2AOKM-MB2smart key

User’s manual This remote has lock,unlock,trunk,and panic buttons,you can open or close the vehicle with the remote transmitter. LOCK When you press the LOCK button, the vehicle doors will lock. If the door is not close, can not lock the door, also key in the ignition switch also can not lock the doors. UNLOCK When you press the UNLOCK button, you can open the all doors.if the key is in the ignition switch, can not unlock the doors. Trunk When press the TRUNK buttons,open the trunk.It can not close the trunk using this transmitter. PANIC When press the PANIC button, the vehicle will start sounding the horn and flushing the hazdard lamp until press any buttons on transmitter. FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. IC WARNING: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device ADVERTENCIA IC Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS)d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis auxdeux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles deprovoquer un fonctionnement indésirable de l'appareil.

Remote Tech LLC DATE :2021-4-9 Equipment Autorisation Division Federal Communications Commission 74 35 Oakland Mills Road Columbia, MD 21046 FCC ID: 2AOKM-MB2 Pr oduct Name: Smart key Req uest for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential: •Schematics •Block diagram •Operation description •BOM These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this 2021-4-9 By: John Strong Signature Printed Title: On behalf of : Remote Tech LLC Telephone: 302-336-8136 manager

Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 24 of 30 8 EUT Constructional Photos Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 25 of 30 Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 26 of 30

Label : FCC ID :2AOKM-MB2 IC : 24223-MB2 MODEL: RT-MB2 P/N: RT-NCZ Location:

Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 27 of 30 Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 28 of 30 Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 29 of 30 Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 30 of 30 ------End of report------

JianYan Testing Group Shenzhen Co., Ltd. Report No: JYTSZB-R12-2100515 Authorized Signature: Bruce Zhang Laboratory Manager This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the JYT product certification mark. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 90 days only. 1 5Cover Page FCC REPORT Applicant: Remote Tech LLC Address of Applicant: 310 ALDER RD, DOVER DE 19904 USA Equipment Under Test (EUT) Product Name: Smart key Model No.: RT-MB2 FCC ID: 2AOKM-MB2 Applicable standards: FCC CFR Title 47 Part 15 Subpart C Section 15.231 Date of sample receipt: 01 Apr., 2021 Date of Test: 02 Apr., to 30 Apr., 2021 Date of report issue: 17 May, 2021 Test Result: PASS* * In the configuration tested, the EUT complied with the standards specified above. Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 2 of 28 2 Version Version No. Date Description 00 06 May, 2021 Original 01 14 May, 2021 1. Updated Field Strength power on page 5. 2. Updated test requirement on page 8. 3. Updated Field Strength on page 10. 4. Updated spurious emissions on page 12. 5. Updated page 15/16. 02 17 May, 2021 1. Updated test data on page 12. 2. Updated test mode information on page 19. Prepared By: Date: 17 May, 2021 Test Engineer Check By: Date: 17 May, 2021 Project Engineer Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 3 of 28 3 Contents Page 1 COVER PAGE ....................................................................................................................................................... 1 2 VERSION ............................................................................................................................................................... 2 3 CONTENTS ........................................................................................................................................................... 3 4 TEST SUMMARY .................................................................................................................................................. 4 5 GENERAL INFORMATION .................................................................................................................................. 5 5.1 CLIENT INFORMATION ............................................................................................................................................ 5 5.2 GENERAL DESCRIPTION OF E.U.T. ....................................................................................................................... 5 5.3 TEST MODE ............................................................................................................................................................ 5 5.4 DESCRIPTION OF SUPPORT UNITS ........................................................................................................................ 5 5.5 MEASUREMENT UNCERTAINTY .............................................................................................................................. 5 5.6 ADDITIONS TO, DEVIATIONS, OR EXCLUSIONS FROM THE METHOD....................................................................... 5 5.7 LABORATORY FACILITY .......................................................................................................................................... 6 5.8 LABORATORY LOCATION ....................................................................................................................................... 6 5.9 TEST INSTRUMENTS LIST ....................................................................................................................................... 6 6 TEST RESULTS AND MEASUREMENT DATA ................................................................................................ 7 6.1 ANTENNA REQUIREMENT ....................................................................................................................................... 7 6.2 RADIATED EMISSION ............................................................................................................................................. 8 6.2.1 Field Strength Of The Fundamental Signal .............................................................................................. 10 6.2.2 Spurious Emissions ..................................................................................................................................... 12 6.3 BANDWIDTH ......................................................................................................................................................... 17 6.4 DURATION TIME ............................…

Text truncated - open the document above for the full version.

Report No: JYTSZB-R12-2100515 JianYan Testing Group Shenzhen Co., Ltd. Project No.: JYTSZE2104006 No.101, Building 8, Innovation Wisdom Port, No.155 Hongtian Road, Huangpu Community, Xinqiao Street, Bao'an District, Shenzhen, Guangdong, People's Republic of China. Tel: +86-755-23118282, Fax: +86-755-23116366 Page 23 of 30 7 Test Setup Photos Radiated Emission Below 1GHz Above 1GHz