2AB4XAMP10522SECRET AGENT WALKIE TALKIES

Ages 6 and up 10522 SpyX Secret Agent Walkie Talkies Requires 4 AAA (LR03) Batteries, not included. Important: Please save this instruction sheet. It contains valuable product information. Talk to fellow spies in secret, just like real secret service agents! The Set-up 1. Detach the microphone plug from the wrist microphone (you will plug it back in later). 2. Attach the wrist strap with wrist microphone to your wrist. Wear it like a watch on top of your wrist or under your wrist for "stealth mode". 3. Clip the power pack unit onto your belt and run the wires up and under your shirt or jacket. 4. Run the Sleeve wire (with the microphone plug at the end) down your shirt or jacket sleeve and reattach the microphone plug back into the microphone jack (make sure it is all the way plugged in). 5. Run the ear bud wire under your shirt and collar and place it in your ear. 6. Turn on each walkie talkie power pack by moving the power switch (Fig 1.) to the "on" position. Talking in Secret The wrist microphone is voice activated, so you just need to start talking into the wrist microphone and the other agent can hear you. Hint: Both agents cannot talk at the same time so one of you will talk while the other listens. You can take turns. Tip: When finished playing with the SpyX Walkie Talkies please move the power switch to the "off" position. BATTERY SAFETY INFORMATION · Only adults should install and replace batteries. · Do not recharge non-rechargeable batteries. · Remove dead or exhausted batteries. · Insert batteries correctly. Match positive and negative signs. · The supply terminals are not to be short circuited. · Do not use rechargeable batteries. · Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. · Do not mix old and new batteries. · Only the batteries of the same or equivalent type recommended to be used. · Do not dispose of batteries in a fire; they may explode. · Dispose of batteries safely. ATTENTION ADULTS—TO INSTALL AND REPLACE BATTERIES SpyX Secret Agent Walkie Talkies. Each Walkie Talkie requires two AAA (LR03) batteries, not included. • Locate the belt clip on the back of the walkie talkie. To gain access to the battery cover, press the tab release on the belt clip and slide the belt clip upwards to release (Fig. 2). • Use a small Phillips head screwdriver to loosen the screw and remove the battery cover (Fig. 2). • Remove all old batteries. • Place new batteries in compartments as shown (Fig. 2). • Replace the battery cover and tighten screw. Then replace the belt clip. SPYX SECRET AGENT WALKIE TALKIES 10522-4000 Product specifications subject to change. IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US AT www.atomicmonkeyproducts.com/help © 2015 Atomic Monkey Products, Ltd. Hong Kong, China, All rights reserved. PRINTED IN CHINA SECRET AGENT WALKIE TALKIES ™ with Hidden Microphone and Ear Bud Receiver FCC INFO AREA Fig 2. Belt Clip Battery Cover Belt Clip Release Tab AAA AAA Belt Clip (on back side) Power Pack Shirt Wire Sleeve Wire ON / OFF Ear Bud Wire Wrist Strap Wrist Microphone Microphone Jack Ear Bud Receiver Microphone Plug Strap Clasp Fig 1. EU Compliance : This device complies with EU EMF Directive 1999/519/EC can be used in the European Community. “ Hereby, (Atomic Monkey Products Ltd.), declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.” FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. SAR Exemption Statement : This device measured RF output power is less than the SAR exclusion threshold value for human head and body. Therefore, SAR test is not necessary.

External Photographs Model :10522

FCC ID Label &Location: FCC ID:2AB4XAMP10522 Label Location

Internal Photographs Model:10522

Report No.: SET2015-06771 CCIC-SET/T˄00˅ Page 1 of 17 RF TEST REPORT Report No.: SET2015-06771 Product Name: SECRET AGENT WALKIE TALKIES FCC ID: 2AB4XAMP10522 Model No. : 10522 Applicant: Applicant Address: Atomic Monkey Products Ltd. Room 811, 8/F., Corporation Park, No.11 On Lai Street, Shatin, N. T.,HongKong Issued by: CCIC-SET Lab Location: Electronic Testing Building, Shahe Road, Xili, Nanshan District, Shenzhen, 518055, P. R. China Tel: 86 755 26627338 Fax: 86 755 26627238 This test report consists of 17 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CCIC-SET. The test results in the report only apply to the tested sample. The test report shall be invalid without all the signatures of testing engineers, reviewer and approver. Any objections must be raised to CCIC-SET within 20 days since the date when the report is received. It will not be taken into consideration beyond this limit. Report No.: SET2015-03811 CCIC-SET/T˄00˅ Page 2 of 17 Test Report Product Name ...................... : SECRET AGENT WALKIE TALKIES Trade Name .......................... : N/A Brand Name ......................... : N/A Applicant .............................. : Atomic Monkey Products Ltd. Applicant Address ............... : Room 811, 8/F., Corporation Park, No.11 On Lai Street, S hatin, N.T.,HongKong Manufacturer ........................ : Atomic Monkey Products Ltd. Manufacturer Address ......... : Room 811, 8/F., Corporation Park, No.11 On Lai Street, S hatin, N.T.,HongKong Test Standards ..................... : 47 CFR Part 15 Subpart C(Section 15.239)˖Radio Frequency Devices ANSI C63.10:2009˖American National Standard for Testing Unlicensed Wireless Devices Test Result ........................... : PASS Tested by ............................ : 2015.05.06 Haigang HeˈTest Engineer Reviewed by ......................... : 2015.05.06 Zhu Qi, Senior Engineer Approved by ......................... : 2015.05.06 Wu Li’anˈManager ANSI C63.4:2009 Report No.: SET2015-06771 CCIC-SET/T˄00˅ Page 3 of 17 TABLE OF CONTENTS 1. GENERAL INFORMATION .................................................................................................... 4 1.1 EUT Description ......................................................................................................................... 4 1.2 Support Equipment .................................................................................................................... 5 1.3 Test Standards and Results ........................................................................................................ 5 1.4 Facilities and Accreditations ...................................................................................................... 6 1.4.1 Facilities .................................................................................................................................... 6 1.4.2 Test Environment Conditions .................................................................................................... 6 2. 47 CFR PART 15C REQUIREMENTS .................................................................................... 7 2.1 Antenna requirement ................................................................................................................. 7 2.1.1 Applicable Standard .................................................................................................................. 7 2.1.2 Antenna Information ................................................................................................................. 7 2.1.3 Result: comply .......................................................................................................................... 7 2.2 20 dB Bandwidth ........................................................................................................................ 8 2.2.1 Requirement .............................................................................................................................. 8 2.2.2 Test Description ........................................................................................................................ 8 2.2.3 Test limit .................................................................................................................................... 8 2.2.4 Test Result ................................................................................................................................. 9 2.3 Conducted Emission ................................................................................................................. 10 2.3.1 Requirement ............................................................................................................................ 10 2.3.2 Test Description ...................................................................................................................... 10 2.3.3 Test Result ............................................................................................................................... 11 2.4 Radiated Emission .................................................................................................................... 12 2.4.1 Limits ...................................................................................................................................... 12 2.4.2 Test Description ...................................................................................................................... 13 2.4.3 Test Procedure ......................................................................................................................... 14 2.4.4 Test Result ............................................................................................................................... 14 Change History Issue Date Reason for change …

Text truncated - open the document above for the full version.

Radiated Emission Test Set-up: Below 1GHz: Above 1GHz: