Z6U-AE1103RC-CSignal Pod or Signal N� Safe

MANUAL AE1103RC-C is my company's conventional remote control, 3 keys, With a pcb antenna, Low power consumption, meet the various aspects of the application. Scope: 1, Automobile, motorcycle alarm 2, Anti-theft alarm system. 3, A variety of remote control, electric curtains, roller shutter doors, car park Road illustrates control; Specifications: 1,Current: 2,Oscillation mode:Oscillation. 3,RF Frequency :433.92MHz Performance characteristics : 1,3 keys 2, High stability 3, Imported SMD components 4, The remote control will not transmit the command to receiver when multiple buttons are pressed down at the same time. 5,If no key is pressed, the remote control is in energy-saving state. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Reason for Amendment (current / obsolete) Revision History Approved Date From To Initial Release (current) 1.0 1.0 Nov-14-2006 Revised wording (current) 1.0 2.0 Sept–25-2007 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 2.0 2011-10-24 To: SIEMIC, INC. 2206 Ringwood Avenue, San Jose, CA 95131 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, Allegro Electronics Limited hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): (E．U．T)： Signal Pod or Signal N’ Safe (M/N)：AE1103RC-C, AE1103RC, AE1103RC-A, AE1103RC-B, AE1103RC-D, AE1103RC-E, AE1103RC-F, AE1103RC-G We affirm that between SIEMIC and Allegro Electronics Limited any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature： Client’s name / title： zhong shuquan Contact information / address： Allegro Electronics Limited / Room 10-11, 8/F, Favor Industrial Centre，2-6 Kin Hong Street, Kwai Chung, N.T, Hong Kong

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 2.0 2206 Ringwood Avenue San Jose, CA 95131 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Reason for Amendment (current / obsolete) Revision History Approved Date From To Initial Release (current) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 1.0 2.0 August – 11 - 2008 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 2.0 2011-10-24 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Confidentiality Request regarding application for certification of FCC ID: Z6U- AE1103RC-C We hereby request confidential treatment of information accompanying this application as outlined below: Block Diagram Schematic Diagram Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature Client’s name / title : zhong shuquan (Manager) Contact information / address: Room 10-11, 8/F, Favor Industrial Centre，2-6 Kin Hong Street, Kwai Chung, N.T, Hong Kong

Appearance photograph of EUT Appearance photograph of EUT

FCC ID LABEL FCC ID: Z6U-AE1103RC-C This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:1. This device may not cause harmful interference, and 2. This device must accept any interference received,including interference that may cause undesired operation. Label Location on EUT EUT Bottom View/ FCC ID Label Location

Inside photograph of EUT Main PCB photograph of EUT antenna Main PCB photograph of EUT

Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E FCC ID: Z6U-AE1103RC-C Page 1 FCC ID TEST REPORT FCC PART 15.231 for Signal Pod or Signal N’ Safe MODEL: AE1103RC-C, AE1103RC, AE1103RC-A, AE1103RC-B, AE1103RC-D, AE1103RC-E, AE1103RC-F, AE1103RC-G FCC ID: Z6U-AE1103RC-C Test Report Number: BCTC12070347E Issued Date: October 24, 2011 Issued for Allegro Electronics Limited Room 10-11, 8/F, Favor Industrial Centre，2-6 Kin Hong Street, Kwai Chung, N.T, Hong Kong Issued By: Shenzhen BCTC Technology Co., Ltd. B Building Room8518, Multiple Use Building of Economic Cooperative, Team one, Anle country, No. 44 of Xin’an Block, Bao’an Area, Shenzhen TEL: +86-755- 33865088 FAX: +86-755- 36933236 Note: This report shall not be reproduced except in full, without the written approval of Shenzhen BCTC Technology Co., Ltd. This document may be altered or revised by Shenzhen BCTC Technology Co., Ltd. personnel only, and shall be noted in the revision section of the document. The test results in the report only apply to the tested sample. Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E Page 2 of 22 FCC ID: Z6U-AE1103RC-C Revision History Of Report Rev. Issue No. Revisions Effect Page Revised By 00 BCTC12070347E Initial Issue ALL Lisa Zhu Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E Page 3 of 22 FCC ID: Z6U-AE1103RC-C TABLE OF CONTENTS 1 TEST CERTIFICATION .............................................................................................. 4 4 TEST METHODOLOGY ............................................................................................. 7 4.1. DECISION OF FINAL TEST MODE ...................................................................................... 7 4.2. EUT SYSTEM OPERATION ................................................................................................. 7 5 SETUP OF EQUIPMENT UNDER TEST .................................................................... 8 5.1. DESCRIPTION OF SUPPORT UNITS ................................................................................. 8 5.2. CONFIGURATION OF SYSTEM UNDER TEST .................................................................. 8 6 FACILITIES AND ACCREDITATIONS ...................................................................... 9 6.2 MEASUREMENT UNCERTAINTY ............................................................................. 9 7 TEST REQUIREMENTS ............................................................................................. 9 7.1. CONDUCTED EMISSION MEASUREMENT ........................................................................ 9 7.2. Radiation Emission Test ..................................................................................................... 12 7.3. 20B Bandwidth ................................................................................................................. 16 7.4 DEACTIVATION TESTING .................................................................................................. 18 7.5. Antenna requirement ........................................................................................................ 19 7.6 DUTY CYCLE ...................................................................................................................... 20 Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E Page 4 of 22 FCC ID: Z6U-AE1103RC-C 1 TEST CERTIFICATION Product: Signal Pod or Signal N’ Safe Model: AE1103RC-C, AE1103RC, AE1103RC-A, AE1103RC-B, AE1103RC-D, AE1103RC-E, AE1103RC-F, AE1103RC-G Applicant: Allegro Electronics Limited Room 10-11, 8/F, Favor Industrial Centre，2-6 Kin Hong Street, Kwai Chung, N.T, Hong Kong Factory: Allegro Electronics Limited Room 10-11, 8/F, Favor Industrial Centre，2-6 Kin Hong Street, Kwai Chung, N.T, Hong Kong Trade Mark: N/A Tested: October 18, 2011 - October 24, 2011 Test Voltage: DC 3V Battery Applicable Standards: FCC Part 15:Subpart C ANSI C63.4:2003 The above equipment has been tested by Shenzhen BCT Technology Co., Ltd. and found compliance with the requirements set forth in the technical standards mentioned above. The results of testing in this report apply only to the product/system, which was tested. Other similar equipment will not necessarily produce the same results due to production tolerance and measurement uncertainties. Tested By: Date: October 24, 2011 (Davis Ma) Check By: Date: October 24, 2011 (Merry Zhao) Approved By: Date: October 24, 2011 (Lisa Zhu) Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E Page 5 of 22 FCC ID: Z6U-AE1103RC-C 2 TEST RESULT SUMMARY FCC 15 Subpart C,Paragraph 15.231 Test Standards Test Items Test Results §15.231 Conducted test N/A §15.231 (b) Radiated Emission Pass §15.231 (c) 20dB Band Width Testing Pass §15.231 (a) Deactivation Testing Pass §15.203 ANTENNA REQUIREMENT Pass §15.231 DUTY CYCLE Pass Note: 1. The test result judgment is decided by the limit of test standard 2. The information of measurement uncertainty is available upon the customer’s request. 3. “N/A” means “Not applicable.” Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E Page 6 of 22 FCC ID: Z6U-AE1103RC-C 3 EUT DESCRIPTION Product Signal Pod or Signal N’ Safe Trade Mark N/A Model AE1103RC-C, AE1103RC, AE1103RC-A, AE1103RC-B, AE1103RC-D, AE1103RC-E, AE1103RC-F, AE1103RC-G Applicant Allegro Electronics Limited Serial Number N/A Antenna Type PCB Antenna EUT Power Rating DC 3V Battery Temperature Range(Operating) +15 ~+ 35°C Operating Frequency 433.92MHz Number of Channels 1 Channels Note: N/A stand for no applicable. Models difference All models have the same constructions, circuit diagram and PCB layout. Only model name are different. Shenzhen BCTC Technology Co., Ltd. Report No.: BCTC12070347E Page 7 of 22 FCC ID: Z6U-AE1103RC-C 4 TEST METHODOLOGY 4.1. DECISION OF FINAL TEST MODE The EUT was tested together with the below additional components, and configuration, which produced the worst emission levels, was selected and recor…

Text truncated - open the document above for the full version.

RADIATED EMISSION TEST