2AAGF-PLATTANBTPlattan ADV Wireless

PLATTAN ADV WIRELESS USER MANUAL ENG •Do not drop, sit on, or allow the headphone to be immersed in water. •Keep away from fire, water, and high voltage equipment. Not suitable for children under age three. Contains small parts, which may be a choking hazard. Long-term exposure to loud music or sounds may cause hearing loss. To prevent possible hearing damage, do not listen at high volume levels for long periods. This is not household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. This product was produced after Jan 1 2006. FCC WARNING Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter- ference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installa- tion. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and receiver. •Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •Consult the dealer or an experienced radio/TV technician for help. IC WARNING This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploita- tion est autorisée aux deux conditions suivantes :(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appar- eil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement. The device is compliance with RF field strength limits, users can obtain Canadian information on RF exposure and compliance. Le présent appareil est conforme de ce matériel aux conformités ou aux limites d’intensité de champ RF, les utilisateurs peuvent sur l’exposition aux radiofréquences et la conformité and com- pliance d’acquérir les informations correspondante. This Class B digital apparatus complies with Canadian ICES- 003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. For any questions or concerns contact: [email protected] Zound Industries International AB Box 6063 10231 Stockholm, Sweden Designed in Stockholm • Produced in China The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Zound Industries AB is under license. Machine Washable Headband – Detachable fabric head- band for easy wash and wear. LED indicator – Discrete and unlit during normal oper- ation. Built-in touch interface Power button Micro USB connector for charging the battery. Zound Plug – Instant music sharing or wired connection to the sound source INTERFACES 1 1 4 4 3 3 2 2 5 5 6 6 PLATTAN ADV WIRELESS USER MANUAL ENG SWITCH ON Press and hold the power button for 1 second SWITCH OFF Press and hold the power button for 2 seconds or leave the headphone inactive and disconnected for 10 minutes CLEANING THE HEADPHONE Detach the washable headband and machine wash 30° C (Cold/Cool). Clean the headphone with a soft, dry cloth. Note! Do not use liquids or sprays. LED INDICATOR Status Indicates Red (continuous) Battery charging White (continuous) Fully charged and connected to a USB power source Blue ( blinking) Pairing mode, waiting to pair White ( blinking) Waiting to connect White (10s interval) Connected and switched on Off Headphones is switched off or in normal operation TROUBLE SHOOTING Problem Action Not powering on Charge the headphone using the USB cable. Make sure the headphone is off before turning it on. Not charging Make sure the USB power source is switched on. The LED indicator is red while charging and white when fully charged. Not pairing Move the devices closer to each other and away from any interference or obstruction. Make sure the headphone is not connected to a different sound source when entering the pairing mode. Disable and enable Bluetooth® communication on your sound source. No sound Make sure the headphone is on and connected. Make sure the sound source is playing. Poor sound quality Move the devices closer to each other and away from any interference or obstruction. IMPORTANT SAFETY INSTRUCTIONS •Set your sound source to low volume before using the headphone. •Do not use this headphone when operating a motor vehicle, a bicycle, or machinery or where your inability to hear outside sounds may present a danger to you or others. •Using this headphone limits your ability to hear noises around you, regardless of listening volume. Please use caution when using this headphone. PLATTAN ADV WIRELESS USER MANUAL ENG CONTROLS PLATTA…

Text truncated - open the document above for the full version.

Zound IndustriesZound IndustriesZound Industries

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT – All View EUT – Front View EUT – Rear View EUT – Left View EUT – Right View EUT – Top View EUT – Bottom View EUT – USB Cable View EUT – Audio Cable View

EXHIBIT A - FCC ID LABEL AND LOCATION FCC ID Label FCC ID Label Location Information The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925)

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS EUT – Cover off View EUT – Inner View EUT – Main Board Top View EUT – Main Board Bottom View BT Antenna EUT – Left Horn Cover off View EUT – Left Horn Inner View EUT – Right Horn Inner View EUT – Small PCB Top View EUT – Small PCB Bottom View EUT – Battery Top View EUT – Battery Bottom View

Note: This test report is prepared for the customer shown above and for the equipment described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. FCC PART 15.247 TEST REPORT For ZOUND INDUSTRIES TORSGATAN 2, 111 23 STOCKHOLM, SWEDEN FCC ID: 2AAGF-PLATTANBT Report Type: Original Report Product Type: Plattan ADV Wireless Test Engineer: Haiguo Li Report Number: RSZ150206011-00C Report Date: 2015-03-12 Reviewed By: Jimmy Xiao RF Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Shenzhen) Report No.: RSZ150206011-00C FCC Part 15.247 Page 2 of 31 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 4 TEST METHODOLOGY .................................................................................................................................................. 4 TEST FACILITY ............................................................................................................................................................. 4 SYSTEM TEST CONFIGURATION .......................................................................................................................... 5 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 5 EUT EXERCISE SOFTWARE .......................................................................................................................................... 5 SPECIAL ACCESSORIES ................................................................................................................................................. 5 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 5 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 5 EXTERNAL I/O CABLE .................................................................................................................................................. 5 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 6 SUMMARY OF TEST RESULTS ............................................................................................................................... 7 FCC§15.247 (i), §1.1307 (b) (1) &§2.1093 – RF EXPOSURE ........................................................................................ 8 APPLICABLE STANDARD .............................................................................................................................................. 8 FCC §15.203 – ANTENNA REQUIREMENT ............................................................................................................ 9 APPLICABLE STANDARD .............................................................................................................................................. 9 ANTENNA CONNECTOR CONSTRUCTION ...................................................................................................................... 9 FCC §15.207 (a) – AC LINE CONDUCTED EMISSIONS ..................................................................................... 10 APPLICABLE STANDARD ............................................................................................................................................ 10 MEASUREMENT UNCERTAINTY .................................................................................................................................. 10 EUT SETUP ................................................................................................................................................................ 10 EMI TEST RECEIVER SETUP ....................................................................................................................................... 11 TEST PROCEDURE ...................................................................................................................................................... 11 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 11 CORRECTED FACTOR & MARGIN CALCULATION ....................................................................................................... 11 TEST RESULTS SUMMARY .......................................................................................................................................... 12 TEST DATA ................................................................................................................................................................ 12 FCC §15.209, §15.205 & §15.247(d) - SPURIOUS EMISSIONS ............................................................................. 15 APPLICABLE STANDARD ............................................................................................................................................ 15 MEASUREMENT UNCERTAINTY .....................…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Conducted Emissions - Front View Conducted Emissions - Side View Radiated Emissions – Front View (30-1000 MHz) Radiated Emissions – Rear View (30-1000 MHz) Radiated Emissions – Front View (1-25 GHz) Radiated Emissions – Rear View (1-25 GHz)