2AIZN-X6817BMobile Phone

Infinix X6817B User Manual (F) 2 Know your phone 1. Front camera 2. Volume + key 3. Volume - key 4. Power key& side fingerprint sensor 2 SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation. 3 Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty. 4 FCC Caution Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Information to user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information: This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that 5 were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: X6817B (FCC ID: 2AIZN-X6817B) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.26 W/kg and when properly worn on the body is 0.88 W/kg. Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. 6 For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. © DTS, Inc. All Rights Reserved. Operating System：Android TM Android is a trademark of Google LLC.

INFINIXMOBILITYLIMITED Address:FLAT398/FBLOCKDWAHLOKINDUSTRIALCENTRE31-35SHANMEISTREETFOTANNT, HongKong Tel.:+86-0755-61803856 E-mail:[email protected] QA-FR-170-B FCCAuthorization Date:2022-3-10 FEDERALCOMMUNICATIONSCOMMISSIONS AuthorizationandEvaluationDivision 7435OaklandMillsRoad Columbia,MD21046 Subject:AgentAuthorization Towhomitmayconcern: We,INFINIXMOBILITYLIMITEDherebyauthorizesShenzhenAccurateTechnology Co.,Ltd.toactonitsbehalfinallmattersrelatingtoapplicationforEquipment authorization,includingthesigningofalldocumentsrelatingtothesematters.Allacts carriedoutbyShenzhenAccurateTechnologyCo.,Ltd.onourbehalfshallhavethe sameeffectasourownaction. We,theundersigned,herebycertifythatwearenotsubjecttoadenialoffederalbenefits, thatincludesFCCbenefits,pursuanttoSection5301oftheAnti-DrugAbuseActof1988, 21U.S.C.862. Thisauthorizationisvaliduntilfurtherwrittennoticefromtheapplicant. SincerelyYours, Signature YitingLuo ProjectManager

INFINIXMOBILITYLIMITED Address:FLAT398/FBLOCKDWAHLOKINDUSTRIALCENTRE31-35SHANMEISTREETFOTANNT, HongKong Tel.:+86-0755-61803856 E-mail:[email protected] FCCConfidentialAuthorization Date:2022-3-7 FEDERALCOMMUNICATIONSCOMMISSIONS AuthorizationandEvaluationDivision 7435OaklandMillsRoad Columbia,MD21046 Subject:ConfidentialityRequestregardingapplicationforcertificationof FCCID:2AIZN-X6817B InaccordancewithSections0.457and0.459oftheCommission’sRules, INFINIXMOBILITYLIMITEDherebyrequestslong-termconfidentialtreatmentof informationaccompanyingthisapplicationasoutlinedbelow: BlockDiagram Schematics OperationDescription Partlist/TuneupProcedure(forlicenseddevice) SoftwareSecurityDescription Aswellasshort-termconfidentialtreatmentofinformationaccompanyingthis applicationforaperiodof180daysaftergrantisissuedasoutlinedbelow: InternalPhotos User’sManual ExternalPhotos TestSet-upPhotos Theabovematerialscontainproprietaryandconfidentialinformationnotcustomarily releasedtothepublic.Thepublicdisclosureofthesematerialsprovidesunjustified benefitstoitscompetitorsinthemarket. SincerelyYours, Signature YitingLuo ProjectManager

Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF External Photos Page 1 of 5 External Photos Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF External Photos Page 2 of 5 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF External Photos Page 3 of 5 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF External Photos Page 4 of 5 Adapter Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF External Photos Page 5 of 5

Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF LABEL AND LOCATION Page 1 of 1 FCC ID Label FCC ID Label Location Information The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925)

Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 1 of 7 Internal photos Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 2 of 7 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 3 of 7 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 4 of 7 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 5 of 7 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 6 of 7 Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Internal Photos Page 7 of 7

★ Note: This report may contain data that are not covered by the A2LA accreditation and are marked with an asterisk “ ”. Shenzhen Accurate Technology Co., Ltd. is not responsible for the authenticity of any test data provided by the applicant. Data included from the applicant that may affect test results are marked with an asterisk ’*’. Customer model name, addresses, names, trademarks etc. are not considered data. This report cannot be reproduced except in full, without prior written approval of the Company. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested. This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software above version 7.0. Shenzhen Accurate Technology Co., Ltd. 1/F., Building A, Changyuan New Material Port, Science & Industry Park, Nanshan District, Shenzhen, Guangdong, P.R. China Tel: +86 755-26503290 Fax: +86 755-26503396 Web: www.atc-lab.com Version 11: 2021-11-09 Page 1 of 56 FCC-BT TEST REPORT Applicant Name : INFINIX MOBILITY LIMITED Address : FLAT 39 8/F BLOCK D WAH LOK INDUSTRIAL CENTRE 31-35 SHAN MEI STREET FOTAN NT, Hong Kong Report Number : SZNS220127-03898E-RF-00A FCC ID: 2AIZN-X6817B Test Standard (s) FCC PART 15.247 Sample Description Product Type: Mobile Phone Model No.: X6817B Multiple Model(s) No.: N/A Trade Mark: Infinix Date Received: 2022/01/27 Date of Test: 2022/02/10~2022/03/09 Report Date: 2022/03/17 Test Result: Pass* * In the configuration tested, the EUT complied with the standards above. Prepared and Checked By: Approved By: Ting Lü Robert Li EMC Engineer EMC Engineer Shenzhen Accurate Technology Co., Ltd. Report No.: SZNS220127-03898E-RF-00A Version 11: 2021-11-09 Page 2 of 56 FCC-BT TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 4 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 4 OBJECTIVE ................................................................................................................................................................... 4 TEST METHODOLOGY .................................................................................................................................................. 4 MEASUREMENT UNCERTAINTY .................................................................................................................................... 5 TEST FACILITY ............................................................................................................................................................. 5 SYSTEM TEST CONFIGURATION .......................................................................................................................... 6 DESCRIPTION OF TEST CONFIGURATION ...................................................................................................................... 6 EUT EXERCISE SOFTWARE .......................................................................................................................................... 6 SPECIAL ACCESSORIES ................................................................................................................................................. 6 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 6 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 6 EXTERNAL I/O CABLE .................................................................................................................................................. 6 BLOCK DIAGRAM OF TEST SETUP ................................................................................................................................ 7 SUMMARY OF TEST RESULTS ............................................................................................................................... 8 TEST EQUIPMENT LIST ........................................................................................................................................... 9 FCC§15.247 (I), §1.1307 (B) (1) & §2.1093 – RF EXPOSURE .................................................................................... 11 APPLICABLE STANDARD ............................................................................................................................................ 11 FCC §15.203 – ANTENNA REQUIREMENT .......................................................................................................... 12 APPLICABLE STANDARD ............................................................................................................................................ 12 ANTENNA CONNECTOR CONSTRUCTION .................................................................................................................... 12 FCC §15.207 (A) – AC LINE CONDUCTED EMISSIONS .................................................................................... 13 APPLICABLE STANDARD ............................................................................................................................................ 13 EUT SETUP ................................................................................................................................................................ 13 EMI TEST RECEIVER SETUP ....................................................................................................................................... 13 TEST PROCEDURE ...................................................................................................................................................... 13 TRANSD FACTOR & MARGIN CALCULATION..........................................…

Text truncated - open the document above for the full version.

Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Test Photos Page 1 of 2 Photo of Conducted Emission Measurement Shenzhen Accurate Technology Co., Ltd. Project No.: SZNS220127-03898E-RF Test Photos Page 2 of 2 Photo of Radiated Emission Measurement (Below 1G) Photo of Radiated Emission Measurement (Above 1G)