2AOTUKDDY036Control Box

User Manual 1.System connection diagram 2.Product list NO. Mane model Quantity 1 Handset KDH139 1 2 power KDDY01B 1 3 Control box KDDY036 1 4 Actuator1 KDYJT014- 025 1 5 Actuator2 KDYJT014- 026 1 1 / 3 FCC ID: 2AOTUKDDY036 FCC ID: 2AOTUKDH139 3.Performance parameter 1. Power performance parameters： INPUT AC100～240V 50/ 60Hz OUTPUT 29V DC / 2A Max output 29VDC/4A 2. Control box performance parameters INPUT 29V DC Actuator output 29VDC/4A Overcurrent protection 5A( single) 3.Actuator performance parameters： N/M Actuator1 Actuator2 v/c 29VDC/ 4A No- load speed 4- 6mm 4- 6mm Installation size 330mm 300 mm stroke 100 mm 60 mm Max Thrust 6000N 6000N 4.Instructions for use 1.Before use, please make sure to wire correctly according to the system connection diagram, and then connect the main power; 2、Before using for the first time, you should pair the wireless hand controller with the control box. The specific operation method is as follows: a、Press the pairing button on the control box and hold it for more than 3s, release the button when the pairing indicator flashes quickly; b、While the indicator light is flashing, press any key on the wireless controller. At this time, the control box indicator light stops flashing and pairing is successful. c、After pairing is successful, operate the corresponding keys on the hand controller to start 2 / 3 the corresponding functions. 5.Matters needing attention 1、Children, the elderly and people with disabilities, please use under supervision; 2、Do not plug or unplug any cables while the power is on, it may cause malfunction of the operation function. If this happens, you can cut off the main power, and then reconnect it after about 30s to recover; 3、W hen the remote control presses multiple keys at the same time, the system will recognize them as invalid keys and will not respond, except for special combination keys; 4、It is not recommended to operate multiple faders at the same time, except for special functions; 5、Please replace the battery of the controller in time. When not in use for a long time, remove the battery. 3 / 3 FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undeundesired operation. Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.

QA-FR-170-B Co mpany: Changzhou Kaidi Electrical Inc. Add: Jiangcun, Henglin Town, changzhou, China Tel: (8 6)519-67898510 Fax: (86)519-67898509 FCC Authorization Date: 2019-12-31 FE DERAL COMM UNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern: We, Changzhou Kaidi Electrical Inc., the undersigned, Hereby authorizes Bay Area Compliance Laboratories Corporation to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by Bay Area Compliance Laboratories Corp. on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature: Typed or Printed Name: Qin Yin Title: Engineer

Compan y: Changzhou Kaidi Electrical Inc. Add: Jiangcun, Henglin Town, changzhou, China Tel: (86)519-67898510 Fax: (86)519-678985 09 E-mail: [email protected] FCC Confidential Authorization Date: 2019-12-31 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2AOTUKDDY036 To: whom it may concern, In accordance with Sections 0.457 and 0.459 of the Commission’s Rules, Changzhou Kaidi Electrical Inc. hereby requests long-term confidential treatment of information accompanying this application as outlined below: Block Diagram Schematics Operation Description The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely Yours, Signature: Typed or Printed Name: Qin Yin Title: Engineer

EXHIBIT A - EUT EXTERNAL PHOTOGRAPHS

Product Name:Control Box Model Name:KDDY036 FCC ID:2AOTUKDDY036

EXHIBIT B - EUT INTERNAL PHOTOGRAPHS

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report is valid only with a valid digital signature. The digital signature may be available only under the Adobe software above version 7.0. FCC PART 15B MEASUREMENT AND TEST REPORT For Changzhou Kaidi Electrical Inc. Jiangcun, Henglin Town, Changzhou, China FCC ID: 2AOTUKDDY036 Report Type: Original Report Product Type: Control Box Test Engineer: Tina Li Report Number: RSHA191231003-00A Report Date: 2020-02-17 Reviewed By: Oscar Ye EMC Manager Prepared By: Bay Area Compliance Laboratories Corp. (Kunshan) No.248 Chenghu Road, Kunshan,Jiangsu province, China Tel: +86-0512-86175000 Fax: +86-0512-88934268 www.baclcorp.com.cn Bay Area Compliance Laboratories Corp. (Kunshan) Report No.: RSHA191231003-00A FCC Part 15B Page 2 of 15 TABLE OF CONTENTS GENERAL INFORMATION ....................................................................................................................................... 3 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ..................................................................................... 3 OBJECTIVE ................................................................................................................................................................... 3 RELATED SUBMITTAL(S)/GRANT(S) ............................................................................................................................. 3 TEST METHODOLOGY .................................................................................................................................................. 3 TEST FACILITY ............................................................................................................................................................. 3 SYSTEM TEST CONFIGURATION .......................................................................................................................... 4 JUSTIFICATION ............................................................................................................................................................. 4 EUT EXERCISE SOFTWARE .......................................................................................................................................... 4 SPECIAL ACCESSORIES ................................................................................................................................................. 4 EQUIPMENT MODIFICATIONS ....................................................................................................................................... 4 SUPPORT EQUIPMENT LIST AND DETAILS .................................................................................................................... 4 EXTERNAL I/O CABLE .................................................................................................................................................. 4 BLOCK DIAGRAM OF RADIATED TEST SETUP ............................................................................................................... 5 SUMMARY OF TEST RESULTS ............................................................................................................................... 6 FCC §15.107 –CONDUCTED EMISSIONS ............................................................................................................... 7 APPLICABLE STANDARD .............................................................................................................................................. 7 MEASUREMENT UNCERTAINTY .................................................................................................................................... 7 EUT SETUP .................................................................................................................................................................. 7 EMI TEST RECEIVER SETUP ......................................................................................................................................... 8 TEST PROCEDURE ........................................................................................................................................................ 8 TEST EQUIPMENT LIST AND DETAILS ........................................................................................................................... 8 FACTOR & OVER LIMIT CALCULATION ........................................................................................................................ 8 TEST DATA .................................................................................................................................................................. 9 FCC §15.109 - RADIATED EMISSIONS ................................................................................................................. 11 APPLICABLE STANDARD ............................................................................................................................................ 11 MEASUREMENT UNCERTAINTY .................................................................................................................................. 11 EUT SETUP ................................................................................................................................................................ 11 EMI TEST RECEIVER SETUP ....................................................................................................................................... 12 TEST PROCEDURE ...................................................................................................................................................... 12 TEST EQUIPMENT LIST AND DETAILS ......................................................................................................................... 13 CORRECT…

Text truncated - open the document above for the full version.

EXHIBIT C - TEST SETUP PHOTOGRAPHS Conducted Emissions - Front Side Conducted Emissions - Rear Side Radiated Emissions Front Side (Below 1 GHz) Radiated Emissions Rear Side (Below 1 GHz) Radiated Emissions Rear Side (Above 1 GHz)