2AARFBFTD50301Digital Radio

1 Notice Government law prohibits the operation of unlicensed radio transmitters within the territories under government control. Illegal operation is punishable by fine or imprisonment or both. Acknowledgement We are grateful you choose BeiFeng series professional radio communications products! Since 1989, BeiFeng has been always engaging in research and exploration of radio communications technologies, In order to lead intelligent technologies in the industry. We still make every effort to research and design products according to modern complicated communications environment, and We offer complete and customized communication solutions to clients. our products will satisfy you because of its excellent performance and outstanding communications strength . No matter what field you are in. You will be Satisfied with the radio . This manual is applicable to UHF digital FM transceiver model: BF-TD5033 Warning！ Precautions It’s important that the operator is aware of and understands hazards common to the operation of any radio .Please observe the following safety precautions to prevent radio damage or personal injury. The following precautions shall be observed during operation 、service and repair of this radio. The recommended usage rate is 1 minute for TX and 4 minutes for RX,When the radio is used for transmission for many hours Continuously, the radiator and chassis will become hot, allow the rear panel of the two-way radio to contact surface of low melting point /low Ignition Point object. Don’t leave the transceiver in direct sunlight for a long time , Don’t place the transceiver on extremely heat、damp、dusty area, and don’t put it on unstable surfaces. ◆ devices, Please obey the regulation turn the transceiver power off. ) ◆ Use of the radio while you are driving may be against traffic laws, Please prohibite using it . ◆If you notice any problems on the radio, please turn off at first. Then contact with local dealer. Do not modify this radio unless instructed by this manual or refer service to a qualified licensed or certified technician only. ◆ If you want to use the machine for secondary development, Please cantact with BeiFeng’s Technical engineer or dealer for technical assistance. ◆ Please keep the surface of radio is clean and dry, Clean the radio using a cloth moistened with clean water and a mild dishwashing liquid. Always switch the radio power off before installing optional accessories. Contents Supplied accessories 2 Accessory 2 Installation of Accessories 3 Installation/ Removing the antenna 3 In explosive atmospheres(inflammable gas,dust particles,much powder area，etc.),Please turn the power off. 2 Attaching/Removing the Battery 4 Li-ion battery features 5 Charging the Li-ion battery 6 Attaching/Removing the belt clip 6 Attaching/Removing the strap 6 Attaching the Speaker/Microphone 6 About the radio 6 Basic Operation 8 LCD Icons 8 Turning the power on /Turn off 9 Adjusting the volume 9 Selecting a Channel 10 Transmitting 10 Receiving 10 Button setting 10 Functions and Operations 10 Digital Channel 10 Contacts 12 Scan 13 Zone select 14 Messages 15 Call Log 16 Radio Settings 17 Radio Info 20 Analog Channel 20 CTCSS Standard frequency table 22 CDCSS standard code table 22 Specifications 23 Statement 24 Supplied accessories Notes: The accessories listed below are covered by BeiFeng dealer、authorized BeiFeng agents or factories . After carefully unpacking the transceiver, identify the items listed in the table below. If any items are missing or have been damaged during shipment Please contact with dealer immediately. Accessory Items Model Qty antenna BF-RA103 1 unpack and inspection 3 strap BF-RL801 1 belt clip BF-BS103 1 charger BF-B33 1 Li-ion battery BF-A33 1 instruction manual 1 warranty card 1 certificate 1 Antenna Strap Belt Clip Charger Li-ion Battery 4 Instruction Manual installation of Accessories Installation/ Removing the antenna Hold the suppied antenna by its base ,then screw it into the connector on the top panel of the radio until fasten. Turn the antenna anti-clockwise to remove it. Attaching/Removing the Battery (Warning)  Don’t short-circuit the battery, it may cause the battery damaged or burst into flame;  Never attempt to remove the casing from battery, That avoid to short the battery terminal;  Battery is flammable objects, Don’t throw it into fire or don’t use it on dangerous area. 5 Match the guides of the battery with the corresponding grooves on the upper rear of the radio, then press the battery until a click is heard to lock it in place. To remove the battery , Please turn the power off, then press the release latch to unlock the battery pull the battery away from the radio. Note: Don’t Attach / Remove the Battery if the transceiver turned on . Li-ion battery features ●New batteries are activated from factory, Please charge your battery before using it .The maximum battery capacity and performance is achieved after three full charge/ discharge cycles. ●The service life of batteries : Charge cycles time is limited, To Prolong Battery Life try to reduce make charge by the battry remained. ●To reduce self-discharge, Please remove the battery before younot in use for a long time , And store your battery in a cool, dry location. ●Charge your battery about 50% before you store it for a long time , So that can prevent to decreased the battery performance. As the battery is charged and discharged repeatedly, the battery capacity decreases,Even if the battery is unused,the battery degrades,store battery in a high temperature will shorten its lifecycle. Charging the Li-ion battery When the battery power runs low,the radio will send alert Sounds, please recharge the battery. please only use the battery and charger specified by BeiFeng. When charging a battery attached to a radio ,Please turn the radio off. Please don’t remove the battery from the charger before fully charge , or the battery could suffer damage. 6 Please remove the battery timely when the b…

Text truncated - open the document above for the full version.

EXHIBIT B - EUT EXTERNAL PHOTOGRAPHS EUT – Front View EUT – Rear View EUT – Top View EUT – Bottom View EUT – Left Side View EUT – Right Side View EUT – Adapter View EUT – Adapter Label View EUT –Charger Top View EUT –Charger Bottom View

EXHIBIT A - FCC ID LABELING AND LOCATION FCC ID Label Proposed FCC ID Label Location The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925) Label here

EXHIBIT C - EUT INTERNAL PHOTOGRAPHS EUT – Cover off View 1 EUT – Cover off View 2 EUT –Cover off View 3 EUT – Main Board Top View 1 EUT –Main Board Top View 2 EUT – Main Board Bottom View EUT – Antenna View EUT – Battery View EUT –Charger Cover off View EUT –EUT Label View

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. SAR EVALUATION REPORT For Fujian Beifeng Telecom Technology Co., Ltd. A-15, Huaqiao Economic Development Zone, Shuangyang, Luojiang, Quanzhou, Fujian,China FCC ID: 2AARFBFTD50301 Report Type: Original report Product Type: Digital Radio Test Engineer: Wilson Chen Report Number: RSZ150114001-20B Report Date: 2015-02-04 Reviewed By: Bell Hu SAR Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building, ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Shenzhen) Report No: RSZ150114001-20B SAR Evaluation Report 2 of 61 Attestation of Test Results EUT Information Company Name Fujian Beifeng Telecom Technology Co., Ltd. EUT Description Digital Radio FCC ID 2AARFBFTD50301 Model Number BF-TD503 Test Date 2015-01-15 Frequency (MHz) Mode Max. SAR Level(s) Reported Limit (W/Kg) 400-470 Digital 12.5kHz Face up: 3.825 W/kg Body worn: 3.976 W/kg 8.0 Applicable Standards ANSI / IEEE C95.1: 2005 IEEE Standard for Safety Levels with Respect to Human Exposure to Radio Frequency Electromagnetic Fileds,3 kHz to 300 GHz. ANSI / IEEE C95.3: 2002 IEEE Recommended Practice for Measurements and Computations of Radio Frequency Electromagnetic Fields With Respect to Human Exposure to SuchFields,100 kHz—300 GHz. IEEE1528:2013 IEEE Recommended Practice for Determining the Peak Spatial-Average Specific Absorption Rate (SAR) in the Human Head from Wireless Communications Devices: Measurement Techniques KDB procedures KDB 447498 D01 v05r02: Mobile and Portable Devices RF Exposure Procedures and Equipment Authorization Policies. KDB 865664 D01v01r03: SAR measurement 100 MHz to 6 GHz v01. KDB 643646D01 v01r01: SAR test Reduction Considerations for Occupational PTT Radios. Note: This wireless device has been shown to be capable of compliance for localized specific absorption rate (SAR) for Occupational /Controlled Exposure limits specified in ANSI/IEEE Standards and has been tested in accordance with the measurement procedures specified in IEEE 1528-2013 and RF exposure KDB procedures. The results and statements contained in this report pertain only to the device(s) evaluated. Bay Area Compliance Laboratories Corp. (Shenzhen) Report No: RSZ150114001-20B SAR Evaluation Report 3 of 61 TABLE OF CONTENTS DOCUMENT REVISION HISTORY ......................................................................................................................... 4 EUT DESCRIPTION .................................................................................................................................................... 5 TECHNICAL SPECIFICATION ......................................................................................................................................... 5 REFERENCE, STANDARDS, AND GUILDELINES ............................................................................................... 6 SAR LIMITS ................................................................................................................................................................. 7 FACILITIES .................................................................................................................................................................. 8 DESCRIPTION OF TEST SYSTEM .......................................................................................................................... 9 EQUIPMENT LIST AND CALIBRATION ............................................................................................................. 16 EQUIPMENTS LIST & CALIBRATION INFORMATION .................................................................................................... 16 SAR MEASUREMENT SYSTEM VERIFICATION .............................................................................................. 17 LIQUID VERIFICATION ............................................................................................................................................... 17 SYSTEM ACCURACY VERIFICATION ........................................................................................................................... 19 SAR SYSTEM VALIDATION DATA ..................................................................................................................... 20 EUT TEST STRATEGY AND METHODOLOGY ................................................................................................. 24 TEST POSITIONS FOR DEVICE OPERATING NEXT TO A PERSON’S EAR........................................................................ 24 CHEEK/TOUCH POSITION ........................................................................................................................................... 25 EAR/TILT POSITION ................................................................................................................................................... 25 TEST POSITIONS FOR BODY-WORN AND OTHER CONFIGURATIONS .............................................................................. 26 SAR EVALUATION PROCEDURE ................................................................................................................................. 27 TEST METHODOLOGY ................................................................................................................................................. 27 CONDUCTED OUTPUT POWER MEASUREMENT ........................................................................................... 28 PROVISION APPLICABLE ............................................................................................................................................ 28 TEST PROCEDURE .............…

Text truncated - open the document above for the full version.

Note: This test report is prepared for the customer shown above and for the equipment described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. FCC PART 90 TEST REPORT For Fujian Beifeng Telecom Technology Co., Ltd. A-15, Huaqiao Economic Development Zone, Shuangyang, Luojiang, Quanzhou, Fujian, China FCC ID: 2AARFBFTD50301 Report Type: Original Report Product Type: Digital Radio Test En gineer: Mike Hu Re port Number: RSZ150114001-00 Re port Date: 2015-07-27 Reviewed B y: Jimmy Xiao RF Engineer Prepared By: Bay Area Compliance Laboratories Corp. (Shenzhen) 6/F, the 3rd Phase of WanLi Industrial Building, ShiHua Road, FuTian Free Trade Zone Shenzhen, Guangdong, China Tel: +86-755-33320018 Fax: +86-755-33320008 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Shenzhen) Report No.: RSZ150114001-00 FCC PART 90 Page 2 of 23 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 3 OBJECTIVE ................................................................................................................................................................... 3 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 3 TEST METHODOLOGY .................................................................................................................................................. 3 TEST FACILITY ............................................................................................................................................................. 4 SYSTEM TEST CONFIGURATION .......................................................................................................................... 5 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 5 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 5 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 5 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 5 SUMMARY OF TEST RESULTS ............................................................................................................................... 6 MEASUREMENT UNCERTAINTY ........................................................................................................................... 7 FCC §1.1307(b) & §2.1093 - RF EXPOSURE ............................................................................................................. 8 APPLICABLE STANDARD .............................................................................................................................................. 8 FCC §2.1046 & §90.205 - RF Output Power ............................................................................................................... 9 APPLICABLE STANDARD .............................................................................................................................................. 9 TEST PROCEDURE ........................................................................................................................................................ 9 TEST EQUIPMENT LIST AND DETAILS ........................................................................................................................... 9 TEST DATA .................................................................................................................................................................. 9 FCC §2.1049 & §90.209 & §90.210 – OCCUPIED BANDWIDTH & EMISSION MASK ................................... 11 APPLICABLE STANDARD ............................................................................................................................................ 11 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 11 TEST PROCEDURE ...................................................................................................................................................... 11 TEST DATA ................................................................................................................................................................ 12 FCC §2.1051 & §90.210 - SPURIOUS EMISSIONS AT ANTENNA TERMINALS ............................................ 15 APPLICABLE STANDARD ............................................................................................................................................ 15 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 15 TEST PROCEDURE ...................................................................................................................................................... 15 TEST DATA ................................................................................................................................................................ 15 FCC §2.1053 & §90.210 - RADIATED SPURIOUS EMISSIONS .......................................................................... 17 APPLICABLE STANDARD ............................................................................................................................................ 17 TEST EQUIPMENT LIST AND DETA…

Text truncated - open the document above for the full version.

EXHIBIT D - TEST SETUP PHOTOGRAPHS Transmitting Radiated Emissions View (Below 1 GHz) Transmitting Radiated Emissions View (Above 1 GHz)