2ABPM28595-MV104REMOTE CONTROLLER

HETRON ELECTRONICS CO., LTD. Smart Keyless 28595 MV104TECHNICAL DOCUMENTS 103 年 2 月 6 日星期四 2 General Technical Description Model ： 28595 MV104 Rated voltage ： DC 3V Operating current ： 8mA (max) Dark Current ： 8uA (max) Operating temperature range ： -20 °C ~ 60 °C (Without batteries) Storage temperature range ： -40 °C ~ 85 °C RF frequency ： 315MHz ± 150KHz LF frequency ： 125KHz ± 1KHz Battery Type ： CR1632 Modulate ： ASK Encoding ： MANCHESTER 103 年 2 月 6 日星期四 3 L1 L4 C1 C4 C7 12 R1 L2 L5 C2 C5 C8 12 R2 L6 C3 C6 C9 12 R3 C10 V+ C11 12 + + + + BT1BT 12 R6 V+ C13 V+ VDD 1 RA5 2 RA4 3 RA3 4 RC5 5 RC4 6 RC3 7 RC2 8 RC1 9 RC0 10 RA2 11 RA1 12 RA0 13 VSS 14 U2 1 2 J1C14 V+ 12 R5 12 R7 V+ 12 R8 12 R9 12 R10 12 R11 LD1 RC2 1 2 R12 12 R13 1 3 S2SW 1 3 S1SW 1 3 S0SW 3 2 1 Q1 L9 C16C17 C18 C19 C15 C20 V+ V+ VA L3 T2 ANTENNA LOCKUNLOCK R-PSD GND 1 VCCO 2 RF3 3 TDAT 4 TEN 5 VBAT 6 EOBA 7 CLKA/M 8 WAKE 9 WDEEN 10 TX 11 MOD 12 TCLK 13 RF2 14 RF1 15 VCL 16 U1 LOOP 1 3 S3 12 R4 Vout 1 VDD 5 SUB 2 N.C 3 GND 4 RG1 V+ 12 R14 IN 2 G 1 G 3 G 5 G 4 G 6 SW1 12 R15 ANT ANT L-PSD 1 P5 1 P6 1 P7 1 P1 1 P2 1 P3 1 P4 1 P10 1 P8 1 P9 1 P11 1 B1 1 B2 1 B3 1 B4 V+ C21 C22 C23 C24 C25 C26 C27 1 2 R16 SCHEMATIC DIAGRAM 28595 MV 104 103 年 2 月 6 日星期四 4 PHOTOGRAPHS 28595 SU102 28595 MV104 Lock Unlock Sliding doors or Trunk 103 年 2 月 6 日星期四 5 P.C.B (Front) 28595 SU102 28595 MV104 103 年 2 月 6 日星期四 6 P.C.B (Back) 28595 SU102 28595 MV104 103 年 2 月 6 日星期四 7 TX ： ：：： 28595 MV104 103 年 2 月 6 日星期四 8 USER OPERATION INSTRUCTION 103 年 2 月 6 日星期四 9 SMART KEYLESS ENTRY Request Signal output RKE module Locking Unlocking ENGINE start UHF receiver LF Antenna 125KHZ 315MHZ ID code discriminate Two-way communication Check OK Vehicle (1) (2) (3) (4) CID Detect area
System Operation Schematic Key Card Key Card 103 年 2 月 6 日星期四 10 SMART KEYLESS ENTRY Authentication Range Radius ： ：：： ≦ 0.8m Interior antenna (Right area) Interior antenna (IP area) Push SW Push SW Exterior door handle antenna Smart keyless ECU Interior antenna (Left area) INSTRUCTIONS ALARM TX：28595 MV104 Description: Alarm TX:28595 MV104, as car alarm remote control door lock when the alarm is set immediately after the alarm is triggered if the doors, trunk, hood is opened or the vehicle being struck, this time the direction of light flashes and a speaker beep 15 seconds; when you press the lift button, door lock, under the direction of said anti-theft light flashes three released; when the burglar released under the remote control or the side door open and close the tailgate. 28595 MV104 FCC Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Change or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. RF exposure warning: The equipment complies with FCC RF exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.

Report No：1410158R-RFUSP14V00 Page: 28 of 36 Attachment EUT Photograph (1) EUT Photo (2) EUT Photo

Whetron electronic Co., Ltd. No.16, Singye Rd., Ta Fa Ind., Daliao Dist., Kaohsiung City 831, Taiwan (R.O.C.) FCC ID.: 2ABPM28595-MV104 FCC ID Label

Report No：1410158R-RFUSP14V00 Page: 30 of 36 (5) EUT Photo (6) EUT Photo Report No：1410158R-RFUSP14V00 Page: 31 of 36 (7) EUT Photo (8) EUT Photo Report No：1410158R-RFUSP14V00 Page: 32 of 36 (9) EUT Photo (10) EUT Photo Report No：1410158R-RFUSP14V00 Page: 33 of 36 (11) EUT Photo (12) EUT Photo Report No：1410158R-RFUSP14V00 Page: 34 of 36 (13) EUT Photo (14) EUT Photo Report No：1410158R-RFUSP14V00 Page: 35 of 36 (15) EUT Photo (Antenna) (16) EUT Photo (Antenna) Report No：1410158R-RFUSP14V00 Page: 36 of 36 (17) EUT Photo (MB)

Report No：1410158R-RFUSP14V00 Page: 1 of 36 FCC Test Report Product Name ：REMOTE CONTROLLER Model No. ：28595 MV104 FCC ID. ：2ABPM28595-MV104 Applicant ： Whetron electronic Co., Ltd. Address ： No.16, Singye Rd., Ta Fa Ind., Daliao Dist., Kaohsiung City 831, Taiwan (R.O.C.) Date of Receipt：2014/01/06 Issued Date ：2014/01/17 Report No. ：1410158R-RFUSP14V00 Report Version：V1.0 The test results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. Report No：1410158R-RFUSP14V00 Page: 2 of 36 Test Report Certification Issued Date : 2014/01/17 Report No. : 1410158R-RFUSP14V00 Product Name : REMOTE CONTROLLER Applicant : Whetron electronic Co., Ltd. Address : No.16, Singye Rd., Ta Fa Ind., Daliao Dist., Kaohsiung City 831, Taiwan (R.O.C.) Manufacturer : Whetron electronic Co., Ltd. Model No. : 28595 MV104 FCC ID. : 2ABPM28595-MV104 EUT Voltage : DC 3V Trade Name : LUXGEN Applicable Standard : FCC 15 Subpart C Section 15.231(b): 2012 Test Result : Complied The test results relate only to the samples tested. The test report shall not be reproduced except in full without the written approval of QuieTek Corporation. This report must not be used to claim product endorsement by NVLAP any agency of the U.S. Government Documented By : ( Demi Chang / Engineering Adm. Specialist ) Reviewed By : ( Quale Tang / Senior Engineer) Approved By : ( Roy Wang / Director) Report No：1410158R-RFUSP14V00 Page: 3 of 36 Laboratory Information We, QuieTek Corporation, are an independent RF consultancy that was established the whole facility in our laboratories. The test facility has been accredited/accepted (audited or listed) by the following related bodies in compliance with ISO 17025 specified testing scopes: The related certificate for our laboratories about the test site and management system can be downloaded from QuieTek Corporation’s Web Site:http://www.quietek.com/tw/ctg/cts/accreditations.htm The address and introduction of QuieTek Corporation’s laboratories can be founded in our Web site : http://www.quietek.com/ If you have any comments, Please don’t hesitate to contact us. Our contact information is as below: HsinChu Testing Laboratory: No.75-2, 3rd Lin, Wangye Keng, Yonghxing Tsuen, Qionglin Shiang, Hsinchu County 307, Taiwan, R.O.C. TEL:+886-3-592-8858 / FAX:+886-3-592-8859 E-Mail : [email protected] LinKou Testing Laboratory: No.5-22, Ruishukeng, Linkou Dist., New Taipei City 24451, Taiwan, R.O.C. TEL : 886-2-8601-3788 / FAX : 886-2-8601-3789 E-Mail : [email protected] Taiwan R.O.C. : TAF, Accreditation Number: 1313 USA : FCC, Registration Number: 365520 Canada : IC, Submission No: 150981 Report No：1410158R-RFUSP14V00 Page: 4 of 36 TABLE OF CONTENTS Description Page 1. General Information .......................................................................................................................5 1.1. EUT Description ............................................................................................................. 5 1.2. Operation Description..................................................................................................... 6 1.3. Test Mode .......................................................................................................................7 1.4. Tested System Details .................................................................................................... 8 1.5. Configuration of tested System ...................................................................................... 8 1.6. EUT Exercise Software .................................................................................................. 8 1.7. Test Facility..................................................................................................................... 9 2. Radiated Emission.......................................................................................................................10 2.1. Test Equipment............................................................................................................. 10 2.2. Test Setup .................................................................................................................... 11 2.3. Limits ............................................................................................................................ 12 2.4. Test Procedure ............................................................................................................. 13 2.5. Test Specification.......................................................................................................... 13 2.6. Uncertainty ................................................................................................................... 13 2.7. Test Result....................................................................................................................14 2.8. Test Photo .................................................................................................................... 19 3. Occupied Bandwidth....................................................................................................................21 3.1. Test Equipment............................................................................................................. 21 3.2. Test Setup .................................................................................................................... 21 3.3. Limits ............................................................................................................................ 21 3.4. Test Specification.......................................................................................................... 21 3.5. Uncertainty ................................................................................................................... 21 3.6. Test Result...........................................................................................…

Text truncated - open the document above for the full version.

Report No：1410158R-RFUSP14V00 Page: 19 of 36 2.8. Test Photo Test Mode ： Mode 1: Transmit Description： Front View of Radiated Emission Test Setup (Bi-Log) Test Mode ： Mode 1: Transmit Description： Back View of Radiated Emission Test Setup (Bi-Log) Report No：1410158R-RFUSP14V00 Page: 20 of 36 Test Mode ： Mode 1: Transmit Description： Front View of Radiated Emission Test Setup (Horn) Test Mode ： Mode 1: Transmit Description： Back View of Radiated Emission Test Setup (Horn)