ZQG-DD7INTTXA RF REMOTE CONTROL TRANSMITTER TO ALLOW CONTROL OF A DISHWASHER

US CA NZ AU GB IE User guide DishDrawer TM dishwasher DD24, DD60 DD36, DD90 models This user guide is an accompaniment to your ‘Quick start guide’ which is included with your dishwasher. For operating instructions, see your ‘Quick start guide’. If you no longer have your ‘Quick start guide’, you can download it from our local website, listed on the back cover. Refer to your ‘Quick start guide’ for information on: Starting a wash Wash programs and when to use them Controls Dos and don’ts of loading Preference options and how to change their settings 1 Contents Electrical connection (GB IE only) 3 Safety and warnings 4 Caring for your dinnerware 7 Racking features 8 Loading suggestions 8 Water hardness and dishwashing 14 Wash programs and detergent quantities 19 Adding detergent 20 Using rinse aid 22 Water softener 23 User maintenance instructions 29 Troubleshooting 32 If there is a fault 34 How to attend to a fault Classic models 34 Designer and Integrated badge models 34 Integrated models with remote control 34 Warranty and service 37 Wash program data 38 Standards test USA and Canada 38 New Zealand and Australia 38 Great Britain and Ireland 38 Important! SAVE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed on the back cover or contact your local Fisher & Paykel dealer. 2 For Great Britain only Important! This appliance must be earthed. Fuse replacement The mains lead of this appliance is fitted with a BS 1363A 13 A fused plug. To change a fuse in this type of plug, use an ASTA approved fuse to BS 1362 type and proceed as follows: 1 Remove the fuse cover and fuse. 2 Fit the replacement 13A fuse into the fuse cover. 3 Refit both into plug. Important! The fuse cover must be refitted when changing a fuse and if the fuse cover is lost, the plug must not be used until a correct replacement is fitted. Correct replacements are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. For the Republic of Ireland The information given in respect to Great Britain will frequently apply, but a third type of plug and socket is also used: the 2-pin, side earth type. Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact an Authorised Service Agent. Please do not attempt to change the plug yourself. This procedure must be carried out by a qualified service technician in compliance with the manufacturer’s instructions and current standard safety regulations. Fuse cover Fuse Electrical connection (GB IE only) 3 Safety and warnings Your dishwasher has been carefully designed to operate safely during normal dishwashing procedures. Please keep the following instructions in mind when you are using your dishwasher. IMPORTANT SAFETY INSTRUCTIONS WARNING! - When using your dishwasher, follow basic precautions, including the following: Read all instructions before using the dishwasher. The information in this manual must be followed to minimise the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Use the dishwasher only for its intended function as described in this user guide and in your ‘Quick start guide’.. This appliance is intended to be used in household and similar applications such as: – staff kitchen areas in shops, offices and other working environments; – farm houses; – by clients in hotels, motels and other residential type environments; – bed and breakfast type environments. Use only detergents or rinse aid recommended for use in a domestic dishwasher and keep them out of reach of children. Check that the detergent dispenser is empty after the completion of each wash program. When loading items to be washed, locate sharp items so that they are not likely to damage the internal lid of the dishwasher and load sharp knives with the handle up to reduce the risk of cut- type injuries. Do not touch the filter plate (the round metal disc in the dishwasher base) during or immediately after use, as it may be hot from the heater plate underneath. Do not operate your dishwasher unless all enclosure panels are properly in place. Do not tamper with the controls. Do not abuse, sit on, stand in or on the drawer or dish rack of the dishwasher. The drawer should not be left in the open position since this could present a tripping hazard. The adjustable racks are designed to support cups, glasses and kitchen utensils. When the adjustable racks are in the drawer do not lean on or use them to support your body weight. To reduce the risk of injury, do not allow children to play in or on the dishwasher. Under certain conditions, hydrogen gas may be produced in a hot water heater system that has not been used for two weeks or more. HYDROGEN GAS IS EXPLOSIVE. If the hot water system has not been used for such a period, before using the dishwasher, turn on all hot water taps and let the water flow from each for several minutes. This will release any accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time. Remove the door to the washing compartment when removing an old dishwasher from service or discarding it. Some dishwasher detergents are strongly alkaline. They can be extremely dangerous if swallowed. Avoid contact with the skin and eyes and keep children away from the dishwasher when the door is open. Check that the detergent receptacle is empty after completion of the wash cycle. 4 Safety and warnings IMPORTANT SAFETY INSTRUCTIONS Installation This dishwasher must be installed and located in accordance with the Installation instructions before it is used. If you did not receive Installation instructions with your dishwasher, you can order them by calling your Authorised R…

Text truncated - open the document above for the full version.

1 st September 2011 EMC Technologies NZ Ltd PO Box 68307 Newton Auckland NEW ZEALAND SUBJECT: Authorisation To Act. To whom it may concern I hereby authorize Andrew Cutler, General Manager of EMC Technologies NZ Ltd to act on our behalf with regard the FCC Certification of the ZQG_DD71NTTX and ZQG-DD71NTRX Transceiver Yours faithfully FISHER & PAYKEL APPLIANCES LTD Peter MacArthur Product Safety & Compliance Engineer

1 st September 2011 Federal Communications Commission Equipment Authorisation Branch 7435 Oakland Mills Road Columbia, MD 21046 United States of America To whom it may concern CONFIDENTIALITY REQUEST Reference rule sections 0.457 (d) (ii) and pursuant to rule section 0.459 (a) confidentiality is requested as follows. Specific Information: Schematics, Block Diagram, Part List Operational Description The schematics contain trade secret information which is not made routinely available to the public or to our competitors. Disclosure of this information could result in an unfair advantage to our competitors. It should be treated as confidential for the duration of the Grant Of Authorisation. Yours faithfully FISHER & PAYKEL APPLIANCES LTD Peter MacArthur Product Safety & Compliance Engineer

____________________________________________________________________________________________________________________________________________________________________________ Page 17 of 20 Test Report No 110621.2 8 August 2011 This report may not be reproduced except in full. 9. PHOTOGRAPHS External Photos

____________________________________________________________________________________________________________________________________________________________________________ Page 18 of 20 Test Report No 110621.2 8 August 2011 This report may not be reproduced except in full. Internal Photos

____________________________________________________________________________________________________________________________________________________________________________ Page 1 of 27 Test Report No 110698.2 8 August 2011 This report may not be reproduced except in full. EMC Technologies (NZ) Ltd PO Box 68-307 Newton, Auckland Phone 09 360 0862 Fax 09 360 0861 E-Mail Address: [email protected] Web Site: www.emctech.com.au TEST REPORT Fisher and Paykel Dishdrawer Transceiver tested to the Code of Federal Regulations (CFR) 47 Part 15 – Radio Frequency Devices, Subpart C – Intentional Radiators Section 15.249 – Operation in the band 2400 – 2483.5 MHz for Fisher and Paykel Appliances Ltd This Test Report is issued with the authority of: ________________________________________ Andrew Cutler - General Manager ____________________________________________________________________________________________________________________________________________________________________________ Page 2 of 27 Test Report No 110698.2 8 August 2011 This report may not be reproduced except in full. Table of Contents 1. STATEMENT OF COMPLIANCE 3 2. RESULTS SUMMARY 3 3. CLIENT INFORMATION 3 4. DESCRIPTION OF TEST SAMPLE 4 5. EQUIPMENT PARAMETERS 4 6. ATTESTATION 6 7. TRANSMITTER TEST RESULTS 7 7. TEST EQUIPMENT USED 19 8. ACCREDITATIONS 19 9. PHOTOGRAPHS 20 ____________________________________________________________________________________________________________________________________________________________________________ Page 3 of 27 Test Report No 110698.2 8 August 2011 This report may not be reproduced except in full. 1. STATEMENT OF COMPLIANCE The Fisher and Paykel Dishdrawer Transceiver complies with 47 CFR Part 15 and in particular Sections, 15.205, 15.207, 15.209, 15.215 and 15.249 as detailed below when tested in accordance with ANSI C63.4 – 2003. 2. RESULTS SUMMARY Clause Description Result 15.201 Equipment authorisation requirement Applied 15.203 Antenna requirement Complies 15.204 External power amplifiers Not applicable 15.205 Operation in restricted bands Complies 15.207 Conducted emissions Not applicable 15.209 Radiated emissions See below 15.215 Additional provisions Complies 15.249 (a) Field strength of fundamental Complies 15.249 (a) Field strength of harmonics Complies 15.249 (b) Fixed, point to point operations Not applicable 15.249 (c) 3 metre measurement distance Noted 15.249 (d) Spurious emission levels except harmonics Complies 15.249 (e) Detectors above 1000 MHz Noted 15.249 (f) Reference to section 15.37(d) Noted 3. CLIENT INFORMATION Company Name Fisher and Paykel Appliances Ltd Address Level 2, Wall Street Mall 211 George Street City Dunedin 9016 Country New Zealand Contact Mr Craig Boon ____________________________________________________________________________________________________________________________________________________________________________ Page 4 of 27 Test Report No 110698.2 8 August 2011 This report may not be reproduced except in full. 4. DESCRIPTION OF TEST SAMPLE Brand Name Fisher and Paykel Model Dish drawer Model Number 523469 Product Transceiver Manufacturer Fisher and Paykel Appliances Ltd Country of Origin New Zealand Serial Number 523469000022 FCC ID ZQG-DD7INTRX 5. EQUIPMENT PARAMETERS The remote tested has the following RF specifications: FCC Band: 2400 MHz – 2483.5 MHz Test Frequencies: 2404, 2441, 2477 MHz Operating Frequencies: 2404, 2425, 2442, 2463, 2477 MHz Rated Power: 1.00 mW (+0 dBm) Modulation Type: GFSK, 2 Mbps data rate Antenna Type: Integral Power Supply: External 120 Vac from the Dish drawer Radio Module Type: Nordic nRF24LE01 An overview of the system is as follows: The system is event based using the radio component of the Nordic nRF24LE01 chip and that is driven by library code from Nordic and also Fisher and Paykel developed code. Testing was carried out on the transceiver contained within the Dish drawer. The Dish drawer transceiver cannot be directly activated by the user however it is activated when an external remote control transceiver is used. ____________________________________________________________________________________________________________________________________________________________________________ Page 5 of 27 Test Report No 110698.2 8 August 2011 This report may not be reproduced except in full. When the user presses a button on the remote device the transmitter sends a “button event” message and then waits for the Dish drawer to return an acknowledge message. In normal use there would be two “button event” messages every time a user runs a wash cycle which for most would be once or twice a day The transmitter will always transmit on the last known good channel. If an acknowledge message is not received from the Dish drawer after two attempts (with a delay before each) then the transmitter will select another channel from the list programmed list of frequencies at random and it then tries again. The transmitter will then cycle through the list of frequencies up to seven times before giving up. When the transmitter gives up, the remote device transceiver flashes a LED as an “out of range” indicator to the user. The user can retry at their discretion. The receiver scans each channel in the frequency list on a timed basis until it gets a valid message. When the receiver sends the acknowledge message before restarting the scan it pauses on each channel for 3ms. When the receiver is scanning there is some latency and it can be expected that the transmitter will retry several times before the receiver channel matches the transmit channel. The transmit data rate is 2Mb/s. A total of 45 bytes are transferred in the “button event” and acknowledge messages. The message transfer time (including retries) is around 5 ms or less. When a dish wash is started the transmitter would be on for about 10ms for a duty of less than 0.1% in a given hour. The Dish drawer transceiver is contained within the Dish drawer and is powered a…

Text truncated - open the document above for the full version.

____________________________________________________________________________________________________________________________________________________________________________ Page 19 of 20 Test Report No 110621.2 8 August 2011 This report may not be reproduced except in full. Radiated emissions test set up photos ____________________________________________________________________________________________________________________________________________________________________________ Page 20 of 20 Test Report No 110621.2 8 August 2011 This report may not be reproduced except in full.