2ABUP-FT1212RRemote Control Transmitter

USER MANUAL FOR FT1212A REMOTE CONTROL TRANSMITTER I. Operation Instructions 1.Fan off  When operating, press the keyto stop the fan.  This key for the fan off only. 2. Speed of the fan (1~6 level)  Press the key ”1,2,3,4,5,6” to turn on the fan to designated speed level.  After press speed level Keys, the fan will enter the corresponding speed level from other speed level or idle.  Key “1” is the lowest speed, and key”6 “is the highest speed. 3.Direction of the fan  Press the keycan change the running direction of the fan. 5. The other optional functions as below:  Light on or off.  +Turn up the brightness of the light.  _Turn down the brightness of the light. Adjust the color temperature of the light 6. The transmitter use 1pcs of 12V 23A battery, please install the battery correctly. II.Use precautions 1. When press the key of transmitter, the LED indicator doesn’t on, please inspect the battery installation. 2. When press the key of transmitter, the LED indicator flashing, that means the battery get low voltage, please replace a new one. 3. Please pull out of the battery from the transmitter when leaving unused for a long time. FCC Instructions ： This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --- Reorient or relocate the receiving antenna. --- Increase the separation between the product and receiver. --- Connect the product into an outlet on a circuit differentfrom that to which the receiver is connected. --- Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause Undesired operation. Warning:Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the product. IC Notice ： In addition to containing other required statements specified elsewhere in this standard or in the applicable RSS, user manuals for licence-exempt radio apparatus shall contain the following text, or an equivalent notice, that shall be displayed in a conspicuous location, either in the user manual or on the device, or both: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exemptRSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme à la section 15 des règlements de laFCC & Industry Canada's licence-exempt RSSs. Le fonctionnement est sujet aux conditions suivantes: 1. Cet appareil ne cause pas du brouillage nuisible. 2. Cet appareil peut subir de brouillage reçu, y compris l'interférence qui conduit à l'opération indésirable.

ShenzhenFunpowerGeneralTechnologyCo.,Ltd. AgentAuthorization Company:ShenzhenFunpowerGeneralTechnologyCo.,Ltd. Address:Room201B,HaborVentureBuilding,No.1041HouhaiAvenue,Shekou, NanshanDistrict,ShenzhenCity,PRC. ProductName:RemoteControlTransmitter ModelNumber(s):FT1212R ProductDescription: RemoteControlTransmitter. WeauthorizeMiCOMLabsInc.,575BoulderCourt,Pleasanton,California94566,USA, toactonourbehalfonallmattersconcerningthecertificationofabovenamed equipment. WedeclarethatMiCOMLabsInc.isallowedtoforwardallinformationrelatedtothe approvalandcertificationofequipmenttotheregulatoryagenciesasrequiredandto discussanyissuesconcerningtheapprovalapplication.Anyandallactscarriedoutby MiCOMLabsonourbehalfshallhavethesameeffectasactsofourown. Signature:Date:2020.08.05 Name:YiChen Title:MarketingManager Company:ShenzhenFunpowerGeneralTechnologyCo.,Ltd.

ShenzhenFunpowerGeneralTechnologyCo.,Ltd. OfficeofEngineeringTechnology FederalCommunicationsCommission 7435OaklandMillsRoad Columbia,MD21046 USA Date:2020.08.05 Subject;RequestforConfidentiality FCCID:2ABUP-FT1212R ToWhomItMayConcern, PursuanttotheprovisionsoftheCommission’srulesTitle47Sections§0.457and§0.459,we arerequestingtheCommissiontowithholdthefollowingattachment(s)asconfidential documentsfrompublicdisclosureindefinitely. Thesedocumentscontaindetailedsystemandequipmentdescriptionsandareconsideredas proprietaryinformationinoperationoftheequipment.Thepublicdisclosureofthesedocuments mightbeharmfultoourcompanyandwouldgivecompetitorsanunfairadvantageinthemarket. SchematicDiagram BlockDiagram PartsList OperationalDescription Tune-upProcedure Inadditionaltoabovementioneddocuments,inordertocomplywiththemarketingregulations inTitle47CFR§2.803andtheimportationrulesinTitle47CFR§2.1204,whileensuringthat businesssensitiveinformationremainsconfidentialuntiltheactualmarketingofnewly authorizeddevices,werequestShortTermConfidentialityofthefollowingattachment(s); ExternalPhotos TestSetupPhotos InternalPhotos UserManual For45days,pursuanttoPublicNoticeDA04-1705. OR For180dayspursuanttoKDB726920D01. Itisourunderstandingthatallmeasurementtestreports,FCCIDlabelformatand correspondenceduringthecertificationreviewprocesscannotbegrantedasconfidential documentsandthisinformationwillbeavailableforpublicreviewoncethegrantofequipment authorizationisissued. Sincerely, Signature: Name:YiChen Title:MarketingManager

ExternalPhotographs

MODEL NO FT1212R.: FCC ID: 2ABUP-FT1212R IC: 25540-FT1212R This device complies with Part 15 of the FCC Rules. following two conditions: Operation is subject to the (1)This device may not cause harmful interference. and(2) This device must accept any interference received.including interference that may cause undesired operation. 24 mm 35 mm

InternalPhotographs

Page 2 of 22 ReportNo.:KS2007S00279E KSIGN(Guangdong)TestingCo.,Ltd. TABLEOFCONTENTSPage 1.TESTSUMMARY ....................................................................................................................................................................... 3 1.1.TESTSTANDARDS ................................................................................................................................................................... 3 1.2. REPORTVERSION ................................................................................................................................................................... 3 1.3.TESTDESCRIPTION .......................................................................................................................................................... 4 1.4.TESTFACILITY .................................................................................................................................................................. 5 1.5. MEASUREMENTUNCERTAINTY ................................................................................................................................................. 6 1.6.ENVIRONMENTALCONDITIONS ................................................................................................................................................. 6 2.GENERALINFORMATION ......................................................................................................................................................... 7 2.1.CLIENTINFORMATION ............................................................................................................................................................ 7 2.2. GENERALDESCRIPTIONOFEUT ............................................................................................................................................... 7 2.3. TESTMODE .......................................................................................................................................................................... 7 2.4.MEASUREMENTINSTRUMENTSLIST ........................................................................................................................................... 8 2.5.TESTSOFTWARE ..................................................................................................................................................................... 8 3.TESTITEMANDRESULTS .......................................................................................................................................................... 9 3.1.ANTENNAREQUIREMENT .................................................................................................................................................. 9 3.2.CONDUCTEDEMISSION ......................................................................................................................................................... 10 3.3.OCCUPIEDBANDWIDTH ........................................................................................................................................................ 11 3.4. DEACTIVATIONTIME ............................................................................................................................................................ 13 3.5.SPURIOUSEMISSION(RADIATED) ............................................................................................................................................ 15 4.EUTTESTPHOTOS .................................................................................................................................................................. 21 5.PHOTOGRAPHSOFEUTCONSTRUCTIONAL .......................................................................................................... 22 Page 3 of 22 ReportNo.:KS2007S00279E KSIGN(Guangdong)TestingCo.,Ltd. 1.TESTSUMMARY 1.1.TestStandards Thetestswereperformedaccordingtofollowingstandards: FCCRulesPart15.231:Periodicoperationintheband40.66–40.70MHzandabove70MHz. ANSIC63.10-2013:AmericanNationalStandardforTestingUnlicensedWirelessDevices. 1.2.Reportversion RevisedNo.DateofissueDescription 01Jul.30,2020Original Page 4 of 22 ReportNo.:KS2007S00279E KSIGN(Guangdong)TestingCo.,Ltd. 1.3.TestDescription FCCRulesPart15.231 TestItem StandardSection ResultTestEngineer FCC Antennarequirement15.203PassRoryHuang ConductedEmissions15.207N/AN/A RadiatedSpuriousEmissions15.205/15.209(a)/15.231(b)/15.35(c)PassRoryHuang DeactivationTime15.231(a)(1)PassRoryHuang DutyCycle15.231PassRoryHuang OccupiedBandwidth15.231(c)PassRoryHuang Note:1.Themeasurementuncertaintyisnotincludedinthetestresult. 2.N/A:meansthistestitemisnotapplicable Page 5 of 22 ReportNo.:KS2007S00279E KSIGN(Guangdong)TestingCo.,Ltd. 1.4.TestFacility Addressofthereportlaboratory KSIGN(Guangdong)TestingCo.,Ltd. WestSideof1/F.,BuildingC,ZoneA,FuyuanNewFactory,JiujiuIndustrialPark,Minzhu,Shatou,Shajing, Bao'anDistrict,Shenzhen,Guangdong,People’sRepublicofChina Laboratoryaccreditation Thetestfacilityisrecognized,certified,oraccreditedbythefollowingorganizations: CNAS-LabCode:L13261 KSIGN(Guangdong)TestingCo.,Ltd.hasbeenassessedandprovedtobeinCompliancewithCNAS-CL01 AccreditationCriteriaforTestingandCalibrationLaboratories(identicaltoISO/IEC17025:2017General Requirements)fortheCompetenceofTestingandCalibrationLaboratories. A2LA-LabCert.No.:5457.01 KSIGN(Guangdong)TestingCo.,Ltd.EMCLaboratoryhasbeenaccreditedbyA2LAfortechnicalcompetence inthefieldofelectricaltesting,andprovedtobeincompliancewithISO/IEC17025:2017GeneralRequirements fortheCompetenceofTestingandCalibrationLaboratoriesandanyadditionalprogramrequirementsinthe identifiedfieldoftesting. ICRegistrationNo.:CN0096 The3malternatetestsiteofKSIGN(Guangdong)TestingCo.,Ltd.EMCLaboratoryhasbeenregisteredby CertificationandEngineerBureauofIndustryCanadafortheperformanceofwithRegistrationNO.:CN0096 FCC-RegistrationNo.:CN1272 KSIGN(Guangdong)TestingCo.,Ltd.EMCLaboratoryhasbeenregisteredandfu…

Text truncated - open the document above for the full version.

FCCID:2ABUP-FT1212R RadiatedEmissions (30MHz~1000MHz) RadiatedEmissions (Above1GHz) RFConducted