YHK-PST017Power Board Wireless Controller

Product manual 1, safety tips: 1.1 induction module belong to wearing parts, please do not squeeze or collision, so as not to affect the product normal use; 1.2 it is prohibited to use water or other liquid scrubbing, lest affect normal use of products. 2, Note: the product before use 2.1 before use, must confirm the product model is correct; 2.2 before use, must be in accordance with the requirements of specification steps to install the product; 2.3 before use, must be used according to the instruction manual steps. 3, product appearance Products are divided into three parts: the middle part of the module for launch, part on both ends for induction module. Figure 1 wireless gating annunciator contour Schematic diagram Figure 2 wireless gating annunciator style figure 4，Basic parameters of products： Input voltage/current/frequency: 3 V DC; The input power (W) : 0.06 W; Transmission frequency: 470.4 MHZ; 5, the working principle of the product： Wireless gating annunciator is divided into modules and two induction module, the signal device is installed in the door column position, before and after the door side are installed a magnet, the door shut, magnet close to the induction module, launch module outward at 470.4MHz frequency signal, the host receives the signal and decoding, then signals corresponding to the pedal controller, pedal controller to identify the door closed. On the other hand, the door open, the same way, pedal controller to identify the door open. 6, product instructions Wireless gating signal device is installed in the car column (as shown in figure 2), the magnet is installed in the car door. The door is closed, the magnet is opposite induction module; The door is open, the magnet from induction module. After the installation is complete, when open the door, the launch module signal the doors open, after receiving module receives the signal, the corresponding action; When closing the door, the launch module signal the doors closed, after receiving module receives the signal, the corresponding action; So as to realize the motion control of the product. Figure 3 installation schematic diagram 7, product fault handling 7.1 if the normal signal, it is need to check whether the product installation is wrong, then check whether the battery failure; 7.2 if there is a product appearance is damaged, please contact your local dealer for replacement. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CONFIDENTIALITY REQUEST for Certification Service in USA Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21048 <March 23, 2015> TO WHOM IT MAY CONCERN Pursuant to Paragraphs §0.457 and 0.459 of the Commission’s Rules (47 C.F.R.) and Section §552(b)(4) of the Freedom of Information Act, we requests confidentiality for the following products: FCC ID Model name YHK-PST017 PST01.7 For the product stated above, we request permanent confidentiality for exhibits which contain Operational Description, Block Diagram, Schematics, Parts Lists or Tune Up Information. The above exhibits contain our trade secrets and proprietary information that could be of benefit to our competitors. If you have any questions, please feel free to contact me at the address shown below. Sincerely, Name: qiwei lu / Engineer Company: T-max (Hangzhou) Industrial Co.,Ltd Address: NO.5, Road 5, Dongzhou Industrial Area,Fuyang City,Hangzhou,China Phone: +86-0571-87191166 Fax: +86- 0571-87191088 Email: [email protected]

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 5 1. EXTERIOR PHOTOGRAPHS Fig.1 Fig.2 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 2 of 5 Fig.3 Fig.4 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 3 of 5 Fig.5 Fig.6 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 4 of 5 Fig.7 Fig.8 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 5 of 5 Fig.9 Fig.10

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd. Page 1 of 1 LABEL AND LOCATION Size: L1.20cm*W1.0cm Material: Tagboard Glue: adhesive sticker Font color: White Label color: Black Power Board Wireless Controller Model No.: PST01.7 FCC ID: YHK-PST017 Label Location

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 6 1. INTERIOR PHOTOGRAPHS Fig.1 Fig.2 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 2 of 6 Fig.3 Fig.4 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 3 of 6 Fig.5 Fig.6 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 4 of 6 Fig.7 Fig.8 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 5 of 6 Fig.9 Fig.10 Antenna SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 6 of 6 Fig.11 Fig.12

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID:YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 23 FCC TEST REPORT For T-MAX(HANGZHOU) INDUSTRIAL CO.,LTD Power Board Wireless Controller Model No.: PST01.7 Additional Model No.: PST02.7、PST03.7、PST04.7、PST05.7、PST06.7 Prepared for : T-MAX(HANGZHOU) INDUSTRIAL CO.,LTD Address : N0 5,Road 5,Dong zhou Industial Area Fuyang City,Hangzhou,China Prepared by : Shenzhen LCS Compliance Testing Laboratory Ltd. Address : 1/F., Xingyuan Industrial Park, Tongda Road, Bao’an Avenue, Bao’an District, Shenzhen, Guangdong, China Tel : (+86)755-82591330 Fax Web Mail : : : (+86)755-82591332 www.LCS-cert.com [email protected] Date of receipt of test sample : February 26, 2015 Number of tested samples : 1 Serial number : Prototype Date of Test : February 26, 2015– March 06, 2015 Date of Report : March 06, 2015 SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID:YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 2 of 23 FCC TEST REPORT FCC CFR 47 PART 15 C(15.231): 2014 Report Reference No. .............. : LCS1501170661E Date of Issue ................................ : March 06, 2015 Testing Laboratory Name ......... : Shenzhen LCS Compliance Testing Laboratory Ltd. Address ........................................ : 1/F., Xingyuan Industrial Park, Tongda Road, Bao’an Avenue, Bao’an District, Shenzhen, Guangdong, China Testing Location/ Procedure ........ : Full application of Harmonised standards ■ Partial application of Harmonised standards □ Other standard testing method □ Applicant’s Name ....................... : T-MAX(HANGZHOU) INDUSTRIAL CO.,LTD Address ........................................ : N0 5,Road 5,Dong zhou Industial Area Fuyang City,Hangzhou,China Test Specification Standard ....................................... : FCC CFR 47 PART 15 Subpart C : 2014 RSS-210 Issue 8 Test Report Form No. ................ : LCSEMC-1.0 TRF Originator ............................ : Shenzhen LCS Compliance Testing Laboratory Ltd. Master TRF .................................. : Dated 2011-03 Shenzhen LCS Compliance Testing Laboratory Ltd. All rights reserved. This publication may be reproduced in whole or in part for non-commercial purposes as long as the Shenzhen LCS Compliance Testing Laboratory Ltd. is acknowledged as copyright owner and source of the material. Shenzhen LCS Compliance Testing Laboratory Ltd. takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Test Item Description. ............... : Power Board Wireless Controller Trade Mark .................................. : T-MAX Model/ Type reference ................. : PST01.7 Ratings ......................................... : DC 3V 230mA by Battery Result ......................................... : Positive Compiled by: Supervised by: Approved by: Dick Su/ File administrators Danny Huang/ Technique principal Gavin Liang/ Manager SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID:YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 3 of 23 FCC--TEST REPORT Test Result Positive The test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. Test Report No. : LCS1501170661E March 06, 2015 Date of issue Type / Model........................... : PST01.7 EUT......................................... : Power Board Wireless Controller Applicant............................... : T-MAX(HANGZHOU) INDUSTRIAL CO.,LTD Address.................................. : N0 5,Road 5,Dong zhou Industial Area Fuyang City,Hangzhou,China Telephone............................... : / Fax.......................................... : / Manufacturer........................ : T-MAX(HANGZHOU) INDUSTRIAL CO.,LTD Address................................... : N0 5,Road 5,Dong zhou Industial Area Fuyang City,Hangzhou,China Telephone............................... : / Fax.......................................... : / Factory................................... : T-MAX(HANGZHOU) INDUSTRIAL CO.,LTD Address................................... : N0 5,Road 5,Dong zhou Industial Area Fuyang City,Hangzhou,China Telephone............................... : / Fax.......................................... : / SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID:YHK-PST017 Report No.: LCS1501170661E This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 4 of 23 TABLE OF CONTENTS 1. GENERAL INFORMATION .................................................................................................................................. 5 1.1. DESCRIPTION OF DEVICE (EUT) ........................................................................................................................... 5 1.2. OBJECTIVE ............................................................................................................................................................ 5 1.3. ENVIRONMENTAL CONDITIONS............................................................................................................................. 5 1.4. HOST SYSTEM CONFIGURATION LIST AND DETAILS ............................................................................................. 6 1.5. EXTERNAL I/O PORT ............................................................................................................................................. 6 1.6. EUT OPERATION .............................…

Text truncated - open the document above for the full version.

SHENZHEN LCS COMPLIANCE TESTING LABORATORY LTD. FCC ID: YHK-PST017 Report No.: LCS1501170661E _______________________________________________________________________________________________ This report shall not be reproduced except in full, without the written approval of Shenzhen LCS Compliance Testing Laboratory Ltd.. Page 1 of 1 1. TEST SETUP PHOTOGRAPHS 1.1. Photo of Radiated Emissions Measurement (X Position) Fig.1 Fig.2