2AC67-X100VT Series Headsets

Valuing You Better 400*140mm VT X100 USB Series User Manual VT X100 USB Ser Valuing You Better Your new headset is supplied with a clothing clip to allow comfortable fitting of your headset without the cable getting caught or inadvertently pulled.The clothing clip should be fastened at a comfortable level, ensuring that there is sufficient slack on the cable allowing free movement of your head without disturbing the headset position. Ear Cushion Removal Using both thumbs, remove the ear cushion by gently prying the earplate away from the groove on the receiver. Maintenance The ear cushions can be removed for cleaning or replacement. Accessories Safety For your own safety, this product should only be used with CE and RoHS approved equipment. Using this headset with non approved equipment can void this product warranty. Xiamen VbeT Electronics Co.,Ltd URL : http://www.vbet.cn Mail : [email protected] Tel : 0086-592-5778728 Fax : 0086-592-5778708 Add : 5th Floor Keji Building#2,No.32 Huoju East Road,Huli District Xiamen china Connect your VT X100 USB Series Headset to a free USB port on your PC. RoHS COMPLIANT Replacements & enhancements for the VT Series headsets: 2 Headset hook 3 Leatherette ear cushion 2 1 3 1 Clothing clip 67 2345 VT X100 USB Series Headset Components 1 Wideband Speaker 2 Ear Cushion 3 Adjustable Headband 4 T-bar 5 Ultra-noise-cancelling microphone 6 Headset Cable 7 USB housing Connection Connect your VT X100 USB Series Headset to a free USB port on your PC. Headset Components New Feature 1 Display for mute microphone 2 Mute microphone 3 Volume control 4 Hook On/Off Key 5 Display for Hook Off 6 Mute Speaker(only for USB02) 7 Display for operation(only for USB02) 1 2 3 3 4 5 4 USB02 USB03 USB04 1 2 3 6 7 Make sure that the headset has been selected as the standard audio device in the system control audio settings. Check whether you need to adjust these settings to use a headset by reading the operating instructions for your softphone application. Wearing Your Headset Revolving 300° When switching the receiver to another side, rotating the microphone boom over the headband to accommodate the left or right ear. Place the headset receiver to your ear(s), if using a single ear headset you should set the T -bar above the other ear . Adjust the headband until it is comfortable, ideally ensuring that there is virtually no pressure felt on the ear(s). To avoid low or distorted sound, and to provide clear and crisp telephone calls, the microphone should be positioned within 30-40mm of your mouth. The microphone boom arm will move in a variety of directions to ensure the best fit. Using Your Headset Work with any PC&Softphone(Skype For Business),Microsoft Lync,Avaya,Cisco system,3CX(USB03/USB04 support hook off/on,USB02 support audio) 2 1 3 2 4 7 5 6

Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EXHIBIT 2 - EUT EXTERNAL PHOTOGRAPHS Model No.: X100 DUO EUT View 1 EUT View 2 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EUT View 3 EUT View 4 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EUT View 5 EUT View 6 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EUT View 7 EUT View 8 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EUT View 9 EUT View 10 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EUT View 11 EUT View 12 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EUT View 13 EUT View 14 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn Model No.: X100 EUT View 15 Model No.: VT6200 EUT View 16

Reference Waltek Tes http://www EXHIBI Proposed Specification it is visible durable to r expected lif e Proposed e No.: WTX20 sting Group w.semtest.co T 1 - PRO FCC ID La ns: The label or easily acc emain fully l etime. Label Loca 0X06036502 (Shenzhen) m.cn ODUCT L abel Forma shall be secu cessible to th legible and in ation on EU 2W Co., Ltd. LABELIN at urely affixed t he user, and ntact on the UT FCC NG to a permane shall not be device in al l ID Label Lo ently attached readily detac l normal cond cation d part of the d chable. The l ditions of use device, in a lo label shall be e throughout ocation where e sufficiently t the device’s e y s

Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EXHIBIT 3 - EUT INTERNAL PHOTOGRAPHS EUT Housing and Board View 1 Solder Board-Component View 1 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn Solder Board-Component View 2 Solder Board-Component View 3 Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn Solder Board-Component View 4

Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn Page 1 of 15 TEST REPORT Reference No. .................... : WTX20X06036502W FCC ID ................................ : 2AC67-X100 Applicant ........................... : Xiamen VBeT Electronics Co., Ltd. Address ............................. : N403, Weiye Building, Xiamen Pioneering Park for Overseas Chinese Scholars, PRC Product Name ................... : VT Series Headsets Test Model. ........................ : X100 DUO Standards .......................... : FCC PART15 SUBPART B Date of Receipt sample .... : Jun.12, 2020 Date of Test........................ : Jun.12, 2020 to Jun.18, 2020 Date of Issue ..................... : Jun.18, 2020 Test Result ......................... : Pass Remarks: The results shown in this test report refer only to the sample(s) tested, this test report cannot be reproduced, except in full, without prior written permission of the company. The report would be invalid without specific stamp of test institute and the signatures of compiler and approver. Prepared By: Waltek Testing Group (Shenzhen) Co., Ltd. Address: 1/F., Room 101, Building 1, Hongwei Industrial Park, Liuxian 2nd Road, Block 70 Bao'an District, Shenzhen, Guangdong, China Tel.: +86-755-33663308 Fax.: +86-755-33663309 Tested by: Reviewed By: Approved & Authorized By: Jack Huang / Project Engineer Evan Cai /EMC Manager Silin Chen / Manager Reference No.: WTX20X06036502W Page 2 of 15 Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn TABLE OF CONTENTS 1. GENERAL INFORMATION ................................................................................................................................... 4 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ............................................................................... 4 1.2 TEST STANDARDS ................................................................................................................................................... 5 1.3 TEST METHODOLOGY ............................................................................................................................................. 5 1.4 TEST FACILITY ....................................................................................................................................................... 5 1.5 EUT SETUP AND OPERATION MODE ...................................................................................................................... 6 1.6 MEASUREMENT UNCERTAINTY .............................................................................................................................. 6 1.7 TEST EQUIPMENT LIST AND DETAILS ..................................................................................................................... 7 2. SUMMARY OF TEST RESULTS ........................................................................................................................... 8 3. CONDUCTED EMISSIONS .................................................................................................................................... 9 3.1 TEST PROCEDURE ................................................................................................................................................... 9 3.2 BASIC TEST SETUP BLOCK DIAGRAM ..................................................................................................................... 9 3.3 ENVIRONMENTAL CONDITIONS .............................................................................................................................. 9 3.4 SUMMARY OF TEST RESULTS ................................................................................................................................. 9 3.5 CONDUCTED EMISSIONS TEST DATA .................................................................................................................... 10 4. RADIATED EMISSION ......................................................................................................................................... 12 4.1 TEST PROCEDURE ................................................................................................................................................. 12 4.2 BLOCK DIAGRAM OF TEST SETUP ........................................................................................................................ 12 4.3 TEST RECEIVER SETUP ......................................................................................................................................... 12 4.4 CORRECTED AMPLITUDE & MARGIN CALCULATION ............................................................................................ 13 4.5 ENVIRONMENTAL CONDITIONS ............................................................................................................................ 13 4.6 SUMMARY OF TEST RESULTS ............................................................................................................................... 13 Reference No.: WTX20X06036502W Page 3 of 15 Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn Report version Version No. Date of issue Description Rev.00 Jun.18, 2020 Original / / / Reference No.: WTX20X06036502W Page 4 of 15 Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn 1. GENERAL INFORMATION 1.1 Product Description for Equipment Under Test (EUT) Client Information Applicant: Xiamen VBeT Electronics Co., Ltd. Address of applicant: N403, Weiye Building, Xiamen Pioneering Park for Overseas Chinese Scholars, PRC Manufacturer: Xiamen VBeT Electronics Co., Ltd. Address of manufacturer: N403, Weiye Building, Xiamen Pioneering Park for Overseas Chinese Scholars, PRC General Description of EUT Product Name: VT Series Headsets Trade Name: VT Model No.: X100 DUO Adding Model(s): X100, VT1000, VT1200, VT2000, VT3000, VT5000, VT5009, VT6000, VT6200, VT6300, VT6909, VT6907, VT1500, VT7000 Software Version: 1.0 Hardware Version…

Text truncated - open the document above for the full version.

Reference No.: WTX20X06036502W Waltek Testing Group (Shenzhen) Co., Ltd. http://www.semtest.com.cn EXHIBIT 4 - TEST SETUP PHOTOGRAPHS Conducted Emission Test Setup Radiation Emission Test Setup (30MHz to 1GHz)