XV5KE888Wireless Engine Ignition Device

USER INSTRUCTION FOR HANDHELD WIRELESS REMOTE IGNITION DEVICE Instruction of Use: 1. Press the “Start” button twice to start the generator unit. If the generator unit is too cold or in a low speed mode, it may not be ignited by the Device. Please press the “Start” button for a longer time until the unit starts. 2. Press the red “Off” button on the device once to turn off the generator unit. 3. Notice and Warning: ƒ The handheld wireless remote ignition device (“Device”) is made with delicate parts or components. Please avoid dropping the Device on hard ground or soaking the Device in liquid such as water. ƒ Adding an antenna to the Device will increase wireless signal emissions and thus the distance of remote ignition. ƒ When the battery charge is low, which may be indicated by a dimmed indicator light, the remote ignition distance may decrease and/or result in a malfunction of the Device. Caution Made Under 47 C.F.R. 15.21: Changes or modification not expressly approved by authorized professional personnel will void the user’s authority to operate the device.

The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 26 of 27 FCC Part15.231 & IC RSS-210 Report 11 EXHIBIT C - EUT PHOTOGRAPHS 11.1 EUT - Front View 11.2 EUT - Rear View

The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 22 of 27 FCC Part15.231 & IC RSS-210 Report 9 EXHIBIT A – FCC & IC EQUIPMENT LABELING REQUIREMENTS 9.1 FCC Labeling Requirements As per FCC §2.925 Identification of equipment (a) Each equipment covered in an application for equipment authorization shall bear a nameplate or label listing the following: (1) FCC Identifier consisting of the two elements in the exact order specified in §2.926. The FCC Identifier shall be preceded by the term FCC ID in capital letters on a single line, and shall be of a type size large enough to be legible without the aid of magnification. Example: FCC ID XXX123 Where: XXX—Grantee Code, 123—Equipment Product Code As per FCC §15.19 Labeling Requirements (a) In addition to the requirements in part 2 of this chapter, a device subject to certification, or verification shall be labeled as follows: (3) All other devices shall bear the following statement in a conspicuous location on the device: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. (4) Where a device is constructed in two or more sections connected by wires and marketed together, the statement specified above is required to be affixed only to the main control unit. If the EUT is integrated within another device then a label affixed to the host shall also state, “Contains FCC ID: XXXXXX” (5) When the device is so small or for such use that it is not practicable to place the statement specified under paragraph (a) of this section on it, the information required by this paragraph shall be placed in a prominent location in the instruction manual or pamphlet supplied to the user or, alternatively, shall be placed on the container in which the device is marketed. However, the FCC identifier or the unique identifier, as appropriate, must be displayed on the device. 9.2 IC Labeling Requirements As per IC RSS-Gen §5.2, Equipment subject to certification under the applicable RSS, shall be permanently labeled on each item, or as an inseparable combination. The label must contain the following information for full compliance: (a) the certification number, prefixed by the term “IC:”; (b) the manufacturer's name, trade name or brand name; and (c) a model name or number. Equipment for which a certificate has been issued is not considered certified if it is not properly labeled. The information on the Canadian label can be combined with the manufacturer’s other labeling requirements. If the device size is too small to put a label, the label can be included in the user’s manual, upon agreement with Industry Canada. The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 23 of 27 FCC Part15.231 & IC RSS-210 Report The certification number shall appear as follows: IC: XXXXXX-YYYYYYYY Where: • "XXXXXX-YYYYYYYY" is the certification number • "XXXXXX" is the Certificate Holder Number (CHN), made of at most 6 alphanumeric characters (A-Z, 0-9), assigned by Industry Canada; and • "YYYYYYYY" is the Unique Product Number (UPN), made of at most 11 alphanumeric characters (A-Z, 0-9) assigned by the applicant. Note 1: The term "IC" before the equipment certification number only signifies that the Industry Canada technical specifications were met. Note 2: Note 1 shall be conspicuously placed in the equipment user manual. Note 3: Permitted alphanumeric characters used in the CHN and UPN are limited to capital letters (A-Z) and digits (0- 9). Other characters, such as "#", "/" or "-", shall not be used. 9.3 FCC ID & IC Label Contents 9.4 FCC ID and IC Label Location Label here

The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 27 of 27 FCC Part15.231 & IC RSS-210 Report 11.3 EUT – Main Board Front View 11.4 EUT – Main Board Rear View ***** END OF REPORT *****

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by NVLAP*, NIST, or any agency of the Federal Government. * This report may contain data that are not covered by the NVLAP accreditation and are marked with an asterisk “*” (Rev.2) FCC PART 15, SUBPART C IC RSS-210, ISSUE 7 TEST AND MEASUREMENT REPORT For The Coast Distribution System, Inc. 7930 Sw Burns Way, Unit C, Wilsonville, OR 97070, USA FCC ID: XV5KE888 IC: 6282B-KE888 Report Type: Original Report Product Type: Remote Starter Test Engineer: Kevin Li Report Number: R0912041-231 Report Date: 2010-03-08 Reviewed By: Boni Baniqued EMC/RF Supervisor Prepared By: (84) Bay Area Compliance Laboratories Corp. 1274 Anvilwood Ave. Sunnyvale, CA 94089, U.S.A. Tel: (408) 732-9162 Fax: (408) 732-9164 The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 2 of 27 FCC Part15.231 & IC RSS-210 Report TABLE OF CONTENTS 1 GENERAL INFORMATION ............................................................................................................................. 5 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) .......................................................................... 5 1.2 MECHANICAL DESCRIPTION.............................................................................................................................. 5 1.3 EUT PHOTO....................................................................................................................................................... 5 1.4 OBJECTIVE......................................................................................................................................................... 5 1.5 RELATED SUBMITTAL(S)/GRANT(S)................................................................................................................... 5 1.6 TEST METHODOLOGY........................................................................................................................................ 6 1.7 MEASUREMENT UNCERTAINTY.......................................................................................................................... 6 1.8 TEST FACILITY................................................................................................................................................... 6 2 SYSTEM TEST CONFIGURATION................................................................................................................ 7 2.1 JUSTIFICATION................................................................................................................................................... 7 2.2 EUT EXERCISE SOFTWARE................................................................................................................................7 2.3 SPECIAL ACCESSORIES....................................................................................................................................... 7 2.4 EQUIPMENT MODIFICATIONS............................................................................................................................. 7 2.5 SPECIAL EQUIPMENT......................................................................................................................................... 7 2.6 LOCAL SUPPORT EQUIPMENT............................................................................................................................. 7 2.7 EUT INTERNAL CONFIGURATION DETAILS........................................................................................................ 7 2.8 EXTERNAL I/O CABLING LIST AND DETAILS..................................................................................................... 7 3 SUMMARY OF TEST RESULTS ..................................................................................................................... 8 4 FCC §15.203 & IC RSS-GEN §7.1.4 – ANTENNA REQUIREMENT ........................................................... 9 4.1 APPLICABLE STANDARD.................................................................................................................................... 9 4.2 TEST RESULT..................................................................................................................................................... 9 5 FCC §15.231(A)(1) & IC RSS-210 §A1.1.1 – DEACTIVATION TIME ....................................................... 10 5.1 APPLICABLE STANDARD.................................................................................................................................. 10 5.2 TEST EQUIPMENT LIST AND DETAILS.............................................................................................................. 10 5.3 TEST SETUP DIAGRAM..................................................................................................................................... 10 5.4 TEST ENVIRONMENTAL CONDITIONS............................................................................................................... 10 5.5 TEST RESULT................................................................................................................................................... 11 6 FCC §15.231(B) & IC RSS-210 §A1.1.2 – FIELD STRENGTH OF EMISSIONS ...................................... 12 6.1 APPLICABLE STANDARD.................................................................................................................................. 12 6.2 TEST SETUP..................................................................................................................................................... 14 6.3 TEST EQUIPMENT LIST AND DETAILS......................................................................…

Text truncated - open the document above for the full version.

The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 24 of 27 FCC Part15.231 & IC RSS-210 Report 10 EXHIBIT B - TEST SETUP PHOTOGRAPHS 10.1 Radiated Emissions - Front View 10.2 Radiated Emissions - Rear View (Below 1 GHz) The Coast Distribution System, Inc. FCC ID: XV5KE888, IC: 6282B-KE888 Report Number: R0912041-231 Page 25 of 27 FCC Part15.231 & IC RSS-210 Report 10.3 Radiated Emissions - Rear View (Above 1 GHz)