YW5VTA07027 inch Tablet PC

Shenzhen Firstview Electronic Co. Ltd. 3-4/F, Block B, Huafeng 1st Technology Zone, Baoan Main Road, Baoan District, Shenzhen, Chin a DATE :2014-11-07 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 Attn: Director of Certification Authority to Act as Agent On our behalf, I appoint Kevin Yu of Shenzhen EBO Technology Co., Ltd. to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in the Federal Communications Commission’s regulations will have affixed to it a label identical to that submitted for approval with this application. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with Shenzhen Firstview Electronic Co. Ltd. And 3-4/F, Block B, Huafeng 1st Technology Zone, Baoan Main Road, Baoan District, Shenzhen, China Dated this / Day of 7/11/2014 / Agency agreement expiration date: 6/11/2015 By: Qu yang Signature Printed Title: manager On behalf of : Shenzhen Firstview Electronic Co. Ltd. Telephone: +86-755-29081735

Shenzhen Firstview Electronic Co. Ltd. 3-4/F, Block B, Huafeng 1st Technology Zone, Baoan Main Road, Baoan District, Shenzhen, China DATE :2014-11-07 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: YW5VTA0702 Product Name: 7 inch Tablet PC Request for Long-term Confidentiality Pursuant to Sections 0.457 and 0.459 of the commission rules, we hereby request that the following documents be held confidential long term:  Block diagram  Schematics  Operational Description These documents contain detailed system and equipment description and related information about the product which Shenzhen Firstview Electronic Co. Ltd. considers to be proprietary, confidential, and a custom design and, otherwise would not release to the general public. Since this design is a basis from which future technological products will evolve, Shenzhen Firstview Electronic Co. Ltd. considers this information to be of benefit to its competitors, and that the disclosure of information in these documents would give competitors an unfair advantage in the market Dated this / Day of 10/31/2014 / By: Qu yang Signature Printed Title: manager On behalf of : Shenzhen Firstview Electronic Co. Ltd. Telephone: +86-755-29081735

Differences Declaration To whom concern, We, Shenzhen Firstview Electronic Co. Ltd. hereby declares: The product model(s) VTA0702, VTA0702E, M720-B, are identical in the PCB layout, interior structure and electrical circuits with the product model VTA0702, the only differences are the model name for commercial purpose. Authorized signature: Position: Manager Date: 2014/11/7

External Photos of EUT Sample

FCC ID:YW5VTA0702 This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received,14 including interference that may cause undesired operation.

Internal Photos of EUT Sample

FCC ID: YW5VTA0702 The device has a standalone transmission. According to KDB 447498 section 4.3.1, the 1-g SAR test exclusion thresholds at test separation distances≤ 50 mm are determined by: [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)]·[√f(GHz)] ≤ 3.0 The maximum tune-up limit power is 7.88dBm(6.14mW) @ 2.412GHz For the head and body SAR, use 5mm as the conservative minimum test separation distance, [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)]·[√f(GHz)] =1.906≤ 3.0 So standalone SAR measurements are not required for both head and body. Remark: The product 7 inch Tablet PC(Model:VTA0702, FCC ID:YW5VTA0702) is electrically identical with t he product 7 inch Tablet PC(Model:VTA0701, FCC ID:YW5VTA0701). In that case, the data of VTA0702 is same to the data of VTA0701.

Shenzhen EBO Technology Co., Ltd . 1-4F, Huafeng Science Park, Xin’an Sixth Road, 82 th District, Bao’an, Shenzhen, China. Telephone: +86-755-29451282, Fax: +86-755-22639141 Report No.: EBO1410083-E307 Page 1 of 57 Authorized Signature: Kevin Yu Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the EBO product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of EBO International Electrical Approvals or testing done by EBO International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by EBO International Electrical Approvals in writing. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” FCC Report (WIFI) Applicant: Shenzhen Firstview Electronic Co. Ltd. Address of Applicant: 3-4/F, Block B, Huafeng 1st Technology Zone Baoan Main Road, Baoan District, Shenzhen, China Equipment Under Test (EUT) Product Name: 7 inch Tablet PC Model No.: VTA0702, VTA0702E, M720-B FCC ID: YW5VTA0702 Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247:2013 Date of sample receipt: October 31, 2014 Date of Test: October 31, 2014 To November 6, 2014 Date of report issued: November 6, 2014 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. Shenzhen EBO Technology Co., Ltd . Report No.: EBO1410083-E307 Page 2 of 57 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.ebotek.cn and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.ebotek.cn . Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 2 Version Version No. Date Description 00 November 6, 2014 Original Prepared By: Date: November 6, 2014 Project Engineer Check By: Date: November 6, 2014 Reviewer Shenzhen EBO Technology Co., Ltd . Report No.: EBO1410083-E307 Page 3 of 57 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.ebotek.cn and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.ebotek.cn . Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only.” 3 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 VERSION ..................................................................................................................................................2 3 CONTENTS ..............................................................................................................................................3 4 TEST SUMMARY .....................................................................................................................................4 5 GENERAL INFORMATION ......................................................................................................................5 5.1 CLIENT INFORMATION.........................................................................................................................5 5.2 GENERAL DESCRIPTION OF EUT .........................................................................................................5 5.3 TEST MODE.........................…

Text truncated - open the document above for the full version.

TEST SETUP PHOTOGRAPHS 1. Radiated Emission Test Setup 2. Conducted Emission Test Setup