ZG4YET3000-12Phoenix Long-Range Wireless Transmitter

Remote Usage Instructions 1. Power Source: One 9v Alkaline battery. 2. The on/off switch for the remote is located on the right side. 3. Numbered Keys (1-12) correspond to the related receiver cues. 4. To transmit: Slide on/off switch to on position. Press any button 1-12. The LED indicator at top center will change to red, indicating signal. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices). This equipment complies with Part 15 of FCC RF Rules. Operation is subject to the following two conditions: 1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device. Caution! The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment.

Report No.: TB-FCC110748 Page: 3 of 7 TB-RF-075-1.0 Appendix III EUT External Photographs Photo 1 Appearance of EUT Photo 2 Appearance of EUT Report No.: TB-FCC110748 Page: 4 of 7 TB-RF-075-1.0 Photo 3 Appearance of EUT

Report No.: TB-FCC110748 Page: 1 of 7 TB-RF-074-1.0 Appendix IID Label FCC ID: ZG4YET3000-12

Report No.: TB-FCC110748 Page: 2 of 7 TB-RF-075-1.0 Appendix II ID Label Location FCC ID LOCATION

Report No.: TB-FCC110748 Page: 5 of 8 TB-RF-075-1.0 Appendix IV EUT Internal Photographs Photo 4 Inside of EUT Photo 5 Appearance of PCB Report No.: TB-FCC110748 Page: 6 of 8 TB-RF-075-1.0 Photo 6 Appearance of PCB Photo 7 Appearance of Antenna Report No.: TB-FCC110748 Page: 7 of 8 TB-RF-075-1.0 Photo 8 Appearance of Antenna

Shenzhen Meihua Electonic Technology Co., Ltd. Report No.: TB-FCC110748 Page: 1 of 28 TB-RF-074-1.0 Room 505, East DingXin Bldg., LiuXian Road, XiLi Town, Nanshan, Shenzhen, China Tel: +86 75526292087 Fax: +86 75526751700 FCC Radio Test Report FCC ID: ZG4YET3000-12 Report No. : TB-FCC110748 Applicant : Uncle Sam’s Fireworks City, Inc. Equipment Under Test (EUT) EUT Name : Phoenix Long-Range Wireless Transmitter Model No. : YET3000-12 Serial No. : YET3000-1, YET3000-4. Brand Name : Phoenix Long Range Remote Transmitter Receipt Date : 2011-04-11 Test Date : 2011-04-12 to 2011-04-18 Issue Date : 2011-04-18 Tested By: : Bontek Compliance Testing Laboratory Ltd. Standards : FCC Part 15, Subpart C(15.231)/ANSI C63.4:2003 Test/Witness Engineer : Approved& Authorized : Report No.: TB-FCC110748 Page: 2 of 28 TB-RF-074-1.0 Contents CONTENTS.............................................................................................................................................2 TEST REPORT DECLARATION........................................................................................................4 1. GENERAL INFORMATION ABOUT EUT.............................................................................5 1.1 General Description of EUT (Equipment Under Test)...................................................5 1.2 Block Diagram Showing The Configuration of System Tested.....................................5 1.3 Description of Support Units..............................................................................................6 1.4 Description of Test Mode....................................................................................................6 1.5 Test Facility...........................................................................................................................6 2. TEST SUMMARY.......................................................................................................................7 3. CONDUCTED EMISSION TEST.............................................................................................8 3.1 Test Standard and Limit......................................................................................................8 3.2 Test Setup.............................................................................................................................8 3.3 Test Procedure.....................................................................................................................8 3.4 Test Equipment Used..........................................................................................................9 3.5 Test Data...............................................................................................................................9 4. RADIATED EMISSION TEST................................................................................................10 4.1 Test Standard and Limit....................................................................................................10 4.2 Test Setup...........................................................................................................................11 4.3 Test Procedure...................................................................................................................12 4.4 EUT Operating Condition.................................................................................................13 4.5 Test Equipment..................................................................................................................13 4.6 Test Condition....................................................................................................................13 4.7 Test Data.............................................................................................................................14 5. BANDWIDTH............................................................................................................................17 5.1 Test Standard and Limit....................................................................................................17 5.2 Test Setup...........................................................................................................................17 5.3 Test Procedure...................................................................................................................17 5.4 EUT Operating Condition.................................................................................................17 5.5 Test Equipment..................................................................................................................18 5.6 Test Condition....................................................................................................................18 5.7 Test Data.............................................................................................................................19 6. RELEASE TIME MEASUREMENT.......................................................................................20 6.1 Test Standard and Limit....................................................................................................20 6.2 Test Setup...........................................................................................................................20 6.3 Test Procedure...................................................................................................................20 6.4 EUT Operating Condition.................................................................................................20 6.5 Test Equipment..................................................................................................................21 6.6 Test Condition....................................................................................................................22 6.7 Test Data.............................................................................................................................22 Report No.: T…

Text truncated - open the document above for the full version.

Report No.: TB-FCC110748 Page: 7 of 7 TB-RF-075-1.0 Appendix V EUT Test Photographs Photo of Setup for Radiated Emission (Above 1 GHz) Photo of Setup for Radiated Emission (Bellow 1 GHz)