ZZCLK-UK001Wired keyboard

RPODUCT DISPOSAL INS TRUCTIONS The symbol shown here and on the product means that the product is classed as Elecrical or Electronic Equipment and should not be disposed with other household or commercial wast at the end of its working life . The waste of Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC) has been put in place to recycle products using best available recovery and recycling methods to minimise the impact on the environment and to treat anyhazardous substances and avoid the increasing landfill. Product disposal instructions for residential users: When you have no further use for it ,please remove any batteries and dispose of them and the product as per your local authority’s recycling processes . For more information please contact your local authority or the retailer where the item was purchased. Product disposal instructions for business users : Business users should use their own contracted disposal agreements with regards to following WEEE procedures so that this product is not mixed with other commercial waste . 15.21 statement: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 15.105 statement： This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help .

1 Photographs 1.1 EUT Constructional Details

Requirements for Label & Label Location 1. location: on the back of the product 2. size: 80.5mm*40.5mm

1 Photographs 1 EUT Constructional Details

SGS-CSTC Standards Technical Services Co., Ltd. No. 1 W orkshop, M-10, Middle Section, Science & Technology Park, Nanshan District Shenzhen, China 518057 Telephone: +86 (0) 755 2601 2053 Fax: +86 (0) 755 2671 0594 Email: [email protected] Report No.:SZEM110800331601 Page: 1 of 13 Authorized Signature: Jack Zhang EMC Laboratory Manager The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. FCC Test Report Application No.: SZEM1108003316IT Applicant/Manufacturer/ Factory: Shenzhen Lucallan Electronics Co.,Ltd. Address of Applicant/ Manufacturer/Factory: 42nd Floor Sha san shang xia wei, The second industrial area, Sha san Rd., Sha jing town, Baoan district, Shenzhen city, Guangdong China. FCC ID: ZZCLK-UK001 Equipment Under Test (EUT): EUT Name: Wired keyboard Item No.: LK-UK001 Standards: FCC PART15 SUBPART B: 2010 Date of Receipt: 2011-08-29 Date of Test: 2011-08-29 to 2011-09-24 Date of Issue: 2011-10-13 Test Result : Pass* * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEM110800331601 Page: 2 of 13 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only 2 Test Summary Test Test Requirement Test Method Class / Severity Result Radiated Emission (30MHz to 1GHz) FCC PART 15, SUBPART B: 2010 ANSI C63.4:2009 Class B PASS Conducted Emission (150kHz to 30MHz) FCC PART 15, SUBPART B: 2010 ANSI C63.4:2009 Class B PASS SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEM110800331601 Page: 3 of 13 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at www.sgs.com/terms_and_conditions.htm and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at www.sgs.com/terms_e-document.htm. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Company’s findings at the time of its intervention only and within the limits of Client’s instructions, if any. The Company’s sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only 3 Contents Page 1 COVER PAGE ........................…

Text truncated - open the document above for the full version.

1 Photographs 1.1 Conducted Emission Test Setup 1.2 Radiated Emission Test Setup