Y77IPRF1104Wireless iPod Controller

Product Code IPRF Transmission Radio Frequency Frequency 433.92 MHz Operating Range up to 10 metres Battery CR2032 3V iPod Connection 30 pin dock connector Compliance FCC part 15C, CE, RoHS iPod Compatiblity All iPods with dock connector TECHNICAL SPECIFICATION wearable technology Wireless iPod Controller + + IPRF IPRF iPod Compatibility CONNECTED-wear, by Fibretronic, is a unique system of integrated controls in garments, bags and other soft goods. CONNECTED-wear Keypad and Joysticks can control audio players, mobile phones and other personal electronics. Just select the CONNECTED-wear module of your choice and get CONNECTED.... The IPRF modules allow you to wirelessly control your iPod from your garment, bag or glove. Plug the IPRF Transmitter Module into any product that has a CONNECTED-wear Keypad or Joystick controller. The IPRF Receiver Module is compatible with all iPod players except; iPod 1st Generation, iPod 2nd Generation and iPod Shuffle. This is a ‘Made for iPod’ licensed product. www.connectedwear.com iPod is a trademark of Apple Inc., registered in the U.S. and other countries CONNECTED-wear and Fibretronic are trademarks of Fibretronic Limited Wireless iPod Controller - + - - OPERATING RANGE The Transmitter Module will wirelessly transmit the commands from the keypad or joystick controller up to a maximum distance of 10 metres from the Receiver Module. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. IPRF www.connectedwear.com CONNECTION INSTRUCTIONS CONNECTED-wear Joystick or Keypad Controller iPod Earphones Dock Connector Jack Plug 2 For further information, product support and warranty advice go to www.connectedwear.com Connect any CONNECTED-wear Keypad or Joystick controller to the Transmitter Module using the Jack Plug. Connect the Receiver Module to your iPod using the Dock Connector. fibretronic Transmitter Module Receiver Module CARE INSTRUCTIONS Do Not Wash Transmitter or Receiver Modules OPERATING INSTRUCTIONS Press to skip forward to the next track. Press and hold to fast forward through a track. To operate the Keypad controller simply press the flexible buttons. To operate the Joystick controller toggle the flexible stick to the right, to the left, upwards or downwards. Push the Joystick in the centre for Play/Pause. Please follow the garment manufacturer’s care instructions listed on the apparel item. DO NOT WASH OR DRY CLEAN THE TRANSMITTER OR RECEIVER MODULES. Disconnect and remove the Transmitter and Receiver modules from the garment before cleaning. After washing, ensure the Keypad and Joystick controllers are thoroughly dry before use. Press to start and stop the music. Press and hold to turn off the iPod. PLAY / PAUSE FAST FORWARD Press to skip backwards to the previous track. Press and hold to rewind through a track. REWIND Press to increase the volume. VOLUME Press to decrease the volume. VOLUME + fibretronic Wireless iPod Controller With normal use the CR2032 3V battery in the Transmitter Module should last for the lifetime of the product. The battery is rated for operating temperatures between -10 C to +50 C. Should the battery need replacement, undo the snap fastener on the Transmitter Module case to access the battery compartment. Slide out the old battery and insert a new battery. Close the snap fastener. INSTRUCTIONS FOR CHANGING THE BATTERY IN THE TRANSMITTER MODULE OO open cover at snap fastener Transmitter Module CR2032 slide out old battery from holder and insert new battery Transmitter Module

Neutron Engineering Inc. Project No.: 1101C161 Page 2 of 19 Model name: IPRF-FIB 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 2 of 19 Model name: IPRF-FIB 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 8 of 19 Model name:ONCF105 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 8 of 19 Model name:ONCF105 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 13 of 19 Model name: IPRF 1101C161 1101 C161 Neutron Engineering Inc. Project No.: 1101C161 Page 13 of 19 Model name: IPRF 1101C161 1101 C161 Neutron Engineering Inc. Project No.: 1101C161 Page 14 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 14 of 19 1101C161 1101C161

Neutron Engineering Inc. Project No.: 1101C161 Page 4 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 4 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 6 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 6 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 5 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 5 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 7 of 19 1101C161 1101C161 Neutron Engineering Inc. Project No.: 1101C161 Page 7 of 19 1101C161 1101C161

Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 2 of 33 Declaration Neutron represents to the client that testing is done in accordance with standard procedures as applicable and that test instruments used has been calibrated with the standards traceable to National Measurement Laboratory (NML) of R.O.C., or National Institute of Standards and Technology (NIST) of U.S.A. Neutron's reports apply only to the specific samples tested under conditions. It is manufacture’s responsibility to ensure that additional production units of this model are manufactured with the identical electrical and mechanical components. Neutron shall have no liability for any declarations, inferences o r generalizations drawn by the client or others from Neutron issued reports. Neutron’s reports must not be used by the client to claim product endorsement by the authorities or any agency of the Government. This report is the confidential property of the client. As a mutual protection to the clients, the public and Neutron-self, extracts from the test report shall not be reproduced except in full with Neutron’s authorized written approval. Neutron’s laboratory quality assurance procedures are in compliance with the ISO Guide 17025 requirements, and accredited by the conformity assessment authorities listed in this test report. Limitation For the use of the authority's logo is limited unless the Test Standard(s)/Scope(s)/Item(s) mentioned in this test report is (are) included in the conformity assessment authorities acceptance respective. Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 3 of 33 Table of Contents Page 1 . CERTIFICATION 5 2 . SUMMARY OF TEST RESULTS 6 2.1 TEST FACILITY 7 2.2 MEASUREMENT UNCERTAINTY 7 3 . GENERAL INFORMATION 8 3.1 GENERAL DESCRIPTION OF EUT 8 3.2 DESCRIPTION OF TEST MODES 9 3.3 BLOCK DIGRAM SHOWING THE CONFIGURATION OF SYSTEM TESTED 10 3.4 DESCRIPTION OF SUPPORT UNITS 10 4 . EMC EMISSION TEST 11 4.1 CONDUCTED EMISSION MEASUREMENT 11 4.1.1 POWER LINE CONDUCTED EMISSION LIMITS 11 4.1.2 MEASUREMENT INSTRUMENTS LIST 11 4.1.3 TEST PROCEDURE 12 4.1.4 DEVIATION FROM TEST STANDARD 12 4.1.5 TEST SETUP 12 4.1.6 EUT OPERATING CONDITIONS 12 4.1.7 TEST RESULTS 13 4.2 RADIATED EMISSION MEASUREMENT 14 4.2.1. FIELD STRENGTH OF FUNDAMENTAL EMISSIONS MEASUREMENT LIMIT 14 4.2.2. MEASURING INSTRUMENTS AND SETTING (FIELD STRENGTH OF FUNDAMENTAL EMISSIONS) 14 4.2.3 RADIATED EMISSIONS MEASUREMENT 15 4.2.4. DWELL TIME OF PERIODIC OPERATION MEASUREMENT 17 4.2.5. MEASUREMENT INSTRUMENTS LIST 19 4.2.6. TEST PROCEDURE 19 4.2.7. DEVIATION FROM TEST STANDARD 19 4.2.8. TEST SETUP 20 4.2.9. EUT OPERATING CONDITIONS 20 4.3. TEST RESULTS (9KHz-30MHz) 20 4.3.1 TEST RESULTS(BETWEEN 30 – 1000 MHz) 21 4.3.2 TEST RESULTS (ABOVE 1000 MHz) 25 5. 20dB SPECTRUM BANDWIDTH MEASUREMENT 29 5.1.MEASURING INSTRUMENTS AND SETTING 29 Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 4 of 33 Table of Contents Page 5.2.TEST PROCEDURES 29 5.3. TEST SETUP LAYOUT 29 5.4. TEST DEVIATION 29 5.5. EUT OPERATION DURING TEST 29 5.6. TEST RESULT 30 6. TIMING TESTING 31 6.1.MEASURING INSTRUMENTS AND SETTING 31 6.2.TEST PROCEDURES 31 6.3. TEST SETUP LAYOUT 31 6.4. TEST DEVIATION 31 6.5. EUT OPERATION DURING TEST 31 6.6. TEST RESULT 32 7. EUT TEST PHOTO 33 Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 5 of 33 1. CERTIFICATION E q u i p m e n t : Wireless iPod Controller Trade Name : N/A Model Name. : IPRF;IPRF-FIB;ONCF105 A p p l i c a n t : Fibretronic Limited Date of Test : Jan. 24, 2011 ~ Feb. 15, 2011 T e s t I t e m : ENGINEERING SAMPLE Standards : FCC Part15, Subpart C(15.231)/ ANSI C63.4 : 2003 The above equipment has been tested and found compliance with the requirement of the relative standards by Neutron Engineering Inc. EMC Laboratory. The test data, data evaluation, and equipment configuration contained in our test report (Ref No. NEI-FICP-1-1101C161) were obtained utilizing the test procedures, test instruments, test sites that has been accredited by the Authority of NVLAP and TAF according to the ISO-17025 quality assessment standard and technical standard(s). Test result included in this report is only for the IPRF-FIB-TX Sample part of the product. Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 6 of 33 2. SUMMARY OF TEST RESULTS Test procedures according to the technical standards: FCC Part15, Subpart C (15.231) Standard Section Test Item Judgment Remark 15.207 Conducted Emission - Note(1)/(2) 15.209 & 15.231(e) Radiated Spurious EmissionPASS 15.231(c) 20dB Occupied Bandwidth Measurement PASS Remark: (1)” N/A” denotes test is not applicable in this Test Report (2) The EUT is used new battery. Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 7 of 33 2.1 TEST FACILITY The test facilities used to collect the test data in this report is DG-CB03 at the location of No.3,Jinshagang 1st Road, ShiXia, Dalang Town, Dong Guan, China.523792 Neutron's test firm number for FCC 319330 2.2 MEASUREMENT UNCERTAINTY Where relevant, the following measurement uncertainty levels have been estimated for tests performed on the EUT as specified in CISPR 16-4-2: The reported uncertainty of measurement y ± U，where expended uncertainty U is based on a standard uncertainty multiplied by a coverage factor of k=2，providing a level of confidence of approximately 95 %。 A. Conducted Measurement : Test Site Method Measurement Frequency Range U，(dB) NOTE DG-C03 CISPR 150 KHz ~ 30MHz 1.94 B. Radiated Measurement : Test Site Method Measurement Frequency Range Ant. H / V U，(dB) NOTE 30MHz ~ 200MHz V 3.82 30MHz ~ 200MHz H 3.60 200MHz ~ 1,000MHz V 3.86 DG-CB03 CISPR 200MHz ~ 1,000MHz H 3.94 Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 8 of 33 3. GENERAL INFORMATION 3.1 GENERAL DESCRIPTION OF EUT Equipment Wireless iPod Controller Trade Name N/A Model Name. IPRF;IPRF-FIB;ONCF105 OEM Brand/Model Name N/A Model Difference Different are appearance and with of jack plug. The RF Modu…

Text truncated - open the document above for the full version.

Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 33 of 33 7. EUT TEST PHOTO Radiated Measurement Photos TX Mode Neutron Engineering Inc. Report No.: NEI-FICP-1-1101C161 Page 33 of 33 7. EUT TEST PHOTO Radiated Measurement Photos TX Mode