Y8JACRWN10002A.C. Ryan PLAYON! Essential Wireless-N 300mbps USB Adapter

ACR-WN10002 A.C.Ryan PLAYON! Essential Wireless-N 300mbps USB Adapter A.C.Ryan Rev: 1.0.0 FCC STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC RF Radiation Exposure Statement: This device has been tested for compliance with FCC RF Exposure (SAR) limits in the typical laptop computer configuration and this device can be used in desktop or laptop computers with side mounted PCMCIA slots. This device cannot be used with handheld PDAs (personal digital assistants). This device and its antenna must not be co-located or operated in conjunction with any other antenna or transmitter. CE Mark Warning This is a class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. National restrictions This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below: Country Restriction Reason/remark Bulgaria None General authorization required for outdoor use and public service France Outdoor use limited to 10 mW e.i.r.p. within the band 2454-2483.5 MHz Military Radiolocation use. Refarming of the 2.4 GHz band has been ongoing in recent years to allow current relaxed regulation. Full implementation planned 2012 Italy None If used outside of own premises, general authorization is required Luxembourg None General authorization required for network and service supply(not for spectrum) Norway Implemented This subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-Ålesund Russian Federation None Only for indoor applications Note: Please don’t use the product outdoors in France. CONTENTS Package Contents.................................................................................................... 1 Chapter 1 Introduction......................................................................................... 2 1.1 Overview of the Product........................................................................................ 2 1.2 Features................................................................................................................ 2 1.3 LED Status............................................................................................................ 3 Chapter 2 Installation Guide................................................................................ 4 2.1 Hardware Installation............................................................................................. 4 2.2 Software Installation.............................................................................................. 4 2.2.1 Overview................................................................................................ 4 2.2.2 Software Installation for Windows XP.................................................... 4 2.2.3 Software Installation for Windows Vista................................................. 8 Chapter 3 Configuration..................................................................................... 13 3.1 General Status.................................................................................................... 13 3.2 Profile Management............................................................................................ 14 3.2.1 Add or Edit a Configuration Profile....................................................... 15 3.2.2 Remove a configuration profile............................................................. 20 3.2.3 Duplicate a configuration file................................................................ 21 3.2.4 Set default configuration profile............................................................ 21 3.3 Available Network................................................................................................ 21 3.4 Status.................................................................................................................. 22 3.5 Statistics.............................................................................................................. 23 3.6 Wi-Fi Protect Setup............................................................................................. 24 3.6.1 PIN....................................................................................................... 25 3.6.2 Question-Answer Method..................................................................... 26 3.7 Access Point Mode...............................…

Text truncated - open the document above for the full version.

R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 14-1 14. PHOTOS OF THE EUT Figure 1 General Appearance of the EUT Figure 2 General Appearance of the EUT R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 14-2 Figure 3 General Appearance of the EUT Figure 4 General Appearance of the EUT R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 14-3 Figure 5 General Appearance of the EUT Figure 6 Inside of the EUT

R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 14-3 Figure 5 General Appearance of the EUT Figure 6 Inside of the EUT R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 14-4 Figure 7 Components Side of the PCB Figure 8 Components Side of the PCB R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 14-5 Figure 9 Components Side of the PCB Figure 10 Components Side of the PCB

Report No.: RZA1104-0523SAR01R1 TESTING No. L2264 OET 65 TEST REPORT Product Name A.C.Ryan PLAYON! Essential Wireless-N 300mbps USB Adapter Model ACR-WN10002 FCC ID Y8JACRWN10002 Client AC Ryan Asia Pacific Pte Ltd TA Technology (Shanghai) Co., Ltd. GENERAL SUMMARY Product Name A.C.Ryan PLAYON! Essential Wireless-N 300mbps USB Adapter Model ACR-WN10002 FCC ID Y8JACRWN10002 Report No. RZA1104-0523SAR01R1 Client AC Ryan Asia Pacific Pte Ltd Manufacturer AC Ryan Asia Pacific Pte Ltd Reference Standard(s) IEEE Std C95.1, 1999: IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz. SUPPLEMENT C Edition 01-01 to OET BULLETIN 65 Edition 97-01 June 2001 including DA 02-1438, published June 2002: Evaluating Compliance with FCC Guidelines for Human Exposure to Radio frequency Electromagnetic Fields Additional Information for Evaluation Compliance of Mobile and Portable Devices with FCC Limits for Human Exposure to Radio frequency Emissions. KDB 248227 D01 SAR meas for 802 11 a b g v01r02: SAR Measurement Procedures for 802.11a/b/g Transmitters. KDB 447498 D02 SAR Procedures for Dongle Xmtr v02: SAR Measurement Procedures for USB Dongle Transmitters. Conclusion This portable wireless equipment has been measured in all cases requested by the relevant standards. Test results in Chapter 7 of this test report are below limits specified in the relevant standards. General Judgment: Pass (Stamp) Date of issue: April 22 nd , 2011 Comment The test result only responds to the measured sample. Approved by Yang Weizhong Revised by Ling Minbao Performed by Du Ruwei TA Technology (Shanghai) Co., Ltd. Test Report Report No. RZA1104-0523SAR01R1 Page 3 of 68 TABLE OF CONTENT 1. General Information ........................................................................................................................ 5 1.1. Notes of the Test Report.......................................................................................................... 5 1.2. Testing Laboratory ................................................................................................................... 5 1.3. Applicant Information ............................................................................................................... 6 1.4. Manufacturer Information ......................................................................................................... 6 1.5. Information of EUT................................................................................................................... 7 1.6. The Maximum SAR 1g Values and Power of each tested Mode................................................ 8 1.7. Test Date ................................................................................................................................. 8 2. Operational Conditions during Test ................................................................................................. 9 2.1. General Description of Test Procedures .................................................................................. 9 2.2. Position of Module in Portable Devices.................................................................................. 10 2.3. Picture of Host Product .......................................................................................................... 11 3. SAR Measurements System Configuration ................................................................................... 13 3.1. SAR Measurement Set-up .....................................................................................................13 3.2. DASY5 E-field Probe System ................................................................................................ 14 3.2.1. EX3DV4 Probe Specification .......................................................................................... 14 3.2.2. E-field Probe Calibration ................................................................................................. 15 3.3. Other Test Equipment ............................................................................................................15 3.3.1. Device Holder for Transmitters ....................................................................................... 15 3.3.2. Phantom .........................................................................................................................16 3.4. Scanning Procedure ..............................................................................................................16 3.5. Data Storage and Evaluation ................................................................................................. 18 3.5.1. Data Storage................................................................................................................... 18 3.5.2. Data Evaluation by SEMCAD ......................................................................................... 18 3.6. System Check........................................................................................................................ 21 3.7. Equivalent Tissues ................................................................................................................. 22 4. Laboratory Environment................................................................................................................ 22 5. Characteristics of the Test ............................................................................................................. 23 5.1. Applicable Limit Regulations .................................................................................................. 23 5.2. Applicable Measurement Standards...................................................................................... 23 6. Conducted Output Power Measurement....................................................................................... 24 6.1. Summary ...................................................…

Text truncated - open the document above for the full version.

R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 FCC PART 15C TEST REPORT FOR CERTIFICATION On Behalf of AC Ryan Asia Pacific Pte Ltd A.C. Ryan PLAYON! Essential Wireless-N 300mbps USB Adapter Model No.: ACR-WN10002 FCC ID: Y8JACRWN10002 Prepared for : AC Ryan Asia Pacific Pte Ltd 60 Kaki Bukit Place#01-12(Lobby A), Eunos Techpark Singapore 415979, Singapore Prepared By : Audix Technology (Shenzhen) Co., Ltd. No. 6, Ke Feng Rd., 52 Block, Shenzhen Science & Industrial Park, Nantou, Shenzhen, Guangdong, China Tel: (0755) 26639496 Report Number ： ACS-F11073 Date of Test ： Mar.01~Apr.04, 2011 Date of Report ： Apr.07, 2011 R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 TABLE OF CONTENTS Description Page 1. SUMMARY OF STANDARDS AND RESULTS .......................................................... 1-1 1.1. Description of Standards and Results .................................................................................. 1-1 2. GENERAL INFORMATION ......................................................................................... 2-1 2.1. Description of Device (EUT) ............................................................................................... 2-1 2.2. Test Information ................................................................................................................... 2-2 2.3. Tested Supporting System Details ....................................................................................... 2-3 2.4. Block diagram of connection between the EUT and simulators .......................................... 2-3 2.5. Test Facility ......................................................................................................................... 2-4 2.6. Measurement Uncertainty (95% confidence levels, k=2) .................................................... 2-4 3. POWER LINE CONDUCTED EMISSION TEST ....................................................... 3-1 3.1. Test Equipments ................................................................................................................... 3-1 3.2. Block Diagram of Test Setup ............................................................................................... 3-1 3.3. Power Line Conducted Emission Test Limits ...................................................................... 3-1 3.4. Configuration of EUT on Test ............................................................................................. 3-2 3.5. Operating Condition of EUT ................................................................................................ 3-2 3.6. Test Procedure ...................................................................................................................... 3-2 3.7. Power Line Conducted Emission Test Results .................................................................... 3-2 4. RADIATED EMISSION TEST ...................................................................................... 4-1 4.1. Test Equipment .................................................................................................................... 4-1 4.2. Block Diagram of Test Setup ............................................................................................... 4-1 4.3. Radiated Emission Limit ...................................................................................................... 4-2 4.4. EUT Configuration on Test .................................................................................................. 4-3 4.5. Operating Condition of EUT ................................................................................................ 4-3 4.6. Test Procedure ...................................................................................................................... 4-3 4.7. Radiated Emission Test Results ........................................................................................... 4-4 5. CONDUCTED SPURIOUS EMISSIONS.................................................................... 5-81 5.1. Test Equipment .................................................................................................................. 5-81 5.2. Limit ................................................................................................................................... 5-81 5.3. Test Procedure .................................................................................................................... 5-81 5.4. Test result ........................................................................................................................... 5-81 6. BAND EDGE COMPLIANCE TEST .......................................................................... 6-98 6.1. Test Equipment .................................................................................................................. 6-98 6.2. Limit ................................................................................................................................... 6-98 6.3. Test Produce ....................................................................................................................... 6-98 6.4. Test Results ........................................................................................................................ 6-98 7. 6dB Bandwidth Test ..................................................................................................... 7-131 7.1. Test Equipment ................................................................................................................ 7-131 7.2. Limit ................................................................................................................................. 7-131 7.3. Test Procedure .................................................................................................................. 7-131 7.4. Test …

Text truncated - open the document above for the full version.

R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 13-1 13. PHOTOGRAPH OF TEST 13.1.Photos of Power Line Conducted Emission Test R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 13-2 13.2.Photos of Radiated Emission Test R AUDIX Technology (Shenzhen) Co., Ltd. FCC ID:Y8JACRWN10002 page Audix Technology (Shenzhen) Co., Ltd. Report No. ACS-F11073 13-3 (Above 1000MHz)