XO8-HALO915TXHALO915TX

FCC ID: XO8‐HALO915TX rev: A01 Instant Care Halo Transmitter Model #: HALO915TX  Identifying the Parts 1 1. Emergency Button/ LED Learning‐in the Halo Transmitter  Please refer to your base station’s user guide for instructions on learning‐in your Halo transmitter.  Operation To dial Emergency Line:  Press and release the Emergency button, the GREEN LED will illuminate for .5 seconds and transmit the message to the Control Panel. Sleep Mode:  ‐The Halo Transmitter ships in “Sleep Mode” to conserve battery life during initial shipment  ‐To exit sleep mode, press and release the emergency button  LEDs: ‐Blue LED = good pendant battery ‐Red LED = low pendant battery   Battery & Electrical Specifications Frequency: 915MHz  Battery: CR2032, 3V 230mAh  Battery life: ~3yrs  Open Field Range: ~500ft  Low battery status: when the battery voltage is below the threshold, the Halo Transmitter will indicate a low battery by illuminating the RED LED for .5 seconds when the Emergency button is pressed. A low battery notification will be sent to the base station with each button press. Low battery supervisory will occur once every 24 hours thereafter. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Caution To assure continued compliance, any changes or notifications not expressly approved by the party responsible for compliance may void the user’s authority to operate his equipment. (Example – use only shielded interface cables when connecting to computer or peripheral devices) FCC Section 15.105 Information to the user NOTE: This equipment has been tested and found to comply with the limits for a lass B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC ID: XO8‐HALO915TX rev: A01 This device complies with Industry Canada licence-exempt RSS standard. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 1 of 14 External Photos Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 2 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 3 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 4 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 5 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 6 of 14

Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 7 of 14 Internal Photos Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 8 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 9 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 10 of 14 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 11 of 14

of Applicant: Instant Care, Inc. Address: 2080 Wineridge Pl.Suite A Escondido California United States 92029 Tested and Prepared by Worldwide Testing Services (Taiwan) Co., Ltd. FCC Registration No.: TW1477, TW1072 Industry Canada filed test laboratory Reg. No. 20037 Report No.: W6M22110-21280-C-1 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E-mail: [email protected] 47 CFR PART 15 SUBPART C TEST REPORT for HALO915TX Model No.: HALO915TX FCC ID: XO8-HALO915TX Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Page 1 of 19 TABLE OF CONTENTS 1 GENERAL INFORMATION .......................................................................................................... 2 1.1 N OTES .......................................................................................................................................... 2 1.2 TESTING LABORATORY ................................................................................................................ 3 1.2.1 Location .............................................................................................................................. 3 1.2.2 Details of accreditation status ............................................................................................ 3 1.3 DETAILS OF APPROVAL HOLDER ................................................................................................... 4 1.4 APPLICATION DETAILS ................................................................................................................... 4 1.5 GENERAL INFORMATION OF TEST ITEM ........................................................................................ 4 1.6 T EST STANDARDS ......................................................................................................................... 4 2 TECHNICAL TEST ......................................................................................................................... 5 2.1 S UMMARY OF TEST RESULTS ........................................................................................................ 5 2.2 TEST ENVIRONMENT .................................................................................................................... 5 2.3 TEST EQUIPMENT LIST ................................................................................................................. 6 2.4 GENERAL TEST PROCEDURE ........................................................................................................ 9 3 TEST RESULTS (ENCLOSURE) ................................................................................................ 10 3.1 PEAK OUTPUT POWER (TRANSMITTER) ...................................................................................... 11 3.2 E QUIVALENT ISOTROPIC RADIATED POWER ................................................................................ 13 3.3 RF EXPOSURE COMPLIANCE REQUIREMENTS ............................................................................ 13 3.4 OUT OF BAND RADIATED EMISSIONS ......................................................................................... 13 3.5 SPURIOUS EMISSION (TX) ........................................................................................................... 14 3.6 RADIATED EMISSIONS FROM RECEIVER PART ............................................................................ 15 3.7 R ADIATED EMISSION ON THE BAND EDGE .................................................................................. 16 3.8 P OWER LINE CONDUCTED EMISSION ......................................................................................... 18 APPENDIX .............................................................................................................................................. 19 Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Page 2 of 19 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the Worldwide Testing Services(Taiwan) Co., Ltd. Tester: October 26, 2021 Rick Chen Date WTS-Lab. Name Signature Technical responsibility for area of testing: October 26, 2021 Kevin Wang Date WTS Name Signature Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Page 3 of 19 1.2 Testing laboratory 1.2.1 Location OATS No.5-1, Lishui, Shuang Sing Village, Wanli Dist., New Taipei City 207, Taiwan (R.O.C.) 3 meter semi-anechoic chamber No.35, Aly. 21, Ln. 228, Ankang Rd., Neihu Dist., Taipei City 114, Taiwan (R.O.C.) TEL:886-2-6613-0228 FAX:886-2-2791-5046 Company Worldwide Testing Services(Taiwan) Co., Ltd. 6F, NO. 58, LANE 188, RUEY-KUANG RD. NEIHU, TAIPEI 114, TAIWAN R.O.C. Tel : 886-2-66068877 Fax : 886-2-66068879 1.2.2 Details of accreditation status Accredited testing laboratory FCC filed test laboratory Reg. No. TW1477, TW1072 Industry Canada filed test laboratory Reg. No. 2003…

Text truncated - open the document above for the full version.

Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 12 of 14 Set Up Photo of Radiated Emission Below 1 GHz Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 13 of 14 Above 1 GHz Registration number: W6M22110-21280-C-1 FCC ID: XO8-HALO915TX Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 14 of 14