XO8-HALO433ACTXHalo Transmitter

FCC ID: XO8-HALO433ACTX rev. 001 Instant Care Halo Transmitter Model #: HALO433ACTX • Identifying the Parts 1 1. Emergency Button/ LED • Learning-in the Halo Transmitter Press the Emergency button, a radio signal will be transmitted to the Control Panel. Please refer to the learn-in procedure of your Control Panel for further instruction. • Operation ➢ To dial Emergency Line: Press once on the Emergency button, the GREEN LED will illuminate for .5 seconds and transmit the message to the Control Panel. ➢ Sleep Mode: -The Halo Transmitter ships in “Sleep Mode” to conserve battery life -Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode • Battery & Electrical Specifications ➢ Frequency: 433MHz ➢ Battery: CR2032, 3V 230mAh ➢ Battery life: Typical life expectancy of 3 yrs at an average use rate of one activation per day. ➢ Open Field Range: Approximately 300 ft. ➢ Low battery status: when the battery voltage is below the threshold, the Halo Transmitter will indicate a low battery by illuminating the RED LED for .5 seconds when the Emergency button is pressed. The low battery signal will be transmitted to the Control Panel. A supervisory message will be sent during a low battery state once every 6 hours. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may void the user’s authority to operate his equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices) FCC Section 15.105 Information to the user. NOTE: This equipment has been tested and found to comply with the limits for a lass B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

Instant Care, Inc.. 2080 Wineridge Pl.Suite A, Escondido, California, United States, 92029 Date: May 26, 2020 TO: Federal Communication Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MID 21046 Regarding: FCC ID: XO8-HALO433ACTX To whom it may concern: We, the undersigned, hereby authorize Ms. Daphne Liang / Section Manager of SGS Compliance Certification Services Inc. to act on our behalf in all manners relating to application for equipment authorization with respect to the FCC ID above, including signing of all documents relating to these matters. Any and all acts carried out by the agent on our behalf shall have the same effect as acts of our own. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 853(a). Where our agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for Certification, as specified by SGS North America, Inc., still resides with << Instant Care, Inc. >>. This authorization is valid until further written notice from the applicant. Name (Printed): Richard Darling Title: CEO Signature: On behalf of Company: Instant Care, Inc.. Telephone: (877)424-4050

Instant Care, Inc.. 2080 Wineridge Pl.Suite A, Escondido, California, United States, 92029 To: SGS North America Inc. 620 Old Peachtree Road SUITE 100 Suwanee, Georgia United States From: Instant Care, Inc. 2080 Wineridge Pl.Suite A, Escondido, CA 92029 United States Regarding: Confidentiality Request regarding application for FCC ID: XO8-HALO433ACTX LONG TERM CONFIDENTIALITY Pursuant to 47 CFR Section 0.459 and 0.457 of the commission’s rules, the applicant hereby request confidential treatment of the documents listed below, associated with the certification application referenced above. Schematic(s) Block Diagrams Operational Descriptions The documents above contain proprietary information not released to the public. Public disclosure of this information may prove harmful to the business of the applicant. Sincerely, Richard Darling CEO Instant Care, Inc.

Page 1 / 5 Report No.: T200608N03 Ref. No.: Rev. 00 External Photo (Model: HALO433ACTX)

HALO433ACTX D iagram Label location Label location Model: HALO433ACTX FCC ID ：XO8-HALO433ACTX

FCC ID: XO8-HALO433ACTX Page: 1 / 39 Report No.: T200608N03-RP1 Rev.: 01 No.8, Jiucengling, Xinhua Dist., Tainan City, Taiwan /台南市新化區礁坑里九層嶺8號 t:(886-6) 5802-201 f:(886-6) 5802-202 www.sgs.com.tw www.ccsrf.com Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 除非另有說明，此報告結果僅對測試之樣品負責，同時此樣品僅保留90天。本報告未經本公司書面許可，不可部份複製。 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com.tw/Terms-and-Conditions and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com.tw/Terms-and-Conditions. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of client’s instruction, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced, except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Compliance Certification Services Inc. 程智科技股份有限公司 Member of the SGS Group FCC 47 CFR PART 15 SUBPART C ANSI C63.10: 2013 TEST REPORT For Halo Transmitter Model: HALO433ACTX Data Applies To: N/A Brand: Test Report Number: T200608N03-RP1 Issued to Instant Care, Inc. 2080 Wineridge Pl.Suite A, Escondido, California, United States, 92029 Issued by Compliance Certification Services Inc. Tainan Lab. No.8, Jiucengling, Xinhua Dist., Tainan City , Taiwan Issued Date: June 23, 2020 Note: This report shall not be reproduced except in full, without the written approval of Compliance Certification Services Inc. This document may be altered or revised by Compliance Certification Services Inc. personnel only, and shall be noted in the revision section of the document. Page: 2 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 01 REVISION HISTORY Rev. Issue Date Revisions Effect Page Revised By 00 June 19, 2020 Initial Issue ALL Gina Lin 01 June 23, 2020 See the following note rev.01 Page 6 Gina Lin 02 September10, 2018 See the following note rev.02 ALL Gina Lin Note: ※ Rev.01 Issue Date： June 23, 2020 Revise Operation Frequency. ※ Rev.02 Issue Date： September 10, 2018 Update test result summary. Page: 3 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 01 TABLE OF CONTENTS 1. TEST RESULT CERTIFICATION ........................................................................ 4 2. TEST RESULT SUMMARY ................................................................................. 5 3. EUT DESCRIPTION ............................................................................................. 6 4. TEST METHODOLOGY ....................................................................................... 7 4.1 EUT CONFIGURATION ............................................................................... 7 4.2 EUT EXERCISE ........................................................................................... 7 4.3 GENERAL TEST PROCEDURES ................................................................ 7 4.4 FCC PART 15.205 RESTRICTED BANDS OF OPERATIONS .................... 8 4.5 DESCRIPTION OF TEST MODES ............................................................... 8 5. INSTRUMENT CALIBRATION ............................................................................ 9 5.1 MEASURING INSTRUMENT CALIBRATION ............................................... 9 5.2 MEASUREMENT EQUIPMENT USED ......................................................... 9 5.3 MEASUREMENT UNCERTAINTY ............................................................. 10 6. FACILITIES AND ACCREDITATIONS .............................................................. 11 6.1 FACILITIES................................................................................................. 11 6.2 EQUIPMENT .............................................................................................. 11 6.3 TABLE OF ACCREDITATIONS AND LISTINGS ........................................ 11 6.4 TABLE OF ACCREDITATIONS AND LISTINGS ........................................ 12 7. SETUP OF EQUIPMENT UNDER TEST ........................................................... 13 7.1 SETUP CONFIGURATION OF EUT ........................................................... 13 7.2 SUPPORT EQUIPMENT ............................................................................ 13 7.3 EUT OPERATING CONDITION ................................................................. 13 8. FCC PART 15.231 REQUIREMENTS ................................................................ 14 8.1 99% BANDWIDTH ...................................................................................... 14 8.2 20dB BANDWIDTH ..................................................................................... 16 8.3 LIMIT OF TRANSMISSION TIME ............................................................... 18 8.4 DUTY CYCLE ............................................................................................. 20 8.5 RADIATED EMISSIONS ............................................................................. 24 8.6 POWERLINE CONDUCTED EMISSIONS ................................................. 35 9. APPENDIX 1 PHOTOGRAPHS OF TEST SETUP ............................................ 36 Page: 4 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 01 1. TEST RESULT CERTIFICATION Product: Halo Transmitter Model: HALO433ACTX Data Applies To: N/A Brand Name: Applicant: Instant Care, Inc. 2080 Wineridge Pl.Suite A, Escondi…

Text truncated - open the document above for the full version.

Page: 36 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 00 9. APPENDIX 1 PHOTOGRAPHS OF TEST SETUP RADIATED EMISSION MEASUREMENT SETUP Below 1GHz Page: 37 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 00 Page: 38 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 00 RADIATED RF MEASUREMENT SETUP Above 1GHz Page: 39 / 39 Report No.: T200608N03-RP1 Ref. No.: Rev.: 00