ZDTJ5C00012.4GHz Joystick Radio Control System

4.8 CH1 (Aileron) CH2 (Elevator) CH3 (Throttle) CH4 (Rudder) CH5 (Battery) J5C01 5 J5C01 5 220 6V J5C01R 5 4.8V FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices). This equipment complies with Part 15 of FCC RF Rules. Operation is subject to the following two conditions: 1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device. Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. EU Declaration of Conformity Hereby, Joysway Hobby (HK) Limited, declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

Report No.: TB-RF126121 Page: 3 of 9 TB-RF-075-1.0 Appendix III EUT External Photographs Photo 1 Appearance of EUT Photo 2 Appearance of EUT Report No.: TB-RF126121 Page: 4 of 9 TB-RF-075-1.0 Photo 3 Appearance of EUT

Report No.: TB-FCC126121 Page: 1 of 9 TB-RF-074-1.0 Appendix IID Label FCC ID: ZDTJ5C0001 Joysway Hobby (HK) Limited This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Made In China Note: There are similar labels as shown above for other models, where only the model name is replaced by: J5C02, J5C03, J5C04, J5C05, J5C06, J5C07, J5C08, J5C09 J4C03, J4C04, J4C05, J4C06, J4C07, J4C08, J4C09.

Report No.: TB-RF126121 Page: 2 of 9 TB-RF-075-1.0 Appendix II ID Label Location FCC ID LOCATION

Report No.: TB-RF126121 Page: 5 of 9 TB-RF-075-1.0 Appendix IV EUT Internal Photographs Photo 4 Internal of EUT Photo 5 Internal of EUT Report No.: TB-RF126121 Page: 6 of 9 TB-RF-075-1.0 Photo 6 Appearance of PCB Photo 7 Appearance of PCB Report No.: TB-RF126121 Page: 7 of 9 TB-RF-075-1.0 Photo 8 Appearance of PCB Photo 9 Appearance of PCB Antenna Report No.: TB-RF126121 Page: 8 of 9 TB-RF-075-1.0 Photo 10 Appearance of PCB

Shenzhen Toby Technology Co., Ltd. Report No.: TB-FCC126120 Page: 1 of 37 TB-RF-074-1.1 10/F., A Block, Jiada R & D Bldg., No.5 Songpingshan Road, Science & Technology Park, Nanshan District, Shenzhen, China Tel: +86 75526509301 Fax: +86 75526509195 FCC Radio Test Report FCC ID: ZDTJ5C0001 Report No. : TB-FCC126120 Applicant : Joysway Hobby (HK) Limited Equipment Under Test (EUT) EUT Name : 2.4GHz Joystick Radio Control System Model No. : J5C01 Serial No. : J5C02, J5C03, J5C04, J5C05, J5C06, J5C07, J5C08, J5C09 J4C03, J4C04, J4C05, J4C06, J4C07, J4C08, J4C09 Brand Name : Joysway Receipt Date : 2013-01-07 Test Date : 2013-01-08 to 2013-02-18 Issue Date : 2013-02-20 Standards : FCC Part 15, Subpart C Test Method : ANSI C63.4:2003 Conclusions : PASS In the configuration tested, the EUT complied with the standards specified above, The EUT technically complies with the FCC requirements Test/Witness Engineer : Approved& Authorized : This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in the report. Report No.: TB-FCC126120 Page: 2 of 37 TB-RF-074-1.1 Contents CONTENTS ............................................................................................................................................. 2 1. GENERAL INFORMATION ABOUT EUT ............................................................................. 4 1.1 Client Information ................................................................................................................. 4 1.2 General Description of EUT (Equipment Under Test) ................................................... 4 1.3 Block Diagram Showing the Configuration of System Tested ...................................... 5 1.4 Description of Support Units .............................................................................................. 5 1.5 Description of Test Mode .................................................................................................... 5 1.6 Description of Test Software Setting ................................................................................ 6 1.7 Test Facility ........................................................................................................................... 7 2. TEST SUMMARY ....................................................................................................................... 8 3. CONDUCTED EMISSION TEST ............................................................................................. 9 3.1 Test Standard and Limit ...................................................................................................... 9 3.2 Test Setup ............................................................................................................................. 9 3.3 Test Procedure ..................................................................................................................... 9 3.4 Test Equipment Used ........................................................................................................ 10 3.5 EUT Operating Mode ........................................................................................................ 10 3.6 Test Data ............................................................................................................................. 10 4. RADIATED EMISSION TEST ................................................................................................ 11 4.1 Test Standard and Limit .................................................................................................... 11 4.2 Test Setup ........................................................................................................................... 12 4.3 Test Procedure ................................................................................................................... 13 4.4 EUT Operating Condition ................................................................................................. 13 4.5 Test Equipment .................................................................................................................. 14 4.6 Test Data ............................................................................................................................. 14 5. RESTRICTED BANDS REQUIREMENT ............................................................................. 30 5.1 Test Standard and Limit .................................................................................................... 30 5.2 Test Setup ........................................................................................................................... 30 5.3 Test Procedure ................................................................................................................... 30 5.4 EUT Operating Condition ................................................................................................. 31 5.5 Test Equipment .................................................................................................................. 31 5.6 Test Data ............................................................................................................................. 32 6. BANDWIDTH TEST ................................................................................................................. 33 6.1 Test Setup ........................................................................................................................... 33 6.2 Test Procedure ................................................................................................................... 33 6.3 EUT Operating Condition ................................................................................................. 33 6.4 Test Equipment ......................…

Text truncated - open the document above for the full version.

Report No.: TB-RF126121 Page: 9 of 9 TB-RF-075-1.0 Appendix V EUT Test Photographs Photo of Setup for Radiated Emission (Above 1 GHz) Photo of Setup for Radiated Emission (Bellow 1 GHz)