEL NO.: IS215x FCC ID: X62IDTI10102901 RECEIVED: Sep. 10, 2010 TESTED: Sep. 27, 2010 ISSUED: Oct. 26, 2010 APPLICANT: Integrated Digital Technologies,lnc. ADDRESS: Room C1,3F,No1.,Lixing 1st rd. Hsinchu Science park, Taiwan, R.O.C. ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch Hsin Chu Laboratory LAB ADDRESS: No. 81-1, Lu Liao Keng, 9th Ling, Wu Lung Tsuen, Chiung Lin Hsiang, Hsin Chu Hsien 307, Taiwan This test report consists of 30 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF990910E01 2 Report Format Version 3.0.1 TABLE OF CONTENTS 1. CERTIFICATION...........................................................................................4 2. SUMMARY OF TEST RESULTS..................................................................5 2.1 MEASUREMENT UNCERTAINTY.....................................................................5 3. GENERAL INFORMATION...........................................................................6 3.1 GENERAL DESCRIPTION OF EUT........................................................6 3.2 DESCRIPTION OF TEST MODES..........................................................7 3.2.1 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL...........8 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS..........................9 3.4 DESCRIPTION OF SUPPORT UNITS...................................................10 3.5 CONFIGURATION OF SYSTEM UNDER TEST...................................10 4. TEST TYPES AND RESULTS....................................................................11 4.1 CONDUCTED EMISSION MEASUREMENT.........................................11 4.1.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT......................11 4.1.2 TEST INSTRUMENTS...........................................................................11 4.1.3 TEST PROCEDURES...........................................................................12 4.1.4 DEVIATION FROM TEST STANDARD..................................................12 4.1.5 TEST SETUP.........................................................................................13 4.1.6 EUT OPERATING CONDITIONS...........................................................13 4.1.7 TEST RESULTS....................................................................................14 4.2 RADIATED EMISSION MEASUREMENT..............................................16 4.2.1 LIMITS OF RADIATED EMISSION MEASUREMENT...........................16 4.2.2 TEST INSTRUMENTS...........................................................................18 4.2.3 TEST PROCEDURES...........................................................................19 4.2.4 DEVIATION FROM TEST STANDARD..................................................19 4.2.5 TEST SETUP.........................................................................................20 4.2.6 EUT OPERATING CONDITIONS...........................................................20 4.2.7 TEST RESULTS....................................................................................21 4.2.8 TEST RESULTS....................................................................................22 4.3 DEACTIVATION TIME...........................................................................24 4.3.1 LIMIT OF DEACTIVATION TIME MEASUREMENT...............................24 4.3.2 TEST INSTRAMENT.............................................................................24 4.3.3 TEST PROCEDURE..............................................................................24 4.3.4 DEVIATION FROM TEST STANDARD..................................................24 4.3.5 TEST SETUP.........................................................................................24 4.3.6 EUT OPERATING CONDICTION..........................................................24 4.3.7 TEST RESULT.......................................................................................25 4.4 20dB OCCUPIED BANDWIDTH MEASUREMENT...............................26 Report No.: RF990910E01 3 Report Format Version 3.0.1 4.4.1 LIMIT OF THE EMISSION BANDWIDTH...............................................26 4.4.2 TEST INSTRAMENT.............................................................................26 4.4.3 TEST PROCEDURE..............................................................................26 4.4.4 DEVIATION FROM THE TEST STANDARD..........................................26 4.4.5 TEST SETUP.........................................................................................26 4.4.6 EUT OPERATING CONDITION.............................................................26 4.4.7 TEST RESULT.......................................................................................27 5. PHOTOGRAPHS OF THE TEST CONFIGURATION.................................28 6. INFORMATION ON THE TESTING LABORATORIES...............................29 7. APPENDIX - A MODIFICATIONS RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB......................................................30 Report No.: RF990910E01 4 Report Format Version 3.0.1 1. CERTIFICATION PRODUCT : Incell Touch 215x BRAND : IDTI MODEL NO.: IS215x APPLICANT : Integrated Digital Technologies,lnc. TESTED : Sep. 27, 2010 TEST SAMPLE : ENGINEERING SAMPLE STANDARDS : FCC Part 15, Subpart C (Section 15.231) ANSI C63.4-2003 The above equipment (Model: IS215x) has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configuration…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 RADIATED EMISSION TEST