ZNFP692Cellular/PCS GSM/EDGE Phone with WLAN, Bluetooth and NFC

Part 15.21 statement " Change or Modifications that are not expressly approved by the manufacturer could void the user's authority to operate the equipment. “ Part 15.105 statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This device is not intended for sale in the USA.

          !"# Date:July 192011 Fede ral Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road, Columbia, MD 21046 RE: Request of Confidentiality for FCC ID: ZNFP692 Equipment Class:%&' () ) * +  *  To Whom It May Concern: Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules (CFR 47), and Section 552 (b) (4) of the Freedom of Information Act MobileComm hereby requ ests confidentiality and treatment of certain informat ion accompanying this application. The materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. We are also hereby request Short-Term Confidentiality for , days after the grant as outlined in Public Notice DA 04-1705. This provision will give  MobileComm temporary confidentialit y of commercially sensitive i nformation prior to product release. The requested Permanent and Temporary Confidential exhibits are listed as follows: '-.+%/0-+1+-.023%+33+ 45 6  %e )  1 Block Diagram 2 Operational Descriptions '-.+ 3 Schematics 4 External Photos 5 Internal Photos 6 Test-Setup Photos /0-+1+-. 7 User’s Manual The Applicant understands that pursuant to Rule 0.457, disclosure of this application and all accompanying documentations, where applicable, will not be made public before the date of the Grant for this application. Sincerely, Christopher Johnson Senior Manager LG Electronics USA LG Electronics USA 1000 Sylvan Avenue Englewood Cliffs, NJ 07632

FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 1 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 2 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 3

Model No: LG-P692 FCC ID : ZNFP692 S/ N : Made in Korea LG Electronics Inc. LGE

FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 1 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 2 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 3 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 4 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 5 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 6 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 8 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. View 9 FCCID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. Basic components information(NFC) NFC Main Matching Portion Antenna Connector

FCCID: ZNFP692 1106-00873 Report No.: DRTFCC1107-0264 TRF-RF-212(00)101214 Page 2 / 44 Copyright ○ C 2011, Digital EMC Co., Ltd. Table of Contents 1. General Information ............................................................................................................... 3 1.1 Testing Laboratory ...................................................................................................................... 3 1.2 Details of Applicant ..................................................................................................................... 3 1.3 Description of EUT ...................................................................................................................... 3 1.4. Declaration by the manufacturer ................................................................................................... 3 1.5. Information about the FHSS characteristics: ............................................................................... 4 1.5.1. Pseudorandom Frequency Hopping Sequence ...................................................................... 4 1.5.2. Equal Hopping Frequency Use ................................................................................................. 4 1.5.3. System Receiver Input Bandwidth ........................................................................................... 4 1.6. Test Equipment List ....................................................................................................................... 5 1.7. Summary of Test Results ............................................................................................................... 6 1.8 Conclusion of worst-case and operation mode ............................................................................ 7 1.9 Test report revision ......................................................................................................................... 7 2. Transmitter Radiated Spurious Emissions and Conducted Spurious Emission ............ 8 2.1. Test Setup........................................................................................................................................ 8 2.1.1. Transmitter Radiated Spurious Emissions .............................................................................. 8 2.1.2. Conducted Spurious Emissions ............................................................................................... 8 2.2. Limit ................................................................................................................................................. 9 2.3. Test Procedures ............................................................................................................................ 10 2.3.1. Test Procedures for Radiated Spurious Emissions ............................................................. 10 2.3.2. Test Procedures for Conducted Spurious Emissions .......................................................... 10 2.4. Test Results ................................................................................................................................... 11 2.4.1. Radiated Emission ................................................................................................................... 11 2.4.2. Conducted Spurious Emissions ............................................................................................. 14 3. 99 % & 20dBc BW ................................................................................................................. 29 3.1. Test Setup...................................................................................................................................... 29 3.2. Limit ............................................................................................................................................... 29 3.3. Test Procedure .............................................................................................................................. 29 3.4. Test Results ................................................................................................................................... 29 5. Maximum Peak Output Power Measurement .................................................................... 35 5.1. Test Setup...................................................................................................................................... 35 5.2. Limit ............................................................................................................................................... 35 5.3. Test Procedure .............................................................................................................................. 35 5.4. Test Results ................................................................................................................................... 36 6. Transmitter AC Power Line Conducted Emission ............................................................ 42 6.1. Test Setup...................................................................................................................................... 42 6.2. Limit ............................................................................................................................................... 42 6.3. Test Procedures ............................................................................................................................ 42 6.4. Test Results ................................................................................................................................... 43 FCCID: ZNFP692 1106-00873 Report No.: DRTFCC1107-0264 TRF-RF-212(00)101214 Page 3 / 44 Copyright ○ C 2011, Digital EMC Co., Ltd. 1. General Information 1.1 Testing Laboratory Digital EMC Co., Ltd. 683-3, Yubang-Dong, Cheoin-Gu, Yongin-Si, Kyunggi-Do, 449-080, Korea www.digitalemc.com Telephone : + 82-31-321-2664 FAX : + 82-31-321-1664 1.2 Details of Applicant Applicant : L…

Text truncated - open the document above for the full version.

FCC ID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. Test Setup photographs(DSS) EUT Position: X-axis FCC ID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. Test Setup photographs(DSS) EUT Position: Y-axis FCC ID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. Test Setup photographs(DSS) EUT Position: Z-axis FCC ID: ZNFP692 Copyright Ⓒ 2011, Digital EMC Co., Ltd. Test Setup photographs (DSS)