2ANXIKS36BB200PDQPortable Bluetooth Speaker

Important Safety Instructions •Read these Instructions. •Keep these Instructions. •Heed all Warnings. •Follow all instructions. •Do not use this apparatus near water. •Clean only with a dry cloth. •Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. •Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. •Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. •Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. •Only use attachments/accessories specified by the manufacturer. •Unplug this apparatus during lightning storms or when unused for long periods of time. •Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. •Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. FCC Warnings This device complies with Part 15 of th e FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and receiver. •Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Co nsult the dealer or an experienced radio/TV technician for help. Additional Warnings and Precautions •CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. •Mains plug is used as disconnect device and it should remain readily operable during intended use. In order to disconnect the apparatus from the mains completely, the mains plug should be disconnected form the mains socket outlet completely. •WARNING: Shock hazard - Do Not Open. •WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain, moisture, dripping, or splashing. •Objects filled with liquids, such as vases, shall not be placed on the apparatus. •CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure. •WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. •WARNING: Do not place this unit directly onto furniture surfaces with any type of soft, porous, or sensitive finish. As with any rubber compound made with oils, the feet could cause marks or staining where the feet reside. We recommend using a protective barrier such as a cloth or a piece of glass between the unit and the surface to reduce the risk of damage and/or staining. •CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. •WARNING: There is a danger of explosion if you attempt to charge standard Alkaline batteries in the unit. Only use rechargeable NiMH batteries. •Warning: Do not ingest battery, chemical burn hazard. •Battery shall not be exposed to excessive heat such as sunshine, fire or the like. •Caution marking is located at the rear or bottom of the apparatus. •The marking information is located at the rear or bottom of apparatus. •Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. •If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. •Do not mix old and new batteries. •Completely replace all old batteries with new ones. •Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni- cad, ni-mh, etc) batteries. •Batteries should be recycled or disposed of as per state and local guidelines.` Features •Bluetooth 5.0 •Voice prompts •FM scan radio •Rotary volume control •Aux in •Color changing LEDs •USB port - supports MP3 file format •SD port - supports MP3 file format •Built-in rechargeable battery •Battery life: approx. 6 hrs playtime at 50% volume Features & Controls CD/Radio/Cassette/Boombox User’s Guide SOURCE/LIGHTS M A S T E R V O L U M E Volume Wheel Display This product utilizes a Class 1 laser to read Compact Discs. This laser Compact Disc Player is equipped with safety switches to avoid exposure when the CD door is open and the s…

Text truncated - open the document above for the full version.

2020.07.16 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: 2ANXIKS36BB200PDQ Product Name: Portable Bluetooth Speaker Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential: Schematics Long-term confidential Block diagram Long-term confidential Operation description Long-term confidential These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Signature: 2020.07.16 Signatory Name Fu Jia Mao Position QE Engineer Company Name Comson (Shenzhen) Electronic Technology Co., Ltd. Address 3rd floor, Building 22, Xingwei Third Industrial District, Xingye Yi Road No.6, Fenghuang Community, Fuyong, Shenzhen City, Guangdong Province, China Tel +86 13527989686 Fax +860755-85250310 Email [email protected] Comson (Shenzhen) Electronic Technology Co., Ltd.

FCC ID: 2ANXIKS36BB200PDQ External Photos FCC ID: 2ANXIKS36BB200PDQ FCC ID: 2ANXIKS36BB200PDQ FCC ID: 2ANXIKS36BB200PDQ

2cm*5cm Location

FCC ID: 2ANXIKS36BB200PDQ Internal Photos FCC ID: 2ANXIKS36BB200PDQ FCC ID: 2ANXIKS36BB200PDQ Antenna FCC ID: 2ANXIKS36BB200PDQ FCC ID: 2ANXIKS36BB200PDQ

RF Exposure evaluation According to 447498 D01 General RF Exposure Guidance v06 The 1-g and 10- g SAR test exclusion thresholds for 100 MHz t o 6 GHz at test separation distances ≤ 50 mm are determined by : [(max. power of channel, including tune-up tolerance, mW)/(min. test separation distance, mm)] ·[√f(GHz)] ≤ 3.0 for 1-g SAR and ≤ 7.5 for 10-g extremity SAR, where f(GHz) is the RF channel transmit frequency in GHz Power and distance are rounded to the nearest mW and mm before calculation The result is rounded to one decimal place for comparison Worse case is as below: [2402MHz: -1.746dBm (0.669mW) output power] (0.669mW /5mm)·[√2.402(GHz)]= 0.21<3.0 for 1-g SAR Then SAR evaluation i s not required FCC ID: 2ANXIKS36BB200PDQ

FCC TEST REPORT FCC ID: 2ANXIKS36BB200PDQ On Behalf of Comson (Shenzhen) Electronic Technology Co., Ltd. Portable Bluetooth Speaker Model No.: KS-36, BB200PDQ, KS-32, KS-33, KS-34, KS-35, KS-37, KS-38, KS-39 Prepared for : Comson (Shenzhen) Electronic Technology Co., Ltd. Address : 3rd floor, Building 22, Xingwei Third Industrial District, Xingye Yi Road No.6, Fenghuang Community, Fuyong, Shenzhen City, Guangdong Province, China Prepared By : Shenzhen Alpha Product Testing Co., Ltd. Address : Building i, No.2, Lixin Road, Fuyong Street, Bao’an District, 518103, Shenzhen, Guangdong, China Report Number : A2006157-C01-R01 Date of Receipt : July 1, 2020 Date of Test : July 2-13, 2020 Date of Report : July 13, 2020 Version Number : V0 Page 2 of 62 Report No.: A2006157-C01-R01 TABLE OF CONTENTS Description Page 1. Summary of Standards And Results .................................................................................................... 6 1.1. Description of Standards and Results .......................................................................... 6 2. General Information .............................................................................................................................. 7 2.1. Description of Device (EUT) ....................................................................................... 7 2.2. Accessories of Device (EUT) ...................................................................................... 8 2.3. Tested Supporting System Details ............................................................................... 8 2.4. Block Diagram of connection between EUT and simulators ...................................... 8 2.5. Test Mode Description ................................................................................................. 8 2.6. Test Conditions ............................................................................................................ 9 2.7. Test Facility ................................................................................................................. 9 2.8. Measurement Uncertainty ............................................................................................ 9 2.9. Test Equipment List ................................................................................................... 10 3. Maximum Peak Output power ........................................................................................................... 11 3.1. Limit .......................................................................................................................... 11 3.2. Test Procedure ........................................................................................................... 11 3.3. Test Setup ................................................................................................................... 11 3.4. Test Result ................................................................................................................. 11 4. Bandwidth ............................................................................................................................................. 12 4.1. Limit .......................................................................................................................... 12 4.2. Test Procedure ........................................................................................................... 12 4.3. Test Result ................................................................................................................. 12 5. Carrier Frequency Separation ............................................................................................................ 22 5.1. Limit .......................................................................................................................... 22 5.2. Test Procedure ........................................................................................................... 22 5.3. Test Result ................................................................................................................. 22 6. Number Of Hopping Channel ............................................................................................................. 24 6.1. Limit .......................................................................................................................... 24 6.2. Test Procedure ........................................................................................................... 24 6.3. Test Result ................................................................................................................. 24 7. Dwell Time ............................................................................................................................................ 26 7.1. Test limit .................................................................................................................... 26 7.2. Test Procedure ........................................................................................................... 26 7.3. Test Result ................................................................................................................. 26 8. Radiated emissions ............................................................................................................................... 30 8.1. Limit .......................................................................................................................... 30 8.2. Block Diagram of Test setup ..................................................................................... 31 8.3. Test Procedure ........................................................................................................... 32 8.4. Test Result ................................................................................................................. 32 9. Band Edge Compliance .........................................................................…

Text truncated - open the document above for the full version.

FCC ID: 2ANXIKS36BB200PDQ Photos of Radiated emission FCC ID: 2ANXIKS36BB200PDQ Photos of Conducted Emission test