2ABCA-BT700Bluetooth Headset

FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC Statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution! Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Neutron Engineering Inc. Project No.: 1311C048 Page 2 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 3 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 4 of 12

SIZE13.5*7.5MM 13.5mm 7.5mm

Neutron Engineering Inc. Project No.: 1311C048 Page 5 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 6 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 7 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 8 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 9 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 10 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 11 of 12 Neutron Engineering Inc. Project No.: 1311C048 Page 12 of 12 RFmoduleantenna

Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 1 of 62 FCC Radio Test Report FCC ID: 2ABCA-BT700 This report concerns (check one): Original Grant Class II Change Issued Date : Nov. 15, 2013 Project No. : 1311C048 Equipment : Bluetooth Headset Model Name : BT700; BT705; BTK-X7; BL-X7; BL-X3; BL-X3S; BTK-X6; BL-25; BL-26; BL-X2; BL-32; BTK-X2; BTK-X3; BL-33; BTK-V1; BTK-V2 Applicant : DOV enterprises inc Address : 2001Rt 46East Suite 310 Parsippany NJ 07054 USA Tested by: Neutron Engineering Inc. EMC Laboratory Date of Receipt: Nov. 07, 2013 Date of Test: Nov. 07, 2013 ~ Nov. 14, 2013 Testing Engineer : (David Mao) Technical Manager : (Leo Hung) Authorized Signatory: (Steven Lu) Neutron Engineering Inc. No.3,Jinshagang 1st Road, ShiXia, Dalang Town, Dong Guan, China. TEL: 0769-8318-3000 FAX: 0769-8319-6000 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 2 of 62 Declaration Neutron represents to the client that testing is done in accordance with standard procedures as applicable and that test instruments used has been calibrated with the standards traceable to National Measurement Laboratory (NML) of R.O.C, or National Institute of Standards and Technology (NIST) of U.S.A. Neutron's reports apply only to the specific samples tested under conditions. It is manufacture’s responsibility to ensure that additional production units of this model are manufactured with the identical electrical and mechanical components. Neutron shall have no liability for any declarations, inferences o r generalizations drawn by the client or others from Neutron issued reports. Neutron’s reports must not be used by the client to claim product endorsement by the authorities or any agency of the Government. This report is the confidential property of the client. As a mutual protection to the clients, the public and Neutron-self, extracts from the test report shall not be reproduced except in full with Neutron’s authorized written approval. Neutron’s laboratory quality assurance procedures are in compliance with the ISO Guide 17025 requirements, and accredited by the conformity assessment authorities listed in this test report. Limitation For the use of the authority's logo is limited unless the Test Standard(s)/Scope(s)/Item(s) mentioned in this test report is (are) included in the conformity assessment authorities acceptance respective. Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 3 of 62 Table of Contents Page REPORT ISSUED HISTORY 5 1 . CERTIFICATION 6 2 . SUMMARY OF TEST RESULTS 7 2.1 TEST FACILITY 8 2.2 MEASUREMENT UNCERTAINTY 8 3 . GENERAL INFORMATION 9 3.1 GENERAL DESCRIPTION OF EUT 9 3.2 DESCRIPTION OF TEST MODES 11 3.3 TABLE OF PARAMETERS OF TEXT SOFTWARE SETTING 12 3.4 BLOCK DIAGRAM SHOWING THE CONFIGURATION OF SYSTEM TESTED 13 3.5 DESCRIPTION OF SUPPORT UNITS 14 4 . EMC EMISSION TEST 15 4.1 CONDUCTED EMISSION MEASUREMENT 15 4.1.1 POWER LINE CONDUCTED EMISSION LIMITS 15 4.1.2 MEASUREMENT INSTRUMENTS LIST AND SETTING 15 4.1.3 TEST PROCEDURE 16 4.1.4 DEVIATION FROM TEST STANDARD 16 4.1.5 TEST SETUP 16 4.1.6 EUT OPERATING CONDITIONS 16 4.1.7 TEST RESULTS 17 4.2 RADIATED EMISSION MEASUREMENT 20 4.2.1 RADIATED EMISSION LIMITS 20 4.2.2 MEASUREMENT INSTRUMENTS LIST ANS SETTING 21 4.2.3 TEST PROCEDURE 22 4.2.4 DEVIATION FROM TEST STANDARD 22 4.2.5 TEST SETUP 23 4.2.6 EUT OPERATING CONDITIONS 24 4.2.7 TEST RESULTS (BELOW 30MHZ) 25 4.2.8 TEST RESULTS-BETWEEN 30MHZ AND 1000MHZ 26 4.2.8 TEST RESULTS (ABOVE 1000 MHZ) 33 5 . BANDWIDTH TEST 45 5.1 APPLIED PROCEDURES / LIMIT 45 5.1.1 MEASUREMENT INSTRUMENTS LIST 45 5.1.2 TEST PROCEDURE 45 5.1.3 DEVIATION FROM STANDARD 45 5.1.4 TEST SETUP 45 5.1.5 EUT OPERATION CONDITIONS 45 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 4 of 62 Table of Contents Page 5.1.6 TEST RESULTS 46 6 . MAXIMUM OUTPUT POWER TEST 48 6.1 APPLIED PROCEDURES / LIMIT 48 6.1.1 MEASUREMENT INSTRUMENTS LIST 48 6.1.2 TEST PROCEDURE 48 6.1.3 DEVIATION FROM STANDARD 48 6.1.4 TEST SETUP 48 6.1.5 EUT OPERATION CONDITIONS 48 6.1.6 TEST RESULTS 49 7 . ANTENNA CONDUCTED SPURIOUS EMISSION 50 7.1 APPLIED PROCEDURES / LIMIT 50 7.1.1 MEASUREMENT INSTRUMENTS LIST 50 7.1.2 TEST PROCEDURE 50 7.1.3 DEVIATION FROM STANDARD 50 7.1.4 TEST SETUP 50 7.1.5 EUT OPERATION CONDITIONS 50 7.1.6 TEST RESULTS 51 8 . POWER SPECTRAL DENSITY TEST 56 8.1 APPLIED PROCEDURES / LIMIT 56 8.1.1 MEASUREMENT INSTRUMENTS LIST 56 8.1.2 TEST PROCEDURE 56 8.1.3 DEVIATION FROM STANDARD 56 8.1.4 TEST SETUP 56 8.1.5 EUT OPERATION CONDITIONS 56 8.1.6 TEST RESULTS 57 9 . EUT TEST PHOTO 59 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 5 of 62 REPORT ISSUED HISTORY Issued No. Description Issued Date NEI-FCCP-1-1311C048 Original Issue. Nov. 15, 2013 Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 6 of 62 1. CERTIFICATION Equipment : Bluetooth Headset Brand Name : BTK; KISS; Lindero; SHARKK Model Name : BT700; BT705; BTK-X7; BL-X7; BL-X3; BL-X3S; BTK-X6; BL-25; BL-26; BL-X2; BL-32; BTK-X2; BTK-X3; BL-33; BTK-V1; BTK-V2 Applicant : DOV enterprises inc Manufacturer : SHENZHEN SHI KISB ELECTRONIC CO.,LTD Address : 3-5/F, A Building, Shanghe Industrial Park, Nanchang Road, Xixiang Town, Bao’an District, Shenzhen, Guangdong, 518103 P.R.China Factory : SHENZHEN SHI KISB ELECTRONIC CO.,LTD Address : 3-5/F, A Building, Shanghe Industrial Park, Nanchang Road, Xixiang Town, Bao’an District, Shenzhen, Guangdong, 518103 P.R.China Date of Test : Nov. 07, 2013 ~ Nov. 14, 2013 Test Item : ENGINEERING SAMPLE Standard(s) : FCC Part15, Subpart C(15.247) / ANSI C63.4-2009 The above equipment has been tested and found compliance with the requirement of the relative standards by Neutron Engineering Inc. EMC Laboratory. The test data, data evaluation, and equipment configuration contained in our test report (Ref No. NEI-FCCP-1-1311C048) were obtained utilizing the test procedures, test instruments, test sites that has been accredited by the Authority of TAF according to the ISO-17025 quality …

Text truncated - open the document above for the full version.

Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 56 of 59 9. EUT TEST PHOTO Conducted Measurement Photos Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 57 of 59 Radiated Measurement Photos 9K~30MHz Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 58 of 59 Radiated Measurement Photos 30M~1000MHz Neutron Engineering Inc. Report No.: NEI-FCCP-1-1311C048 Page 59 of 59 Radiated Measurement Photos Above 1000MHz