ZVTA4X00Portable Scanner

1.1 EUT Constructional Details

SGS-CSTC Standards Technical Services Co., Ltd. No. 1 Workshop, M-10, Middle Section, Science & Technology Park, Nanshan District Shenzhen, China 518057 Telephone: +86 (0) 755 2601 2053 Fax: +86 (0) 755 2671 0594 Email: [email protected] Report No.:SZEM110800306001 Page: 1 of 17 Authorized Signature: Jack Zhang EMC Laboratory Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC Test Report (Verification) Application No.: SZEM1108003060IT Applicant: Kenxen Limited Address of Applicant: 26/F., Lever Tech Center, 69-71 King Yip St., Kwun Tong, H.K. Manufacturer/Factory: Kenxen Electronic (SZ) Limited Address of Manufacturer /Factory: 3/F, BIK.6 HuaXinRuiMing Industrial Park, Lang Rong Road, XinWei DaLang Community, Bao’an District, Shenzhen, China FCC ID: ZVTA4X00 Equipment Under Test (EUT): EUT Name: Portable Scanner Item No.: A4A, A4B, A4C, A4D, A4E, A4F♣ ♣ Please refer to section 2 of this report which indicates which item was actually tested and which were electrically identical. Standards: FCC PART15 SUBPART B:2010 Date of Receipt: 2011-08-17 Date of Test: 2011-08-24 to 2011-08-30 Date of Issue: 2011-09-01 Test Result : Pass* * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEM110800306001 Page: 2 of 17 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only 2 Test Summary Test Test Requirement Test Method Class / Severity Result Radiated Emission (30MHz to 1GHz) FCC PART 15, SUBPART B: 2010 ANSI C63.4:2009 Class B PASS Conducted Emission (150kHz to 30MHz) FCC PART 15, SUBPART B: 2010 ANSI C63.4:2009 Class B PASS Remark: Item No.: A4A, A4B, A4C, A4D, A4E, A4F Only the item A4A was tested, since the electrical circuit design, layout, component used and internal wiring were identical for all above items. The only difference is model name and cosmetic part. SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEM110800306001 Page: 3 of 17 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This doc…

Text truncated - open the document above for the full version.

1 Photographs - Test Setup 1.1 Conducted Emission Test Setup 1.2 Radiatd Emission Test Setup